查询词典 valve body

Check valve 1, the ball 3, valve body 26 then and, if damage to be repaired.

9检查阀体1、球3、阀体接体26，如有损伤予以修复。

This structure effectively compensate for tolerance between the sleeve and the valve body and valve stem in the medium with the elastic deformation under pressure to solve the two-way valve in the transmission medium interchangeable sealing problems existing in the process.

这种结构有效地补偿了轴套与阀体之间的公差带及阀杆在介质压力下的弹性变形，解决了阀门在双向互换的介质输送过程中存在的密封问题。

Jacketed valve:This valve is design incorporates a so-called jacket around the valve body.

夹套阀：这种阀的设计，是将一个所谓的夹套套在阀体上。

As the valve body and valve cover gasket, you can not remove the valve flap or damper circumstances, forced open a gap, into the raw material brought on the list.

作为阀门中阀体与阀盖间的垫圈，可在不取出阀瓣或闸板的情况下，撬开一缝隙，塞进生料带去就行了。

Because the crank is connected with the shaft through the flat key and the shaft is fixed onto the valve plate with the pin, thus the valve plate is driven to turn in the valve body so as to change the flow area of the pipeline change to regulate the flowrate of the medium.

由于曲柄通过平键与轴连结，。轴与阀板用销子固定，从而带动阀板在阀体内回转，使管道流通面积变化，达到调节介质流量。

Do not let any pipe into the valve body adhesive in order to avoid damage to valve and valve seat.

不要让任何管道粘接剂流入阀体内，以避免损坏阀瓣和阀座。

It make use of three-dimensional CAD parameterization designing technique to design and draw valve body mainly, and offer the database administration module of project, for finishing valve body casting technological design.

主要利用三维CAD参数化设计技术来设计绘制阀体，并提供工程数据库管理模块，以便完成阀体铸造工艺设计。

Once it is installed on the body, he was the valve cap or valve body by the sealing gasket.

一旦它被安装在阀体上，他被阀帽或阀体的垫片所密封。

If tightening the valve body lateral cap, exhaust valve to stop the exhaust, in general, valve cap should be at the open.

如拧紧阀体侧部的阀帽，排气阀停止排气，在通常，阀帽应该处于开启状态。

Plunger valve is from the valve body, valve cover, stem, plunger, hole frame, sealing rings, hand wheels, of parts.

柱塞阀是由阀体、阀盖、阀杆、柱塞、孔架、密封环、手轮等零件组成。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。