查询词典 uniform distribution

To investigate the thermal protection effects of a heat sinking vest with phase-change material in high-temperature and high-humidity environment and the feasibility of numerical computation of heat transfer to the vest, based on the analysis of heat and mass transfer characteristic about the accouterments, a thermodynamic model was set up with the enthalpy method. The uniform energy equation was constructed for the whole domain, and the implicit difference equation was used in every node, the distribution of enthalpy was solved by numerical method.

为了研究相变材料降温服在高温高湿条件下的热防护性能和相变材料数值计算方法应用于降温服传热计算的可行性，在分析服装传热传质特点及计算方法的基础上，利用焓值分析法对服装中的相变材料建立传热模型，在整个区域建立统一的能量方程，在区域结点进行离散，并进行隐式求解，得到焓的分布。

The results indicated that the prepared TiO2 was of anatase phase structure with a uniform particle size Distribution of 15~20 nm.

结果表明，所制备的纳米TiO2为锐钛型结构，粒径为15~20 nm，分布均匀。

The climate characteristics of TCP were analyzed with variance analysis,trend coefficient and linear regression technique,followed by comparison with those of annal total rainfall in East China.Results show that the spatial distribution of TC rainfall is not uniform in East China with the...

结果表明：华东地区登陆台风降水量空间分布不均匀，福建东南沿海地区最大，具有向西北方向递减的趋势，这种趋势与地形等因素有关；TCP的年际变化明显，9 a和15 a周期显著；TCP年代际变化表现为20世纪50年代最多，70年代前开始减少，比华北地区台风降水减少出现的时间提早10 a；TCP与总降水两者的时间演变特点差异较大。

The APW in summer is less than 25 mm which is the least limit value of monsoon areas.This means that Xinjiang is not affected by monsoon.The geographic distribution of APW is adverse with that of precipitation,videlicet,higherAPW values corresponding to lower precipitation values.With the effects of westerly winds,the APW mode presents as an uniform change within Xinjiang area and has a stable distribution.It is very different from Xinjiang rainfall mode which changes a lot spatially.As mentioned above,there is no obvious change during 1961～2000,this indicates that APW is not a dominant factor determining precipitation,it is the result of dynamic condition,water vapor convergence and other causes.

APW的地理分布与实际降水量分布相反，其最大区域却为降水量最小区，受西风带影响，新疆APW模态主要表现全疆一致变化，分布稳定，与降水模态分布差异性大有显著不同，且近40年来无显著变化趋势，表明决定新疆降水差异的根本原因不在于水汽的多少，而是由降水产生的动力条件、水汽辐合和其它因素差异决定的。

A novel lightly-doped channel approach for linearity improvement of InGaP/InGaAs pseudomorphic high-electron-mobility transistor device was presented. Light doping in the channel region of the conventional δ-doped InGaP/InGaAs PHEMT was adopted to provide a uniform and symmetric electron distribution in the channel region to achieve flat extrinsic transconductance distribution under different gate bias conditions.

本次实验在传统矽平面掺杂元件结构的通道区域中加入微量的杂质浓度掺杂，使得电子在元件通道层中的分布更为均匀及对称，以期望在不同的闸极偏压条件下得到较为平坦的转导值分布曲线，改善磷化铟镓/砷化铟镓假晶式高电子迁移率电晶体的线性度表现。

It has many problems: the selected objection is improper; the effective transfer payment is insufficient; the distribution of transfer payment is not regular;there are too much randomicity and form; a uniform harmonizing mechanismis is lacked,the distribution amount is not rational; and the formulized transfer payment system is not effective etc.

存在着目标选择不当，有效转移支付不足；转移支付的分配不规范，带有相当大的随意性；转移支付的形式过多，相互间缺乏统一的协调机制；分配数额的确定不合理；公式化转移支付制度作用不大等弊端。

Based on the fractal characteristics of the blasting fragmentation distribution,the paper derived a relationship between the explosive specific charge and the uniform exponent of the distribution,which is instructive for predicting the fragmentation.

基于爆破块度分布的分形特征，从理论上推导了炸药单耗与爆破块度分布均匀性指数的关系，对爆破块度分布的预测具有重要的指导意义。

In comparison with bugle shaped nozzle, bifurcated nozzle downward jet angle 45°, cow-nose nozzle and three-hole nozzle, in all, the last two are better than the former and bifurcated nozzle downward jet angle 45 is better than bugle shaped nozzle; Cow-nose nozzle is helpful for guaranteeing the product's quality, in order to protect jet flow from eroding the strand at narrow face, gain uniform temperature distribution at cross section and decrease heat flux, adding the block's width to 100 mm. Three-hole nozzle is advantageous to increase flux and casting speed, but should avoid weak shell thickness in the center broad. In the real production, setting the SEN's immersed depth or plugging the hole at the bottom can adjust the flow and temperature distribution in the mold.

对比喇叭形水口，双侧孔水口(45°)，牛鼻子水口和三孔水口，总的说来后两者优于前两者；而双侧孔水口(45°)又优于喇叭形水口；牛鼻子水口和三孔水口比较各有特点，前者对保证铸坯质量有利，为防止流股对窄面的冲击，增加挡块宽度到100 mm，可使结晶器横截面上温度分布更加均匀，降低窄面热负荷；后者对增加流量，提高拉速非常有利，但要防止中孔射流过强导致铸坯中心坯壳变薄，在实际生产中可通过控制水口浸入深度或塞住浸入式水口的底孔来调节结晶器中的流动与温度分布状态。

In comparison with bugle shaped nozzle, bifurcated nozzle downward jet angle 45°, cow-nose nozzle and three-hole nozzle, in all, the last two are better than the former and bifurcated nozzle downward jet angle 45 is better than bugle shaped nozzle; Cow-nose nozzle is helpful for guaranteeing the product"s quality, in order to protect jet flow from eroding the strand at narrow face, gain uniform temperature distribution at cross section and decrease heat flux, adding the block"s width to 100 mm. Three-hole nozzle is advantageous to increase flux and casting speed, but should avoid weak shell thickness in the center broad. In the real production, setting the SENs immersed depth or plugging the hole at the bottom can adjust the flow and temperature distribution in the mold.

对比喇叭形水口，双侧孔水口(45°)，牛鼻子水口和三孔水口，总的说来后两者优于前两者；而双侧孔水口(45°)又优于喇叭形水口；牛鼻子水口和三孔水口比较各有特点，前者对保证铸坯质量有利，为防止流股对窄面的冲击，增加挡块宽度到100 mm，可使结晶器横截面上温度分布更加均匀，降低窄面热负荷；后者对增加流量，提高拉速非常有利，但要防止中孔射流过强导致铸坯中心坯壳变薄，在实际生产中可通过控制水口浸入深度或塞住浸入式水口的底孔来调节结晶器中的流动与温度分布状态。

Research results show that under AC voltage the voltage distribution of Y-type insulator strings is extremely non-uniform and the voltage distribution curve of Y-type insulator string is si...

研究结果表明：在交流电压下，Y型绝缘子串的电压分布极不均匀，其电压分布曲线和交流悬垂I串类似；在直流电压下，Y型绝缘子串的电压分布极不均匀，绝缘子串导线侧绝缘子分担电压高于其它绝缘子，总体上呈现导线侧和杆塔侧两端高、中间低的分布趋势。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。