查询词典 valve body

Next Body: contains valve internal parts, there is a flow channel connecting the mouth of the half part of the body shell.

下阀体：包含阀门内部零件，有一个流道连接口的阀体壳体的一半部分。

On the Body: contains valve internal parts, there is a flow channel connecting the mouth of the half part of the body shell.

上阀体：包含阀门内部零件、有一个流道连接口的阀体壳体的一半部分。

Plug Valve should be in accordance with the six degrees of freedom of the API specifications Valve should be nonlubricated, flexible, two-seater, and gradually abolished, plug-and-play able to handle two-way blocking; steel body, chrome-plated trim and gradually plug steel or ductile iron, chrome or nickel plating to support the upper reaches of the lower trunnions , iron and steel, ductile iron sealed with rubber seal alone.

插头 阀应按照六自由度的API规格阀应nonlubricated ，有弹性，双座位，逐渐取消，即插即用型能够处理双向堵；钢体，镀铬的内饰，并逐渐插件的钢或球墨铸铁，镀铬或镀镍，支持上游低trunnions ，钢铁球墨铸铁密封单与橡胶密封件。

Its working principle is: the valve has a spring inside the rubber membrane with the composition of the body, connected with the valve stem.

它的工作原理是：在阀门内有一个由弹簧与橡胶膜组成的机构，它与阀杆连接。

Also, the hydraulic actuator and the hydraulic control valve are formed integrally with each other in the valve housing body.

还有，在阀外壳主体内一体设置所述油压促动器和油压控制阀。

The trap body and cover shall be manufactured out of cast iron, the diaphragm cover shall be forged brass, the diaphragm shall be duplex phosphor bronze type with stainless valve cone, the condensate valve and seats shall be hardened stainless steel and the float shall be manufactured out of seamless copper.

这种疏水阀的阀体和阀盖应该采用铸铁制造，隔膜盖应该采用锻造黄铜，这种隔膜应该是双磷青铜类型并配置不锈钢阀芯，凝结水阀和阀座应该采用硬化不锈钢，浮子应该采用无缝铜制造。

QB Series Knife Gate Valve absorb the advantages of technology and structure both at home and aboard to exclude other knife gate valves' shortcomings when using . This knife gate valve is made up withe body 、disc、stem、stem nut、sealing ring and operation parts.

QB型系列刀闸阀吸取了国内外先进技术和结构优点，排除了其他厂家所产刀闸阀在使用中存在的问题，此阀门主要由阀体、闸板、阀杆、阀杆螺母、密封圈、操作件组成。

The valve is mainly made up of body, disc, axle, rocker, connecting rod, cam and spring etc, realizing discharging and air locking making use of the continual action of cam, connecting rod and spring. The cam is controlled by electric pneumatic, so the open angle and time of valve can be controlled in some range by reducing gear.

电动锁气翻板卸灰阀主要由阀体、阀板、阀轴、摇杆、连杆、凸轮、弹簧等零件组成，利用凸轮、连杆、弹簧连续动作实现锁气卸灰，凸轮系统由电气控制，因而阀板的开启角度和时间可由减速装置控制在一定范围内。

During the installation, please do not use the valve as the crane part of the executive body of the lifting Flange-connection stiff metallic sealing ball valve points to avoid damage to the executing agency and accessories..

在安装期间，请不要用阀的执行机构部分作为起重的吊装点，以避免损坏执行机构及附件。。

So that the channel immediately exit valve seat to prevent the rapid expansion of body wall and the wall suffered cavitation damage, and for Water in the needle valve, the expansion chamber diameter of 1.5 times the diameter of including pull back the export channel, including length of 8 times the diameter when subjected to cavitation can be avoided.

使紧接阀座出口端的通道急剧扩大可防止阀体壁和管壁遭受气蚀损坏，对用于水厂中的针形阀，其扩大腔室的直径为管径的1.5倍，包括出口退拔在内的通道长度为管径的8倍时，可避免遭受气蚀。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。