查询词典 under pressure

In northeastern of basin, together with the structural framework of slope belt and the dynamical information of well, we can conclude that the gas reservoir in Taiyuan-early Shihezi formation dominantly belong to protogene depositional gas reservoir under the normal pressure, and the gas favourable reservoir belt was controled by framwork of main sandbody; But in upper Shihezi Formation to Shiqianfeng Formation the gas reservoir show the feature of secondary Tectonic-depositional gas reservoir under the extremely low pressure, and the gas favourable reservoir belt mainly locate in a zone which the low amplitude structure and main sandbody superposed in the slope belt.

5盆地东北部斜坡带构造与钻井生产动态资料的相关分析结果表明，太原组-下石盒子组气藏主体属于正常压力下的原生岩性气藏，其有利含气区带主要受控于主砂体分布格局；上石盒子组-石千峰组气藏则主要为异常低压下的次生构造-岩性气藏，其有利含气区带主要分布在斜坡带低幅度构造与主砂体叠合区。

It uses middle extracted steam from steam turbine to heat the feetwater of boiler to the saturate temperature under working pressure of deaerator, so as to remove dissolved oxygen and other gases. To prevent or slow boiler and steam turbine as well as pipeline from corroding, and extend them service life, to ensure the operation of the power plant under safety economic condition. The high-pressure deaeator of 235t/h is a kind of mixture-type heater, which shall match with 55 MW units, whose deaerated head adopts a kind of new-style stuffing way with rotation film.

它是利用汽轮机的中间抽汽将锅炉给水加热到除氧器工作压力下的饱和温度，以达到除去给水中的溶解氧和其它气体，防止或减缓锅炉、汽机及其管道的腐蚀，延长其使用寿命，确保电厂的安全经济运行。235t/h高压除氧器是配55MW机组的混合式加热器。

Lithologies are mostly sand and carbonate rocks, caps are mud rock, shale and magmatite. Entrap types are anticline, fault block rebuilt by breaking and the screened entrap diapered rock mass. The composition is CO_2, N_2, CH_4, C_2H_6 and He etc. It is magma air source body and its geologic fashions are intrusion and buried volcanic conduit. The relations between gas reservoirs and gas source bodies have three types: magma intrusion-breaking-communicated gas reservoir, magma intrusion-contacted CO_2 reservoir and buried volcanic conduit-contacted gas reservoir. The CO_2 migration in magma intrusion is consisted of fusing and crystallizing phases;it in volcanic conduit is consisted of near-surface effusion and crystallizing phases.The buoyancy of CO_2 in water far more than migration resistance in breaking or chink, CO_2 is easy float upward, the floating can results in differentiation of different density gases and concentration of sealed gas. The gas in sand reservoir firstly migrate into the higher porosity and coefficient of permeability sand, and along with the pressure going up it migrate into the lower. In magma intrusion-breaking-reservoir migration, CO_2 firstly migrate into watered breaking, began gravity differentiation and concentrate, the gas pressure time and again go up, CO_2 migrate into reservoir and concentrate under expansibility as the pressure reach upward a given extend. The CO_2 in reservoir experience four breaking modes: chemistry deposition, dissolution, diffusion and mechanic breaking, the pressure balance can be broken by faulting and the CO_2 will further migrate and form new reservoir.

济阳坳陷已发现的八里泊、阳25、平方王、平南、高青、花17 CO_2气藏主要储集层位有奥陶系、中生界、沙四段、沙三段、沙一段、馆陶组和明化镇组，储集层岩性以砂岩和碳酸盐岩为主，盖层以泥质岩、页岩和岩浆岩为主。；圈闭类型主要为受断裂改造的背斜、断块及刺穿岩体遮挡圈闭。；气体成分主要有CO_2、N_2、CH_4、C_2H_6、He等。；主要气源体为岩浆气源体，气源体的主要地质形式为侵入体和埋藏的火山通道。；气藏和气源体的空间关系有岩浆侵入体一断裂一气藏沟通型、岩浆侵入体-CO_2气储集层接触型和埋藏火山通道-气储集层接触型三种类型。；岩浆侵入体CO_2气运移分为熔融运移阶段和结晶运移阶段，火山通道中CO_2气运移分成近地表喷发阶段和结晶运移阶段。；断裂中，CO_2在水中的浮力远大于运移阻力，CO_2气容易上浮，CO_2在断裂中的易浮性导致不同密度气体的分异和走向上封闭的断裂气体相对富集。；气体在砂岩储集层运移聚集具有选择性，会优先进入孔隙度和渗透率较高的砂岩，随着压力增加，才会进入孔隙度和渗透率较低的砂岩；在岩浆气源体-断裂-储集层空间输导格架下，CO_2气在膨胀力的驱动下，首先进入含水的断裂并重力分异而聚集，气体压力会不断增高，当压力增至一定程度，CO_2气会向高孔隙度、渗透率的储集层运移并聚集。；在岩浆气源体-储集层接触空间输导格架下，CO_2气受膨胀力的驱动直接向储集层运移并聚集。；成藏的CO_2气会经历化学沉淀、溶解、扩散和机械破坏四种破坏方式，会受断裂切割而打破压力平衡，沿断裂进一步运移和聚集成藏。

In this thesis, the influence of column force, joint hoop reinforcement, and repeat load on the stress and sheer bearing capability of inclined pressure bar is analyzed utilizing finite element software. In the case study, the column axial force's influence on the inclined pressure bar's equivalent width, stress and sheer bearing capability of RCFEN is obtained by changing the column force when modeling the RCFEN with ANSYS. In the former model, the joint hoop reinforcement influence on the equivalent width inclined pressure bar and the strength of RCFEN is achieved by changing the quantity of joint hoop reinforcement; the inclined pressure bar's equivalent width and the strength variation of RCFEN under cyclic load are gained by applying low frequency cyclic load on the inflection point of column and the middle of beam.

针对上述算例中的框架外节点采用ANSYS进行建模，运用有限元软件分析了柱轴力、节点箍筋、反复荷载对外节点斜压杆承载力、抗剪承载力的影响：改变柱轴力，研究了柱轴力对斜压杆的等效宽度、框架外节点斜压杆承载力、框架外节点斜压杆抗剪承载力的影响；在上述模型中，改变节点箍筋的数量，分析了节点箍筋对斜压杆的等效宽度、框架外节点强度的影响；在上述模型中，在柱反弯点和梁中点均进行低周反复加载，讨论了在反复荷载作用下，框架外节点的斜压杆的等效宽度、框架外节点强度的变化情况。

The results of pressure drop characteristics experiments indicate that the new type cyclone tube's pressure drop reduction extent is directly related to the sticks'number, length and the radial position of the straight stick pressure drop reduction frame; is directly related to the length, width and number of grid pressure drop reduction frame installed under the split flow core tube.

安装在排气芯管内的直杆减阻框、栅格减阻框使旋风管的压降有不同程度的降低，减阻幅度与直杆减阻框杆数和长度成正比；与直杆的径向位置大小成反比；与安装位置、绕流截面形状有一定的关系；并与栅格减阻框的长度、宽度和片数成反比。

Sixth, followed by release of the cylinder high-pressure injector tubing connector on the nut, the governor of diesel engine running under the handle position, rotation of diesel engine, the high-pressure pipeline from the air (this step can be ignored under normal circumstances, when the start failure should not be ignored).

第六，依次松开各缸喷油器上的高压油管接头螺母，将调速器手柄置于柴油机运行位置，转动柴油机，排出各高压油管内的空气（此步骤一般情况下可以忽略，当启动失败时不应忽略）。

The shear layer vortices dominate in the initial portion of the jet, which are a result of the K-H instability. The crossflow encounters an adverse pressure gradient ahead of the jet and separates to form horseshoe vortices under the pressure downstream, and they develop into the wake. The wake vorticity comes into being in the actions of an adverse pressure gradient and a wall-normal component of vorticity, which originates from the wall boundary and is entrained into the jet. The shear layer vortices encounter adverse pressure gradients in the lee of the jet and break down, leading to the formation of the CVP and the CVP is the most important characteristic of the jet in crossflow.

文中指出：剪切层涡源于射流与横流之间的K-H不稳定性；马蹄形涡的产生是由于射流喷口上游迎风侧的壁面边界层内存在逆压梯度，使流动发生了分离，在下游逆压梯度的挤压作用下，形成了马蹄形涡，马蹄形涡向下游发展，进入尾迹区；在逆压梯度和法向涡生成项的共同作用下产生了尾迹涡，尾迹涡源于壁面边界层，止于射流，并将部分涡量向上输运至射流内部的CVP；CVP是横向紊动射流的重要特征，剪切层涡破裂后，在逆压梯度的作用下CVP形成。

The shoe must be under the second stage pressure for a minimum of 12 seconds,under the correct pressure

在正确的压力下，压底时间应从第二个压底过程开始算起至少12秒

The simulated distribution of the volume fraction of vapor phase under different outlet pressure and the variation of the cavitation flow ratio indicate that the intensity of cavitation is varied with the outlet pressure of the jet pump when driving pressure and suction pressure are fixed.

模拟所得到的不同出口压力下的气相体积分数分布以及汽蚀流量比的变化表明：当射流泵工作压力与吸入压力固定时，射流泵出口压力越低，汽蚀流量比越小，同时流量比越接近汽蚀流量比，空化也越严重。

This article analyzes systematically the work process of fuel injection system in detail. It analyzes the fault fundamentals and its influence of three coupling parts in the high pressure oil road and the injection process, three coupling parts include plunger coupling parts, delivery valve coupling parts and needle valve coupling parts. It discusses the pulse situation of fuel pressure under the every kind of typical fault model, and regarding this as according to pick up the pulse signal of pressure from the high pressure pipeline, and process wavelet decomposition, picks up the of parameter fault, make use of the model identification technique, realizes to the intelligent diagnosis of fuel injection system fault.

文中系统地分析了燃油系统的工作过程，对高压油路中三偶件(柱塞偶件、出油阀偶件、针阀偶件)、喷油过程等的故障机理及其影响进行了分析，讨论了各种典型故障状态下的燃油压力波动情况，并以此为根据，从高压油管处提取压力波动信号，提取故障参数，利用模式识别技术，实现了对燃油系统故障的智能化诊断。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。