查询词典 unique solution

In the first part, first of all, we have a priori estimate for solution of the reaction-diffusion equation with initial condition and Dirichret boundary conditions. Then, we construct a semidiscrete Legendre pseudospectral scheme, and have a priori estimate for approximate solution. We discuss the asymptotic stability of approximate solution. At last, we get a error estimation on large time for solution of the semidiscrete system.

首先，对此类方程初边值问题的解进行了先验估计；然后建立方程半离散的Legendre拟谱格式，并对近似解进行了先验估计，讨论了近似解的渐近稳定性；最后，得到了半离散系统解的长时间误差估计。

Using New Zealand rabbit ears cartilage makes chondrocyte suspension, Fibrinogen was mixed with D-hank's makes a final fibrinogen concentration of 50mg/ml mixture solution, then chondrocytes resuspend with fibrinogen solution, chondrocytes-seeded fibrinogen was mixed with thrombin (25U/ml in 40mM calcium choride) to make chondrocytes/fibrin glue polymer. Pluronic F-127 was mixed with D-hank's makes a final Pluronic F-127 concentration of 400mg/ml mixture solution, then chondrocytes resuspend with Pluronic F-127 solution to make chondrocytes/Pluronic F-127 polymer. The chondrocyte concentrations was 10 million chondrocyte/ml of polymer.

为确定纤维蛋白凝胶与Pluronic F-127在注射方式形成组织工程化软骨过程中的优劣，我们进行了如下实验：应用新西兰大白兔耳软骨获取软骨细胞并体外培养，纤维蛋白原应用D-hank's液配制为50mg/ml，然后以纤维蛋白原溶液重悬软骨细胞，再与40mM的氯化钙配制的25U/ml凝血酶混合形成软骨细胞—纤维蛋白凝胶复合物；Pluronic F-127应用D-hank's液配制为400mg/ml，同样用PluronicF-127溶液重悬软骨细胞而形成软骨细胞—Pluronic F-127凝胶复合物。

When pump starts, the lower impeller lifts the solution up step by step. And the extreme centrifugal force from the enlarged higher impeller stops the solution as it entering the higher impellr. At the same time, the full solution in the chamber stops the air mixed with the solution in the chamber to go down. This way masterly eliminates both big problems of vertical sealless pump, overflow at high pressure and bubbles at big flow.

塑宝SV泵剖面结构SV Super Series Analytical cross section SV泵剖面结构泵开始运转时，底部叶轮将液体逐步上推，待液体进入上部叶轮时，即受加大之背叶的强大阻力而无法上升，但上部叶轮所卷入液体中的空气，却受阻於水室中贮满的液体而无法下降，如此巧妙地排除了立式无轴封泵高压时溢流，或大流量时吸入空气的两大难题。

In order to enhance the miscibility between the inorganic and the organic phases,the silanol coupling agent is made from the slane VTMS and the colloid silica. Then the silanol coupling agent and nano-particles of ZnSb2O6 as the conductive filler are successfully bonded and the nano-particles of ZnSb2O6 will become more organic-like. The colloid silane-SiO2-ZnSb2O6 precursor solution is subsequently mixed with a homogeneous lsopropylalcohol solution of SR-399 acrylic monomers (Dipentaerythritol pentaacrylate) and the active free radical agent709. Under nitrogen purging, this reaction solution prepolymerize at 60℃. Then, the solution is spin-coated with the spin coator at room temperature. At last, the coated thin film is cured and crosslinked by the UV curing reactor to form the highly transparent thin film with good optoelectronic properties from hybrid organic-inorganic nano-composite.

首先以矽氧烷VTMS和colloid silica制备矽氧偶合剂，再以此偶合剂对分散於异丙醇溶液之奈米级的colloid ZnSb2O6做有机化改质，以增进其与有机高分子基材的键结相容性，我们将此colloid silane-SiO2 - ZnSb2O6前驱物与SR-399有机基材单体(Dipentaerythritol pentaacrylate)的异丙醇溶液与活性自由基光起始剂709均匀掺混后，在充满氮气反应系统下，加热至60℃进行预聚合反应，接著在室温下以旋转涂布机旋转涂布成厚度均匀薄膜，最后将此薄膜直接高温硬化或以UV硬化机网状键结硬化成透明与具部份导电性等光电特性之无机/有机奈米混成薄膜。

Also, the type of dispersion of four gasliquid-liquid systems: air-decane-aqueous solution of sodium sulfite and surfactant, airmixture of decane and dodecene-aqueous solution of rhodium complex, ligand, and surfactant, air-mixture of decane, dodecene and tridecyl aldehyde-aqueous solution of rhodium complex, ligand and surfactant, and air-mixture of decane and dodeceneaqueous solution of trisodium salt of tri (m-sulfophenyl) phosphine, and surfactant is determined by electric conductivity.

本文采用电导率测量的方法实验研究了空气—正癸烷—亚硫酸钠和十六烷基三甲基溴化铵水溶液、空气—正癸烷和1-十二碳烯混合物—铑膦络合物催化剂和十六烷基三甲基溴化铵水溶液、空气—正癸烷、1-十二碳烯和十三醛混合物—铑膦络合物催化剂和十六烷基三甲基溴化铵水溶液、空气—正癸烷和1-十二碳烯混合物—三间磺化苯基膦三钠盐和十六烷基三甲基溴化铵水溶液四个三相体系的液液分散特性。当有机相与水相体积比分别为7／3、1／1和3／7时，前三个体系均形成水包油型分散，并有稳定的乳状液生成。

The results show that the perfect Honeycomb pattern films without defects within area of 0.8cm^2 can be obtained at the PS concentration ranges from 20 mg/mL to 50 mg/mL and PS/TEOS mass ratio less than 2. The films cast from the chloroform solution of dicarboxyl terminated PS were more perfect than those cast from the chloroform solution of monocarboxyl terminated PS. The perfect Honeycomb structure films could be obtained with both chloroform and benzene as solvents, but the pore diameter of films cast from benzene solution of PS was larger than that of films cast from chloroform solution of PS.

研究结果表明，聚合物浓度在20~50mg/mL，PS/TEOS质量比大于2：1的条件下可以制备结构完整的多孔膜，且制备的Honeycomb结构在0.8平方公分内无缺陷；采用双羧基封端的聚苯乙烯成膜效果好于单羧基封端的成膜效果；以氯仿和苯作为溶剂均可以制备完全Honeycomb结构的复合膜，但以苯为溶剂制备的多孔膜孔径较大。

The effects of the buffer solution have been studied by many researchers and many experiments were also performed in this work. The results showed that NH〓Cl solution is the most suitable for the porous glass preparation and the mixed acid solution which used many times will lead to the high cracking of the glass and the new acid solution would be used every time.

很多学者研究了不同缓冲溶液对酸浸的影响，本文对此进行了大量实验表明，以NH〓Cl作为缓冲溶液浸析效果最好，表现为玻璃浸速率较快且易于获得完整的多孔玻璃，而重复使用含玻璃本身组分的酸液会造成玻璃开裂情况更加严重，因此建议使用新配酸液。

The influence of the inlet solution concentration, solution flow rate, inlet air flow rate and temperature, air humidity on the absorbed process were studied for different liquid desiccants (calcium chloride, lithium chloride and calcium chloride mixture), and the dehumidifying effects of various mixture ratios on lithium chloride and calcium chloride mixture were also analyzed. The results show that the CELD (Cost-Effective Liquid Desiccant, the mixture ratio is 1:1) is more economical than pure lithium chloride solution, while its dehumidifying performance is better than calcium chloride solution.

针对不同的实验工质：氯化钙溶液、不同混合比的氯化钙和氯化锂混合溶液，研究了除湿器入口溶液浓度、入口空气流量、溶液流量及空气入口温度、湿度变化对除湿器除湿量的影响；以及氯化钙和氯化锂的混合质量比分别为1：1.5、1：1、1.5：1时的除湿效果；实验结果表明：用氯化钙和氯化锂混合质量比为1：1时的除湿溶液代替氯化锂溶液能节省费用，同时也改善了用纯氯化钙浓溶液作除湿剂时的除湿性能。

A production method as defined in claim 1, further comprising the step of mixing the heavy solution obtained in said step of separating the reaction product into the light solution and the heavy solution with a neutralizer to neutralize the catalyst composed of alkaline material contained in the heavy solution.

生产方法所界定的权利要求1 ，进一步组成的一步混合沉重的解决方案，获得了在说的一步分离反应产物到轻的解决方案和沉重的解决方案与中和剂，以抵消催化剂组成的碱性物质中所载的沉重的解决办法。

Iodine in the test solution was oxidized to IO-3 by excessive amounts of potassium permanganate solution and sodium hypochlorite solution,and excess of the oxidants was removed by reacting with sodium sulfite solution.

采用过量联合氧化剂高锰酸钾-次氯酸钠氧化试液中碘至IO3-，剩余的高锰酸钾和次氯酸钠用过量的亚硫酸钠反应除去，利用IO3-的电活性，建立了在四硼酸钠-吐温-80底液中的线性扫描伏安法测定微量碘的方法。

Putt your way through 36 fun-filled holes of minigolf on 3D designed courses with elevated greens, bunkers, bridges and water hazards, among other crazy obstacles.

您的推杆方式，通过36个有趣的填孔迷你的三维设计的课程，以提升绿党，掩体，桥梁和水的危害，除其他疯狂的障碍。

Some participles can be used either as attributes or as predicatives.

有些分词既可当定语用，也可当表语用。