查询词典 valve body

No.3: When the valve fully open, the angle between sphere body hole-through axes and valve body hole-throught axes Max.

阀门全开时，球体通孔轴线与阀体通孔轴线的夹角不大于3

Piston-type check valve: valve valve slide along the centerline of the valve body.

活塞式止回阀：阀瓣沿着阀体中心线滑动的阀门。

Metal Body lining valve: body shape metal, interior where the main point of contact with the media are lining the surface, such as rubber lined valves, plastic valves lining, lining ceramic valve.

3金属阀体衬里阀门：阀体外形为金属，内部凡与介质接触的主要表面均为衬里，如衬胶阀、衬塑料阀、衬陶阀等。

Friction discs, brake clamp body, bracket, steering Stand Etc motorcar Fitting. Valve, valve body castings, hydraulic pressure jack castings, well cover and base component etc.

主要产品有：制动盘、制动钳体、支架、转向节等汽车配件，阀门、阀体铸件，液压千斤顶铸件和窨井盖等基础件。

Its has four types, continnueains over 200 kinds, and above 60% castings are exported, friction discs, brake clamp body, bracket, steering stand etc motorcar fitting, valve, valve body castings, hydraulic pressure jack castings, well cover and base component etc.

主要产品有：CA498汽缸体铸件、制动盘、制动钳体、支架、转向节等汽车铸件，阀门阀体铸件，液压千斤顶铸件和窨井盖等通用铸件。

Check the valve lift valve is located in the valve body on the valve seat sealing surface.

升降式止回阀的阀瓣座落位于阀体上阀座密封面上。

Mainly by the valve body, valve cover, piston, spring, main valve, valve and membrane composed of the Deputy.

主要由阀体、阀盖、活塞、弹簧、主阀、副阀及膜片等组成。

The seal test Test the stem and the valve cover seal sealing performance of the test, Deputy Shell Test Such as the valve body and valve cover is made of the valve housing connected to the pressure test.

上密封试验检验阀杆与阀盖密封副密封性能的试验壳体试验对阀体和阀盖等联结而成的整个阀门外壳进行的压力试验。

The conveyed medium can't be leaked outside. Thus it will not cause the environmental pollution and human body safety dangerous while exhausting the toxin and flammable or corrosive medium. 5、No electricity. It's safe and reliable while using in the flammable and explore places. 6、It can be soaked in medium. 7、It's convenient to use and reliable to work. Only open or close the gas valve body while starting or stopping. Even if no medium operation or pausing suddenly for long time because of accident matters, the pump will not be damaged caused by this. Once over-loading, the pump will automatically stop and possesses the self-protection function. When the load recovers normally, it also can start automation. 8、Simple structure and less wearing parts. This pump is simple in structure, installation and maintenance. The medium conveyed by the pump will not touch the matched pneumatic valve and coupling lever etc. not like other kinds pumps, the performance will drop down gradually because of the damages of rotor, gear and vane etc. 9、It can transmit the adhesive liquid (the viscosity is below 10000centipoise) 10、 This pump needn't the oil lubricant. Even if idling, it has any influence to the pump. This is a characteristic of this pump.

所以抽送有毒、易挥发或腐蚀性介质时，不会造成环境污染和危害人身安全； 5、不必用电，在易燃、易爆场所使用安全可靠 6、可以浸没在介质中工作 7、使用方便、工作可靠、开停只需简单地打开和关闭气体阀门，即使由于意外情况而长时间无介质运行或突然停机，泵也不会因此而损坏，一旦超负荷，泵会自动地停机，具有自我保护性能，当负荷恢复正常后，又能自动启动运行； 8、结构简单、易损件少，该泵结构简单，安装、维修方便，泵输送的介质不会接触到配气阀，联杆等运动部件，不像其他类型的泵因转子、活塞、齿轮、叶片等部件的磨损而使性能逐步下降； 9、可输送较粘的液体（粘度在1万博以下）； 10、本泵无须用油润滑，即使空转，对泵也无任何影响，这是该泵一大特点

There are two worn gear drive device of open-close and turn over on the worm gear blind cut-off valve gate. The gear rim, gear wheel and screw pole screw pairs of open-close worm gear box drive the right and left valve body to clamp and release. The turn-over worm gear box drives the valve disc to open. There is limit block on the valve disc to ensure the open-close position of the valve disc.

蜗轮传动盲板切断阀，阀门中设有启闭和翻转两个蜗轮传动装置，启闭蜗轮箱通过齿圈、齿轮和丝杆螺旋副驱动左、右阀体完成松开、夹紧动作，翻转蜗轮箱驱动阀板完成开启动作，阀板上设有限位挡块以保证阀板的启闭位置。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。