查询词典 under-charge

Article 22 Under any of the following circumstances, business operators may not file a concentration declaration to the Anti-monopoly Law Enforcement Agency under the State Council

第二十二条经营者集中有下列情形之一的，可以不向国务院反垄断执法机构申报

The "New" items are stored under the file type definition, under a ShellNew key.

"新"项目存储在文件类型的定义，根据ShellNew的关键。

The conclusion shows that gas diffesion model under the third kind boundny conditionincludes the m0del under the first Kind boundary condition;mass transfer Biot criterion can repressent the featoreof gas diffesion field of coal particles.Moreover,the measurement method of gas diffu...

结论表明，第三类边界条件下的瓦斯扩散模型包含以往研究的第一类边界条件下的扩散模型，传质毕欧准数能表征煤粒瓦斯扩散场的特点；介绍了测试煤粒瓦斯扩散系数和表面传质系数的方法，给出了测试实例。

Compared with the graphite, the coefficients of friction of the RL-C/C are lower under the same load of about 0.08-0.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.02-0.05 and 0.2 mm^3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

结果表明：PAN炭纤维改善C/C复合材料的摩擦磨损行为；在实验载荷范围内，与高强度石墨材料相比，含RL炭C/C复合材料的摩擦因数降低0.08~0.12；体积磨损量增幅降低；与热解炭试样相比，具有SL炭C/C复合材料的摩擦因数降低0.02~0.05，体积磨损量低0.2立方公厘左右；随着时间的延长，大部分C/C复合材料的摩擦因数基本相对稳定或呈小幅下降，而石墨、热解炭块的摩擦因数均呈不同幅度的上升；具有RL炭的C/C复合材料摩擦表面膜厚度随载荷增加而降低，具有SL炭的C/C复合材料摩擦表面较粗糙；高强石墨能形成较完整致密的摩擦膜，但磨粒磨损严重，磨屑易在摩擦膜边缘形成层状堆积；热解炭块摩擦表面磨屑堆积松散，有较多的孔洞以及热解炭层整体剥落的形貌。

Compared with the graphite, the coefficients of friction of the RL-C/C are lower under the same load of about 0.080.12, and the increasing range of the volume losses are still lower than those of the graphite. Compared with the SL pyrocarbon material, the COF and the volume loss of the SL-C/C are about 0.020.05 and 0.2 mm3, lower than those under the same load. The COFs of most RL-C/C and SL-C/C specimens remain stable or decrease slightly with time, while those of the graphite and pyrocarbon specimens increase. The thickness of the integrated friction film of the RL-C/C decreases with load, but the wear surface of the SL-C/C is rough. Tough the wear surface of the graphite is integrated, the serious abrasive wear make the debris move easily and accumulate on the edge of the wear trace to form a restacked morphology. On the wear surface of the pyrocarbon material, some loosed debris, circular worn holes and flake worn out pyrocarbon has been found.

结果表明：PAN炭纤维改善C/C复合材料的摩擦磨损行为；在实验载荷范围内，与高强度石墨材料相比，含RL炭C/C复合材料的摩擦因数降低0.08~0.12；体积磨损量增幅降低；与热解炭试样相比，具有SL炭C/C复合材料的摩擦因数降低0.02~0.05，体积磨损量低0.2 mm3左右；随着时间的延长，大部分C/C复合材料的摩擦因数基本相对稳定或呈小幅下降，而石墨、热解炭块的摩擦因数均呈不同幅度的上升；具有RL炭的C/C复合材料摩擦表面膜厚度随载荷增加而降低，具有SL炭的C/C复合材料摩擦表面较粗糙；高强石墨能形成较完整致密的摩擦膜，但磨粒磨损严重，磨屑易在摩擦膜边缘形成层状堆积；热解炭块摩擦表面磨屑堆积松散，有较多的孔洞以及热解炭层整体剥落的形貌。

It was wholly in the lower ice, but close against the upper, and was flattish, or perhaps slightly lenticular, with a rounded edge, a quarter of an inch deep by four inches in diameter; and I was surprised to find that directly under the bubble the ice was melted with great regularity in the form of a saucer reversed, to the height of five eighths of an inch in the middle, leaving a thin partition there between the water and the bubble, hardly an eighth of an inch thick; and in many places the small bubbles in this partition had burst out downward,and probably there was no ice at all under the largest bubbles,which were a foot in diameter.

在气泡之下和周围已经结了一层新的冰，所以气泡是在两片冰的中间；它全部是在下层中间的，却又贴近上层，扁平的，也许有点像扁豆形，圆边，深四分之一英寸，直径四英寸；我惊奇地发现，就在气泡的下面，冰溶化得很有规则，像一只倒置的茶托，在中央八分之五英寸的高度，水和气泡之间有着一个薄薄的分界线，薄得还不到一英寸的八分之一，在许多地方，这分界线中的小气泡向下爆裂，也许在最大的直径一英尺的气泡底下完全是没有冰的。

In the state large-and-middle scale coal enterprise, because the technology mining under flic building is not ripe enough, the coal pressed under the village restricts the coal enterprises development seriously.

在国有大中型煤炭企业中，由于建筑物下开采技术不够成熟，村庄下压煤严重制约着煤炭企业的发展。

LED High Power DownLight,LED Hight Power Track Light,LED High Power Ceiling Light,LED high Power Wall Lamp,LED Hight Power Grid Lamp,LED Flood Light,LED High Power Wall Washing Light,LED High Power Under Ground Light,LED High Power Under Water Light,LED Table Lamp,LED High Power Street Light,All Kinds of LED Light.

成功研制生产的大功率LED筒灯、LED泛光灯、LED吸顶灯、LED豆胆灯、LED横灯等产品，因其可靠的质量和性能远销到欧洲、北美洲、及亚洲国家。公司产品全面通过CE认证，在设计、生产、和服务过程中严格实施标准化管理和控制。

Under the statute, federal agencies are normally required to respond to a FOIA request within 20 business days of its receipt, but may extend this by 10 business days under certain circumstances.

根据照信息自由法，联邦机构被正式要求在收到请求20个工作日内（在特定情况下可以延长10个工作日），对按这项法律作出的请求作出回答。

The results show that the periodic average yield of acrylonitrile under any forced periodic oscillation of oxygen concentration among this experimental conditions,thus obtained could higher than that under the steady-state condition.

而为完成整个氧化还原循环过程，气相氧分子就必须在不同丙烯吸附中心的再氧化中心上吸附，获得电子，解离后扩散进入催化剂中的阴离子孔穴，如图1所示。从该机理可知，反应气氛中的氧烯比大小对催化剂表面的氧化还原反应过程的循环有重大影响。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。