查询词典 uniform velocity

The results showed that velocity distribution was non-uniform outside the filters.

结果表明，滤管外速度分布是不均匀的。

Then, a series of successful numerical simulations on the finite length inclined positively buoyant jets in uniform cross flows environment are developed. Based on the results from numerical simulations, some qualitative pictures of the complex three -dimensional mean flows are given. In terms of these pictures, the flowing behavior of the buoyant jets and the mechanism of end-vortexes generation are made a study. The change rules of end-vortexes and temperature and dilution on trajectory of jets, horse-hoof shape of buoyant jets on horizontal, the phenomenon of the jets touch wall, and the effects of diffuser length^ densimetric Foroude number % velocity ratio on buoyant jets are also given.

之后对均匀横流环境中的有限长线源型倾斜浮力射流进行了大量的数值计算，根据数值模拟的结果，绘出了一些复杂的三维图，据此探讨了其流动特性及端涡的产生机理，成功模拟了端涡现象及其发展过程，对轨迹线上沿程温度及稀释度的变化规律，倾斜浮力射流的马蹄形结构，浮力射流的贴壁现象，扩散器长度、喷口弗汝德数、流速比等对浮力射流的影响等问题均给出了有价值的结论。

Aiming at slope types, features, deformation traits and destroy mechanism of high steep valley slope at Jinping Ⅰ Hydropower Station, and applying monitoring results, a comprehensive prediction design is suggested. In the space, according to the occurrences of unfavorable geological phenomena such as faults F5, f(subscript 42-9) deep fracture SL(subscript 44-1) and lamprophyre vein X, all of them can be treated as the boundary conditions for slides, potential instable blocks of slope on the left abutment are estimated which take on a wedge-shaped sliding model. In the sametime, through using three kinds of joint prediction methods such as statistic models and nonlinear models, judging from the shape of curves of deformation-time and their deformation velocities, it is found that the slope is at the state of slowly creeping to uniform deforming with a deforming velocity of 0.05 mm/d.

针对锦屏一级水电站左岸高边坡的边坡类型、边坡特征、变形特点和变形机制，在监测成果的基础上，对其进行综合预报，空间上判断左岸拱肩边坡由断层F5，f(下标 42-9)、深部裂缝SL(下标 44-1)及煌斑岩脉X互相组合，形成可能边坡失稳块体的边界条件、楔型体滑移失稳模式：时间上采用统计模型及非线性模型多种方法联合预报，根据边坡变形时序曲线的形态及变形速率指出：边坡目前处在缓慢蠕动至匀速变形阶段，变形速率小于0.05mm/d。

The results indicate: diversion shell can transform the kinetic energy of fluid into pressure energy well, and eliminate the circumferential component of fluid; the inlet incidence angle of vaned diffuser increases at the condition of O.8Q, and it results in flow separation very likely and the hydraulic loss increases; it is nearly non-impact inflow at the condition of 1.2Q, and the velocity distribution is uniform at the inlet of vaned diffuser and flow separation dose not appear.

结果表明：导流壳能很好地将叶轮中流出的流体的动能转化为压能，并消除速度的圆周分量；在0.8Q工况下，空间导叶的进口冲角增大，容易在空间导叶背面产生流动分离，造成水力损失增加；在1.2Q工况下，空间导叶的进口接近无冲击入流，在进口处流速分布较均匀，其内部未发生流动分离现象。

A uniform magnetic field acts perpendicular to the porous surface which absorbs the micropolar fluids with a suction velocity varying with time.

均匀磁场垂直作用于可以吸收微极流体的多孔表面，吸引速度随着时间而变化。

The major works are as follows: 1 The 3-D numerical model of U-sharp flow passages is set up. The single-phase fluid flow and heat transfer are simulated for the U-sharp smooth and rib-roughened flow passages with FLUENT software. Their performance curves, temperature field and velocity vector are obtained and the local heat transfer and flow pressure-drop distribution along flow passage are analyzed. It is revealed that the ribbed flow passages can enhance heat-transfer and make the temperature more uniform, but it increases the pressure-drop to more extent. 2 The influences of diaphragm depth, channel width and board spacing on the performance are investigated.

建立了层叠式蒸发器U形流道的3维湍流模型，用FLUENT软件对尺寸相同的U形光滑流道和肋化流道中单相流体的传热和流动进行了数值模拟，得到了两种流道的传热和阻力性能关系曲线及速度矢量图、温度场，分析了光滑流道和肋化流道的局部换热系数及沿程压降变化，结果表明流道的肋化能有效的增强传热，而且使流体的流动和传热更加均匀，但也较大地增大了阻力。

The results show that,in the static pressure tank,the air velocity decreased and the pressure distribution was uniform gradually in the corner between the plates and clapboards with the increase in the aperture of the perforated plates.Moreover,there was Coanda effect around the freezing food in the freezing area and the food temperature decreased from the inlet to the outlet of the freezing area.

通过改变位于冻品上下方的均风孔板开孔率得出：在静压箱内，随着出口开孔率的增大，风速逐渐减小，并且在由孔板和隔板间形成的局部区域内，压力分布逐渐趋于均匀；在冻结区内，通过速度场的模拟，从数值计算的角度验证了冷风在冻品表面产生的柯恩达效应。

Taking velocity moment as controlled variable, the formulas were deduced to calculate quasi-3D inverse problem for uniform stream model of guide pulley. According to the theory of two relative flow surfaces and the force analysis of air bubble, the formulas were deduced to calculate quasi-3D direct problem while gas and liquid running in the guide pulley of multiphase pump, and a method was provided to carry on quasi-3D numerical calculation of inner flow filed.

以速度矩作为控制参数，推导出多相泵导轮中均匀流模型的准三维反问题计算公式；基于两类相对流面理论及气泡的受力分析，推导出气、液两相在多相泵导轮中运动的准三维正问题的计算公式，提出一种对多相泵导轮内流场进行准三维数值计算的方法。

In this paper,the raft is approximated by a thin plate with regular shape at first.Then the floating raft system is divided into several subsystems,such as plate raft,elastic foundation,etc,which are respectively modeled by four-parameter net method.After that,dynamic absorber and active absorber are put into a uniform frame to obtain the model of plate raft subsystem coupling with them.At last,according to the force and velocity relationship among each subsystem\'s interfaces,the entire plate floating raft system is modeled by subsystem structural admittance synthesis method.As the main structure of floating raft system is elastic,it is inevitably to study the optimization of actuators\' mounting positions before designing control law.In this paper,two new criterions are proposed for it.

本文首先将浮筏的中间筏架用一个规则形状的薄板近似；然后再将浮筏系统分解成若干个子系统，如板式筏架子系统、弹性基础子系统等，运用四端参数网络建立了它们的动力学传递方程，传递特性由导纳矩阵描述；接着，将动力吸振器和主动吸振器的(来源：ABC90论文00网www.abclunwen.com)分析统一于一个框架内，获得了与吸振器耦合的板式筏架子系统的动力学传递特性；最后，根据各子系统在各界面上的作用力和速度的相互关系，通过子系统结构导纳综合方法获得了整个板式浮筏系统的动力学传递方程，并在此基础上获得了系统的力传递函数模型。

A new method is suggested in which velocity potential of a Kelvin source moving in infinite deep uniform fluid is taken as a basic Green function.

提出了将Kelvin源格林函数作为基本解的求解物体在分层流体中兴波问题的计算方法。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。