查询词典 under load

Simulation in the discussion, respectively, from the rated load, and the empty set three conditions for the system simulation, obtained under the three conditions in response to step through the analysis of the curve, the load that the impact of changes in the system And to improve the system.

在仿真讨论中，分别取额定负载、空载和过载三种情况对系统进行仿真，得出其在三种情况下的阶跃响应，通过对曲线的分析，得出负载的变化对系统的影响，并以此对系统进行了改进。

Under static load, and the impact of lower load mode or hot extrusion press forging die.

此钢系高强度热作模具钢，可用于制造工作温度≥550℃并承受较高的静载荷，而冲击载荷较低的锻造压力机模或热挤压模具。

A loading cycle consisting of a haversine load followed by a rest period was adopted to simulate the actual vehicle loading on asphalt pavement, and a viscoelastic-damage mechanics model was deduced for permanent deformation of asphalt mixture under repeated load.

再采用半正矢波间歇荷载模拟实际路面轮载作用，推导了重复荷载作用下沥青混合料永久变形的弹黏塑性损伤力学模型。

Assumed resisting power method of load-structure model is used tocalculate hemicycle lining under bias load.

指出偏压荷载作用下的隧道衬砌内力计算可以采用基于假定抗力法的荷载结构模型进行计算。

The influence of indentor radius on the plastic deformation has been discussed and some important results are as follows:(1) The influence of the ratio of ceramic coating thickness to indentor radius on the failure of coating, plastic deformation of substrate and crack propagation are obvious.(2)The propagation of crack in ceramic coating is assumes to be of semi-elliptical shape under normal contact with a rigid sphere.(3)Fatigue life of ceramic coating is mainly decided by substrate and load, the lower substrate elastic moduli and load, the more cycles of fatigue.

分析了压头半径对塑性变形的影响，模拟结果表明；(1)陶瓷涂层厚度和压头半径之比对涂层失效、基体塑性变形及裂纹的形成有显著影响；(2)在刚性球压头静态挤压条件下，陶瓷涂层中的预制裂纹按照椭圆形裂纹规律扩展；(3)陶瓷涂层的疲劳寿命与基体和载荷有很大关系，基体弹性模量越小，疲劳寿命延长。

In creep buckling question,by means of theoretical analysis,the instaneous critical load and durable critical load of viscoelastic braid composite cylindrical shell under axial compression are obtained and the numerical example is given.

对蠕变屈曲问题，通过理论分析来得到了编织复合材料圆柱壳的瞬时弹性临界载荷和持久临界载荷，给出了具体的算例。

A new calculation method was proposed to predict the ultimate load capacity of the reinforced concrete slabs under the compressive membrane effect based on its loading mechanism and the geometrical conditions at ultimate state with the lateral restraint load as intermediate variable.

基于钢筋混凝土板的压力膜效应受力机理及极限状态下的几何条件，以侧向约束力为中间参数，提出了一种压力膜效应的极限承载力计算方法。

The study on the interruptible load management and other load management emphasizes the study on executive strategies under deregulation.

可中断负荷管理和间接负荷管理的研究着重在市场环境下资源获取的实施策略研究。

Numerical results obtained by inverse Laplace transformation were used to discuss the difference of the dynamic responses of shell under different response modes by respectively applying axial symmetry load and fluid load.

最后利用Laplace数值逆变换得到时间域中的数值结果，讨论了在球壳内作用有轴对称荷载和流体压力两种情况时不同响应模式条件下球壳动力响应。

2TheMax GPX750 PSU for the desktop computer features total output of 750W, rated supply voltage of 115V to 230V auto range, rated mains frequency of 47 to 63 Hz, rated input of 115V at 10A or 230V at 5A, efficiency of 85% minimum at typical load, holdup time of 16.6ms at nominal line under full load condition, power good signal between 100ms to 500ms, over current protection at 110% to 150% individual output power, over voltage protection for +5V is between 5.8V to 6.3V,+12V from 14V to 17V, 3.3V from 3.6V to 4.2V, air flow by DC fan, operating temperature of 0°C to 50°C and operating humidity of 20% to 90% non-condensing.

2themax gpx750电源为桌上型电脑的功能总产量750瓦特，额定电源电压115v到230v汽车范围，额定工频47至63赫兹，额定输入的115v在10 A条或230v在5 ，效率85 ％，最低在典型负载，持的时间16.6ms的名义在网上下，满负荷条件下，电源良好信号之间的100 ms到500ms ，过电流保护在110 ％至150 ％个别的输出功率，过电压保护，为5 V是之间的5.8 V至6.3v ，+12 V的从14v至17v ，电压为3.3 V从V到3.6 V至4.2 V ，空气流量由直流风扇，操作温度0° C到50 ° C和运作中的湿度为20 ％至90 ％，非冷凝。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。