查询词典 under weight

The conclusion indicated that pyruvate supplement could accelerate the speed of body energy metabolism and slower weight and body fat gain during exercises. Due to the influences of pyruvate supplement on the levels of enemies and hormones to adjust body lipometabolism during exercises, body blood lipid and glucose levels decreased, and the process of fat metabolism came under.

丙酮酸补充可在一定程度上减慢运动机体体重和体脂的增长速度，加快运动机体能量代谢速度；并通过影响运动机体脂肪代谢相关调控酶和激素水平，使其血脂和血糖水平下降，从而影响其脂肪代谢过程。

Tory mucks of the region contain 50 per cent or more mineral matter by weight and have considerably more native fertility than saw grass mucks, which were formed under logographic conditions.

保守党mucks遏制该地区50%以上的重量和矿物质有相当多的本土生育率比看到草mucks，logographic条件下所形成的。

Bass fishing ontario Tory mucks of the region contain 50 per cent or more mineral matter by weight and have considerably more native fertility than saw grass mucks, which were formed under logographic conditions.

低音渔安大略保守党mucks遏制该地区50%以上的重量和矿物质有相当多的本土生育率比看到草mucks，logographic条件下所形成的。

The results show that the optimum conditions are: the mole ratio of malonic acid to benzaldehyde 1.0:0.9, the dosage of proline 4.0% of the weight of malonic acid and the reaction time 4h, the yield of cinuamic acid is 99.0% under the optimum conditions.

实验结果表明，合成肉桂酸的最合适条件：原料比为1.0：0.9，L-脯氨酸用量为丙二酸质量的4.0%，反应时间4h，在此最佳条件下，肉桂酸的收率达到99.0%。

With only inches to freedom for Michael, the cable tears free from the wall under Manche's weight.

Michael 离外墙只有几英寸远了，但是电缆线由于 Michael 的体重而被扯断了。

The results show that the composite coating is metallurgically bonded to the substrate and the microstructure is fine and uniform. The hardness of the composite coating is up to 400 HV, which is 2.5 times that of the substrate. Under room temperature and oil lubrication condition, the sliding wear tests indicate the friction coefficient and weight loss of the composite coating are smaller than those of substrate. The worn surface of the composite coatings is much smoother than that of the substrate, without grooves and crater.

结果表明，复合材料涂层与基体形成良好的冶金结合，微观组织细小、均匀；复合材料涂层硬度达400HV，约为基体的2.5倍；在室温油润滑条件下，滑动磨损试验表明复合材料涂层摩擦系数和失重均小于基体，磨损表面划痕较浅且平滑，无明显的犁沟、粘着、剥落现象；激光表面合金化显著提高了材料的耐磨性。

Result Richards Model and Monodic Quadratic Equation could properly describe grain dry matter growing process and the change process of grain filling rate with days after anthesis. There was big difference in average grain filling rate, maximum grain filling rate under different planting density. Average grain filling rate 1.26 mg/ and maximum grain filling rate 2.44 mg/ of T7 were the quickest, and the average grain filling rate 0.94 mg/ and maximum grain filling rate 1.99 mg/ of T12 were the slowest, and the maximum difference percentage of the average grain filling rate and maximum grain filling rate among different density were 33.98%, 22.61%. There was significant correlation between average grain filling rate, maximum grain filling rate, grain filling active duration, rapid increasing stage and thousand grain weight, and the correlation coefficients were 0.628*, 0.630*, 0.849**, 0.739**. Active grain filling duration contributed mostly to TGW.

结果不同密度处理间千粒重、单位面积穗数、穗粒数、单株穗数、单位面积籽粒产量均存在显著差异；不同密度处理冬小麦的籽粒灌浆均符合慢－快－慢的&S&型生长特性，用Richards模型能很好地模拟冬小麦籽粒增重过程，用一元二次抛物线方程能较好地模拟冬小麦灌浆速率随花后时间变化过程；不同密度处理间平均灌浆速率、最大灌浆速率有较大差异，最大差异率分别为33.98%、22.61%，T7的平均灌浆速率1.26mg/及最大灌浆速率2.44mg/均最大，T12的平均灌浆速率0.94mg/及最大灌浆速率1.99mg/均最小；平均灌浆速率、最大灌浆速率、灌浆活跃期、灌浆快增期与千粒重显著或极显著正相关，相关系数分别为0.628*、0.630*、0.849**、0.739**；通径分析表明，灌浆活跃期对千粒重的贡献最大。

The weight loss method, electrochemical impedance spectroscopy and surface analysis methods were employed to investigate the corrosion behavior of steel A3 under the combined effect of Streptomyces and Nocardia sp.

采用腐蚀失重法、电化学交流阻抗法和表面分析技术研究了A3钢在链霉菌和诺卡氏菌共同作用下的腐蚀行为。

The PDLLA with a viscosity average molecular weight beyond 20×10~4 was obtained under the optimum synthesis conditions of the lactide after being recrystallized 4 times as the monomer,the vacuum level of 0.098 MPa,reaction temperature of 150-160 ℃,reaction time of 6-8 h,and using 0.1%-0.18% stannous octoate as catalyst.

实验结果表明，重结晶4次后的丙交酯作为单体，在辛酸亚锡摩尔分数为0.1%—0.18%，真空度0.098 MPa，聚合温度150—160℃下聚合6—8 h可获得粘均相对分子质量Mη大于20×104的聚D，L-丙交酯。

In 2000, Nishida et al synthesized the PPDO whose molecular weight could reach 142,000 but the monomer conversion could only reach 79.4% by using stannous octoate as catalyst with co-initiator under conditions that T = 100oC, M/I = 4900, t = 20 h, in 2000, the enzymatic polymerization of PDO was carried out at 100oC for 15 hours using 5wt% immobilized lipase CA by Nishida et al.

这主要是因为PDO的结构相对稳定，开环聚合要比GA、LA、CL困难一些，而且用于PDO开环聚合的催化剂体系单一，主要集中在Ti， Zr， Sn， Ld， La， Yb， Hg等重金属，然而这些重金属作为副产物，不容易从PPDO中分离出来，阻碍了PPDO作为医用材料的应用，这也造成了PPDO的成本昂贵。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。