查询词典 under load

Fist, mode analysis is accomplished, and stiffness influence of the structure by the member parameter and the accessional columns are analysed. Then the numerical value of the pulsoting wind load was used, the time history contrastable analysis between mega-sub controlled structure and general megaframe structure has been accomplished. Finaly, the influence of vibration-controlled efficiency under the different member parameter of vibration-absorption megaframe structure is analysed.

首先进行了模态分析，讨论了钢筋混凝土巨—子型控制结构的主要结构参数及附加柱刚度对结构整体刚度的影响：利用脉动风荷载计算机模拟的荷载值，并对它和一般的巨型框架结构进行了脉动风荷载下的时程对比分析，讨论了钢筋混凝土巨—子型控制结构的主要结构参数对减振效果的影响，研究了钢筋混凝土巨—子型控制结构的动力特性。

Then the running characteristics of the system were tested under different load working conditions. And the energy-saving performance was contrastively analyzed between the closed-circuit system and the valve-controlled system and so on.

试验研究了在不同负载工况下电梯轿厢的速度运行性能，并对比分析了该系统与阀控等系统的节能性能。

The load-displacement plot was measured and analyzed at elbow flexion of 90, 60, and 45° and under four conditions (intact elbow, type-I coronoid process fracture, type-I coronoid process fracture with AMCL deficient, and type-II coronoid process fractures with AMCL deficient).

N单轴压缩实验，分别在屈肘 90、60 和 45°测量标本在下列情况下的负荷-位移曲线：①完整肘关节；②Ⅰ型冠突骨折后肘关节；③Ⅰ型冠突骨折合并 AMCL 损伤后肘关节；④Ⅱ型冠突骨折合并 AMCL 损伤后的肘关节。？

The results were found as following:(1) The damage value increases more significantly with the increase in PVF before 30% PVF, beyond which the increasing trend becomes gradually gentle.(2)Keeping the interphase strength and PVF unchanged, the damage increase with increasing moisture concentration in a nearly linear relation.(3)The results generated from the FCC model with consideration of the interphase debonding are in good agreement with the experimental data, meanwhile, the FCC model is also capable of predicting the critical load for the damaged and the undamaged dental composite subject too the 3-point flexural test.4 A 3D-fmite element analysis has been successfully exploited to examine the mechanical behavior of the restoration-tooth structure under the polymerization shrinkage and water sorption. It was found:(1) The low stiffness of the composite has the effect to limit the displacement occurring in the remaining tooth tissue. For lower interphase, the cuspal flexures are litter higher. The high interphase modulus acts as a \'shielding effect\' for stress transfer.

得到如下结论：(1)相同的吸湿性，在30％PVF(颗粒体积分数：Particle volume fraction，PVF)前增加PVF，层间脱胶损伤值显著增加；此后损伤值的增加趋于平缓；(2)保持层间强度和PVF不变，层间脱胶损伤随吸湿率的增加而接近线性增加；(3)FCC(面心立方：Face-centred cubic，FCC)模型层间脱胶损伤的预测结果和实验数据基本吻合；同时此模型可以用于预测牙齿填充材料三点弯曲实验的临界载荷。4、建立理想牙齿修复结构，利用有限元方法研究了同时考虑聚合收缩和吸湿膨胀耦合作用下的填充修复材料和粘结界面层材料性能对牙齿修复结构的力学行为的影响，得到如下结论：(1)低弹性模量的牙齿填充修复材料能限制天然牙组织的位移，但天然牙组织的位移与粘结界面层的弹性模量无关。

And the frontal technique is adapted to solve the FE equations. The techniques are studied to deal with the large slip frictional contactproblems between a deflectable body with large deformation and a rigid bodywith flat or curved surface. A new algorithm is presented to resolve such contactproblems, including incremental displacement constraints and force constraints,and the modules are programmed. The performances of tire under static load invertical loading state and camber state are analyzed by this method. And theexperiments were carried out at the same condition as used in analysis process.

研究了大变形柔性体与具有平面及曲面外形刚性体之间的大滑动摩擦接触问题，提出了求解这类接触问题的位移增量约束和主动力增量约束处理方法；编制了大变形柔性体与具有平面及曲面外形刚性体之间的大滑动摩擦接触问题求解模块；利用本文提出的大滑移接触问题处理方法，分析了轮胎在径向静载和静态外倾加载条件下受力和变形，并对部分分析结果进行了试验验证，验证结果表明，本文提出的位移增量约束和主动力增量约束处理接触问题的方法是正确可靠的，而且具有精度高、收敛性好、收敛速度快的优点。

Numerical experimental results showed that the perimeter air deflectable deposited burner could ensure the flame stability to satisfy combustion requirements under low load and can prevent spout fire carrying, low concentration of particle matters around the water-wall ensures the water-wall to be in oxidation atmosphere to solve problems of high temperature erosion and slagging, and particle matters separated from main spray caused by deflectable deposited perimeter air plays a significant role in low NO combustion control.

数值试验结果表明，偏置周界风燃烧器在保证煤粉气流着火稳定性以满足低负荷燃烧要求的同时，具备较强的防止喷口带火能力；炉内水冷壁附近颗粒物质量分数相对较小，从而能保证较高的氧化性氛围以解决水冷壁高温腐蚀、结渣等问题；偏置周界风所引起的炉内气固两相偏析在低NO燃烧控制方面具有重要意义。

The transient dynamic analysis model of rigid pavement under falling weight deflectometer load was established by utilizing ANSYS for the concrete slabs on Kelvin foundation.

对于Kelvin地基上的混凝土板，利用有限元软件ANSYS，建立了落锤式弯沉仪荷载作用下刚性路面的瞬态动力分析模型。

Madenci and Westmann analyzed the propagation problem of local delaminate in the laminated structure under compressive load.

Madenci和Westmann分析了层状体系内局部脱层在压缩载荷作用下扩展问题。

With this fracture model, some important results are obtained for composite thin-walled circular tubes under axial compression; the calculation of the critical delaminate load is gained based on the linear elastic analysis As for the dynamic loading, this delaminated model modified in depth by introducing a dynamic factor will be helpful.

利用该模型本文得到一些重要的结论，并给出压缩载荷临界判据。利用该模型研究复合材料圆管的轴向压缩承载行为，为后继动力轴向压缩问题的研究奠定基础。

In this paper, the load-displacement and skeleton curve of dendriform connections to the concrete filled square steel rectangular tubes under low-cycle reversed loading was calculated by fiber line element model, which is based on the relation of the stress-strain of steel and concrete and is compared with the FE and experiment.

本文在确定了往复应力作用下钢管混凝土的钢材和核心混凝土的应力－应变关系的基础上，利用纤维杆元模型，有限元模型对钢管混凝土Y形柱和十字形钢梁连接的节点的荷载－位移滞回关系曲线及其骨架曲线进行了计算，并与试验结果进行了比较。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。