查询词典 under
- 与 under 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
This selection strongly inhibits the growth of arg-13 under stringent sorbose/glucose condition but allows arg-13 to grow under spot test conditions.
此法在严紧山梨糖/葡萄糖条件下能强烈抑制arg-13突变株生长,但在斑点试验条件下允许arg-13突变株生长。
-
The results showed that 3% to 5% propionic acid solution had better preservative action by soaking the sorosis for three minutes under normal atmospheric temperature;and 0.5% propionic acid,potassium sorbic acid and sodium benzoic acid solution all had better preservative action under low temperature of 5℃ to 8℃.
结果表明,在常温下,3~ 5 %的丙酸溶液浸果 3 min具有较好的防腐作用;在 5~ 8℃的低温条件下,0 。5 %浓度的丙酸、山梨酸钾和苯甲酸钠浸果 2 min均能达到较好的防腐效果。
-
Pollen morphology of six species were similar, all trisected circular shape in polar view, tricolporate. Observed under LM the ornamentation of exine is granular with spinules arranged sparsely and under SEM the basal part of spinule extend.
六种沙蒿的花粉较为相似,极面观均为三裂圆形,三孔沟,孔横长,外壁纹饰在光镜下表面颗粒状,在电镜下为排列较疏的刺,刺基外延。
-
It is pointed out that under the condition of the temperature of 1120℃, the reaction time of 16 mm and the carbon content of 27%, the metal transformation rate of sponge iron used for general metallurgy is up to 90%. But the optimal carbon content is 29% for iron sponge to treat DSD acid oxidation wastewater. Under condition of the wastewater's pH value of 3 to 5 and the reaction time of 40min, the removal rates of COD and color are 68% and 90%, respectively. The BOD/COD ratio is up to 0.425 when DSD oxidation acid water is treated with sponge iron.
研究表明:在配碳量27%、反应温度1160℃、反应时间16min的情况下,以铁泥为原料制备的常规海绵铁的金属化率可达90%以上;用于处理DSD酸氧化废水的海绵铁适宜配碳量为29%,用制备出的海绵铁处理DSD酸氧化废水,在pH值3~5、反应时间40min时,出水的COD去除率可达68%、色度的去除率达90%、可生化性指标BOD/COD提高到0.425。
-
The results showed that, under P sufficient conditions, 2 QTL were identified for SPUE on chromosome 1B and 5A, respectively; 3 QTL were detected on chromosome 2B, 5A and 7A, respectively, influencing WPUE. Under P deficient conditions, 3 QTL on chromosome 2D, 3B, and 6D were detected for SPUE, and 2 QTL on chromosome 2D and 7A for WPUE.
结果表明,正常供磷,有2个与SPUE有关的QTL,分别位於染色体1B和5A上,变异解释分别为6.55%和11.61%;与WPUE有关的QTL有位於染色体2B、5A和7A上的3个;SPUE和WPUE还分别受一对互作位点的影响。
-
Pass to count to Wisterch parameter , and the steel wire is different from the molding tool get in touch with the length, and settle the path the research taking the length work the stabber angle to get under differently pull to stir the term, mold core adoption of best severally why size, combine the best work stabber of research the Cape, and settle the path to take the length nextly steel wire is in the molding tool of have fever to measure, air inside dispel-heat calories, winding dispel-heat on the coil-canister , and its molding tool dispel-heat calories of, and cause the steel wire the temperature difference pass in and outing the molding tool to influence steel wire machine function, under the experiment inside pull to stir the term according to the same race different work stabber Cape half of adoption the Cape(7 degree,10 degree,12 degrees, the best mold Cape, experience mold Cape) settle the path to take the length(2-3 mm,3-4 mm,4-5 mms, theories length, experience length) to proceed to experiment, and get the conclusion, work stabber the Cape then is more big the steel wire get in touch with the length with
通过对Wisterch参数,钢丝与模具接触长度、定径带长度、工作锥角度的研究得到了在不同拉拨条件下模芯采用的最佳几何尺寸,并研究最佳工作锥角、定径带长度下钢丝在模具中的发热量、空气中散热量、卷筒上的散热量及其模具散热量的不同,导致钢丝进出模具的温度差别对钢丝机械性能的影响,在实验中根据同种拉拨条件下采用不同工作锥角半角、定径带长度进行试验,得出结论,工作锥角越大则钢丝与模具接触长度越短,钢丝变形越剧烈,在模具中发热量就越高,导致钢丝出模温度高,使钢丝强度、硬度升高,弯曲、扭转次数降低,并且降低模具使用寿命。在其它条件相同的情况下,定径带越长则钢丝与定径带简壁磨擦增大,使钢丝发热量加大,从而使钢丝强度、硬度略升高,弯曲扭转次数略降低但定径带的增大减小了钢丝变形产生的弹性后效使钢丝出模直径比较稳定。
-
In recent months has been broken for the trifling matter of trivial in the busy, busy the weekend it was to sit under the bodhi tree Sunday to take a stand no chance, not today, under the bodhi tree ...
近月来一直在为琐琐碎碎的事在忙,忙得把那原本要在週末週日到菩提树下坐一坐的机会都沒有,今天不在菩提树下。。。
-
Methods With non - surgery elderly CHD patients at the stane periods as control,the whole blood viscosity and whole blood reduction viscosity were determined under three different shearing stress conditions ( 150s-1 ,60s- 1 and 10s- 1 )by NXE - 1 weissenberg wiscosimeter, plasma viscosity was tested under middle shearing stress condition, and the hematocrit was also determined by rourine method.
方法以NXE-1型椎板粘度计在150s-1、60s-1和10s-1 3个不同切变条件下测定老年冠心病手术患者的全血粘度、全血还原粘度,在中切变条件下测定血浆粘度,以常规方法测定血球压积。
-
1 Because our company's enzyme production of a time sex usage the 滤 divided by the leuco - cell blood transfusion the 器 under clinically have already used the polypeptide year, fall under the already set product, for this reason our company to primarily use to analyze have already been wantsed not by other tool the bane's means, it that judge from aly statedly the start of some result, analyse the criterion a the possible reason of the lower function system.
8.1.1因为本公司生产的一次性使用滤除白细胞输血器在临床已使用多年,属于定型产品,因此本公司主要是用来分析已由其他方法判定的危害的手段,它从一种设定的不希望有的后果开始,分析判断下一较低功能系统的可能原因。
-
Article 94 The State organs of the People's Republic of China of all levels are under the obligation to carry out thoroughly the obligations assumed by the Signatory States' Governments under international human rights treaties and treaty protocols, which have already been concluded or acceded to by the People's Republic of China.
第九十四条中华人民共和国各级国家机关有义务认真履行中华人民共和国已经缔结和参加的国际人权公约以及公约的任择议定书所规定的缔约国政府应尽的公约下的各项义务。
- 相关中文对照歌词
- House Under The Ground
- Six Feet Under
- Under The Boardwalk
- Under Attack
- Under The Influence
- Top Dawg Under Dawg
- World Down Under
- Brothers Under The Sun
- Under My Skin
- Under My Skin
- 推荐网络例句
-
However, as the name(read-only memory)implies, CD disks cannot be written onorchanged in any way.
然而,正如其名字所指出的那样,CD盘不能写,也不能用任何方式改变其内容。
-
Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.
镀锌钢托盘多用于出口,替代木托盘,免薰蒸,符合欧盟、北美各国对出口货物包装材料的法令要求;喷涂钢托盘适用于重载上货架之用,托盘表面根据需要制作成平板状、波纹状及间隔形式,满足不同的使用要求。
-
A single payment file can be uploaded from an ERP system to effect all pan-China RMB payments and overseas payments in all currencies.
付款指令文件可从您的 ERP 系统上传到我们的电子银行系统来只是国内及对海外各种币种付款。