查询词典 under load

When evaporative cooling hydrogenerator ( generator/ motor) runs with a certain load, all bars of stator windings change under the same law : Temperature of bar increases arising from winding loss, and temperature of cooling medium in hollow conductor of bar is also increased through specific heat capacity, and it comes to boiling and is boiled away partially when temperature reaches a saturation that required by corresponding pressure.

当蒸发冷却水轮发电机以某一负载运行时，定子绕组所有线棒发生着同一规律的变化：铜损耗使线棒发热，线棒空心导体中的冷却介质通过比热容吸热使温度线性上升；当温度达到压力所对应的饱和温度时便以蒸发潜热吸热而部分沸腾汽化。

The residual stress in bent pile can be ignored. The curvature of batter pile has important influence on additional moment to bent pile under vertical load on top. When the radius of curvature on the upper segment of pile is small, the additional moment can not be ignored.

得到以下结论：桩体由于施打而发生的弯曲在桩体中产生的残余应力可以忽略不计；桩顶竖向荷载作用下桩身的弯矩同桩的偏斜曲线有重要关系，桩顶处的曲率较大时，桩身的弯矩在工程中是不能忽视的。

Ultimate capacity of cross-section is partly determined by stress value of unbonded tendon. The stress value is determined by state of net concrete beam that relative to unbonded tendon under prestress, ultimate load and restriction.

承载力极限状态的无粘结筋的应力值部分决定了构件截面的承载能力，而这个应力值的大小取决于相对于无粘结筋束的净混凝土梁在预加力、极限荷载及约束条件下的状态。

A method of the buckling critical load for laminated beam and laminated plate under Hamilton system is presented on this basis.

本文首先简单地介绍了一下混合状态方程的重要性和与之对应的Hamilton正则方程的构造方法。

This paper presented the mechanism of fretting fatigue failure that happened on the contact surfaces between sleeve and roll neck of oil-film bearing under the rolling load.

研究了油膜轴承锥套与辊颈接触表面在轧制载荷作用下发生微动疲劳损伤的力学机理。

Compared disturbed values of the thick tail metal bolt and common bolt under the load action.

比较了金属粗尾锚杆和普通锚杆在不同载荷作用下的挠度值。

In order to meet the demands of high load and high lift height of product development trend, under the precondition to minimize hoist boom weight, what kind of sectional shape shoul...

为满足产品向大起重量和高起升高度方向发展的需要，在尽可能降低起重臂重量的前提下，采用何种截面形式，才能将失稳减小到满足设计要求的最小程度，是设计者要解决的重要问题。

In order to meet the demands of high load and high lift height of product development trend, under the precondition to minimize hoist boom weight, what kind of sectional shape should be adopted to minimize the instability, is a critical problem the designer should solve.

为满足产品向大起重量和高起升高度方向发展的需要，在尽可能降低起重臂重量的前提下，采用何种截面形式，才能将失稳减小到满足设计要求的最小程度，是设计者要解决的重要问题。

The heart of the world is breaking under this load of pride and pretense.

世人的心都被驕傲和虛偽的擔子壓傷了。

With basis in today's output ratings of large rectifier, some future trends are mentioned and the resulting consequences for the associated fuses are discussed The conditions under which large size 5 fuses are tested are explained in respect to load ability and breaking capacity of the fuse itself and further it is explained how coordination tests with power semiconductors can be conducted.

在大型整流器今天的输出额定值基础上，探讨了未来的某些趋势，讨论了同熔断器有关联的相应结果。解释了对大规格的5#熔断器进行测试的条件同该熔断器自身的负载能力及分断能力的关系，进而说明该熔断器同功率半导体器件的协同测试应该如何进行。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。