查询词典 under control

Article 51 If any director, supervisor, senior manager, employee of a listed company or any legal person or any other organization under the control or entrustment of the listed company intends to take over the listed company or to obtain the controlling right to the listed company by the means prescribed in Chapter V of these Measures (hereinafter referred to as the management buy-out), the listed company shall have a healthy and well-operated organizational structure and an effective internal control system, and have 1/2 or more independent directors in its board of directors are independent directors.

第五十一条上市公司董事、监事、高级管理人员、员工或者其所控制或者委托的法人或者其他组织，拟对本公司进行收购或者通过本办法第五章规定的方式取得本公司控制权的，该上市公司应当具备健全且运行良好的组织机构以及有效的内部控制制度，公司董事会成员中独立董事的比例应当达到或者超过1/2。

The author also analyzed the difference of soil moisture between furrow and ridge, inside and outside of film, wide and narrow furrow under water control condition, put forward the index of soil moisture for postponed irrigation of maize, expounded the influence of water control in later stage on products and soil moisture of monoculture Maize.

在控水条件下，分析了垄背与垄沟、膜内与膜外、宽沟与窄沟的土壤水分差异，提出了玉米推迟灌头水的土壤水分指标，并阐述了后期控水对单种玉米产量及土壤水分的影响。

The method to configure RED parameters based on network properties is also presented. Simulations show that the modified Random Early Detection algorithm really performs better than the original Random Early Detection algorithm and can work for a much wider range of traffic. Finally, whether the assured service mechanisms i. e. an edge router tags every arriving packet of a TCP flow based service profile and core router drops packets differently at congestion using active queue management scheme is possible to provide a throughput consistent with target rate, is investigated under different network scenarios. Different factors including target rate tagged algorithm, RIO algorithm and TCP congestion control mechanism how to affect the throughput of an assured service TCP flow are examined. Based on a fluid model. we then derive a model of an assured service TCP flow, which is the function of round trip delay, packet loss rate and token bucket parameters. Based on this model, we observe that in some cases it is possible to regulate the token bucket parameters to gain a consistent throughput with the target rate, while in other cases there exist ranges of values of the achieved rate for which the token parameters have no influence. With the latter, some modified TCP congestion control mechanisms to assure TCP throughput are proposed.

最后，在区别服务网络结构内，研究了当前提出的一种边缘路由器根据服务合同标记、分类数据包，结合内部路由器采用主动队列缓冲管理机制区别处理数据包的确信服务机制是否可在不同网络情况下使TCP连接获得同目标速率相一致的、公平的吞吐量问题；指出影响TCP连接获得同目标速率相一致吞吐量的主要因素是目标速率大小、标记算法参数和TCP连接的拥塞控制算法；对此，基于流模型假设，首次推导出一个以端到端时延、数据包丢失率、漏桶参数为变量的确信服务TCP连接吞吐量模型；利用这个模型进行分析，得到主要结论是在一些情况下可通过设置合适的漏桶参数得到同目标速率更一致的吞吐量，而在另一些网络情况下不管如何设置漏桶参数都不能使TCP连接获得同目标速率一致的吞叶量；对于后一些情况，还初步讨论了改进TCP拥塞控制算法来改善TCP连接性能的方法。

Theoretical and experiment researches of transmission mechanism and control strategy of the CVT have been carried out under the project (59835160) financed by National Natural Science Foundation which includes follow content:1The kinematic relation of the metal pushing V-belt type transmission is analyzed. The relation among oil pressure of pulley cylinder, transmission ratio and input torque under load condition is studied. Optimal design method for metal pushing V-belt type continuously variable transmission is put forward.2Based on the engine experiment, torque and oil consumption model of engine are established by method of spline interpolation. The optimum economy and performance curves are put forward.

本文在国家自然科学基金重点项目（资助号：59835160）资助下，对金属带式无级变速传动系统的传动机理、匹配及控制策略等进行了系统深入的理论分析和实验研究，具体研究内容如下：1）系统地分析了金属带无级变速传动的基本运动规律，研究了在负载状态下，带轮油缸压力与速比和输入转矩的关系，提出了对金属带式无级变速传动系统进行优化设计的方法。2）通过发动机台架试验，利用样条插值方法构造了发动机转矩和发动机油耗模型，确定了发动机最佳经济性与最佳动力性工作线。

This design main be how average type beam drill electricity charge circuit be in progress design, main content include host circuit design, control circuit design, instruction circuit design and under the control of component choice, not bad come true Z3050 type beam drill starting, stop, be rotating, roll back and a few corresponding protection function.

本设计主要是多普通型摇臂钻床的电控线路进行设计，主要内容包括主电路的设计、控制电路的设计、指示电路的设计和控制元器件的选择，可以实现Z3050型摇臂钻床的启动、停止、正转、反转以及一些相应的保护功能。

For example, the general system loop for a steam autoclave under computer control could consist of temperature/pressure sensors connected to a microprocessor that transmits commands to steam/vacuum control valves.

例如，计算机控制下的一个蒸汽高压灭菌器的通常的系统环路由连接到微处理器的温度/压力传感器组成，这个微处理器发送控制命令到蒸汽/真空控制阀。

In this paper, we proved that there exists only one contact point between a pair of non-circular gears working under the designed pitch curves when they are manufactured by involute cylindrical gear cutter in numeric control slotting machine. Under this manufacturing condition, the pair of non-circular gears can mesh accurately.

证明了采用渐开线圆柱齿轮刀具在数控插齿机上加工的1对非圆齿轮副传动时，在其按设计的已知节曲线工作时，两非圆齿轮副的齿廓具有单一的接触点，即能保证正确的啮合关系，为深入分析非圆齿轮副的传动机理提供了前提。

In view of the uncertain load disturbances and parameter variations and so on, the disturbance restraint performance of the six-phase synchronism motor control system for the ship electric propulsion is improved under the robust control theory.

在船舶的空间运动模型和螺旋桨四象云母加热圈限模型的基础上，综合考虑船舶和螺旋桨地相互作用，建立了船桨一体化的运动模型，并结合六相同步电功机控制系统仿真研究船舶电力推进六相同步电动机控制系统典型工况下的运行性能。

The company is under the jurisdiction of 843 state-run factories of Industry Corporation of weapons (the Qin chuan of the North of Xi'an now ), have cooperated with unit experts and technical staff such as Zhejiang University , Tsing-Hua University , Xi'an Communications University ,etc. for many years, in absorb , digest Company and AG reaction of Company , BBC of Germany , heat power at the technological foundation, develop , help integrated circuit control and digital control circuit brilliant floodgate in charge of the power of intermediate frequency, apply various smelting , being completely hot , quenching metal to , return bend and reaction heat field of brazing, make reaction heating technology of our company in in a leading position competence at home.

公司隶属于兵器工业总公司国营843厂（现为西安北方秦川有限公司），多年来同浙江大学、清华大学、西安交通大学等单位的专家及技术人员合作，在吸收消化德国BBC公司与AG公司的感应加热电源技术基础上，研制成全集成电路控制及数字控制线路晶闸管中频电源，应用于各种金属的熔炼、透热、淬火、弯管及感应加热钎焊领域，使我公司的感应加热技术在国内处于领先水平。

This article designs is one kind under the monolithic integrated circuit 89C51 control the infrared remote control servo vehicle, after the server is passes through the special re-equipping server.

本文设计的是一种在单片机89C51控制下红外遥控伺服车，伺服机是经过特殊改装后的伺服机。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。