查询词典 under arms

Under the Commonwealth, John Biddle was prominent as an upholder of Socinian principles; Cromwell banished him to the Scilly Isles, but he returned under a writ of habeas corpus and became minister of an Independent church in London.

根据英联邦，约翰比德尔是著名的维护者的Socinian原则；克伦威尔流放他到锡利群岛，但他下返回人身保护令状部长，并成为独立的教会在伦敦。

Based on the load transmission mechanism of space truss, and referenced theanalysis of test materials, a formula for calculating the bearing capacity of reinforcedconcrete compression strut is introduced. By using the theory of plastic hinge-line, anupper limit solution of bent bearing capacity for four-pile cap, which coincidesprecisely with the practical measurements, is obtained. By utilizing the reaction ofthe soil under cap and by basing on the method of plastic ultimate analysis, an upperlimit solution of punching shear bearing capacity for pile cap is acquired, which. coincides precisely with the practical measurements, and the formula is similar to thecode.A brief discuss on cooperative work of strip beam of foundation and single rankof piles is made. Separately considering the pile-cap and the pile-group, thencoupling their matrix of rigidity, the inner force of pile-cap is solved by the numericalmethod under some reasonable supposition. In comparison with other method, thecalculating results are exact, reliable and convenient in using. The method provides apowerful tQol fOr further analysis and research on this kind of structure.

本文以空间桁架传力机理为基础，结合试验资料分析，推导了钢筋混凝土等边三桩承台受冲切承载力计算公式；根据塑性铰线理论，导得了与试验结果吻合良好的四桩承台受弯承载力的上限解；利用承台底土反力分布，根据塑性极限分析方法，导得了桩基承台受冲切承载力的上限解，在此基础上，通过简化假定，得到与规范公式相类似的承台受冲切承载力实用公式，该公式能方便考虑台底土反力作用，与试验结果的吻合程度比规范公式好；简要讨论了桩基条形承台梁与单排桩的协同工作分析；在一些合理假定的基础上，将承台与群桩分开考虑，分别得到其刚度矩阵后进行耦合，通过数值方法求解承台内力，算例表明，该方法结果准确，使用方便，为该类结构的进一步分析研究及工程设计提供了强有力的工具。

Through lots of tests, the new technology of preparing the polymeric ferric aluminum silicate sulfate by using the waste-acid of Ti02-industriy and the coal fly ash has been designed. The highest Al-acid stripping rate can be achieved by the waste sulfate acid under boiling degree for 1. 5h when the mass ratio between NaCl and Coal Fly ash is 0. 05:1, as well as that between Coal Fly ash and Waste Acid ratio is 1:10. By means of the oxidation-polymerized reaction under 40-50*C and normal pressure, using NaNCkas catalyst and air as oxidation, the polymeric ferric aluminum sulfate can be obtained. The poly-silicic acid is polymerized with soluble glass in the optimum conditions of pH=5-6 and the concentration of Si02 is about 3%. The inorganic high molecule coagulant of PFASS is synthesized with the poly-silicic acid into the solution of polymeric ferric aluminum sulfate.

本论文通过大量的试验，研究开发出了用粉煤灰及钛白废酸制取聚合硫酸硅酸铁铝的新工艺，其最佳工艺条件为：于沸点温度，以NaCl为助溶剂(NaCl与粉煤灰质量比为0.05：1)，以钛白废酸浸取粉煤灰(固液比为1：10)中的铝1.5小时，最大浸取率可达40％；经过滤洗涤后，调节滤液pH至2.0左右，以NANO_2为催化剂(NaNO_2用量为滤液中FeSO_4·7H_2O量的3％)，空气为氧化剂，于40-50℃进行常压催化氧化反应，制取聚合硫酸铁铝，催化氧化时间为2小时；将工业水玻璃稀释至3％左右，调节其pH于5-6，室温下制备活性聚硅酸；将活性聚硅酸与聚合硫酸铁铝按照一定比例复合，经熟化，即制得新型无机高分子混凝剂PFASS。

This selection strongly inhibits the growth of arg-13 under stringent sorbose/glucose condition but allows arg-13 to grow under spot test conditions.

此法在严紧山梨糖/葡萄糖条件下能强烈抑制arg-13突变株生长，但在斑点试验条件下允许arg-13突变株生长。

The results showed that 3% to 5% propionic acid solution had better preservative action by soaking the sorosis for three minutes under normal atmospheric temperature;and 0.5% propionic acid,potassium sorbic acid and sodium benzoic acid solution all had better preservative action under low temperature of 5℃ to 8℃.

结果表明，在常温下，3～ 5 %的丙酸溶液浸果 3 min具有较好的防腐作用；在 5～ 8℃的低温条件下，0 。5 %浓度的丙酸、山梨酸钾和苯甲酸钠浸果 2 min均能达到较好的防腐效果。

Pollen morphology of six species were similar, all trisected circular shape in polar view, tricolporate. Observed under LM the ornamentation of exine is granular with spinules arranged sparsely and under SEM the basal part of spinule extend.

六种沙蒿的花粉较为相似，极面观均为三裂圆形，三孔沟，孔横长，外壁纹饰在光镜下表面颗粒状，在电镜下为排列较疏的刺，刺基外延。

It is pointed out that under the condition of the temperature of 1120℃, the reaction time of 16 mm and the carbon content of 27%, the metal transformation rate of sponge iron used for general metallurgy is up to 90%. But the optimal carbon content is 29% for iron sponge to treat DSD acid oxidation wastewater. Under condition of the wastewater's pH value of 3 to 5 and the reaction time of 40min, the removal rates of COD and color are 68% and 90%, respectively. The BOD/COD ratio is up to 0.425 when DSD oxidation acid water is treated with sponge iron.

研究表明：在配碳量27%、反应温度1160℃、反应时间16min的情况下，以铁泥为原料制备的常规海绵铁的金属化率可达90%以上；用于处理DSD酸氧化废水的海绵铁适宜配碳量为29%，用制备出的海绵铁处理DSD酸氧化废水，在pH值3~5、反应时间40min时，出水的COD去除率可达68%、色度的去除率达90%、可生化性指标BOD/COD提高到0.425。

The results showed that, under P sufficient conditions, 2 QTL were identified for SPUE on chromosome 1B and 5A, respectively; 3 QTL were detected on chromosome 2B, 5A and 7A, respectively, influencing WPUE. Under P deficient conditions, 3 QTL on chromosome 2D, 3B, and 6D were detected for SPUE, and 2 QTL on chromosome 2D and 7A for WPUE.

结果表明，正常供磷，有2个与SPUE有关的QTL，分别位於染色体1B和5A上，变异解释分别为6.55%和11.61%；与WPUE有关的QTL有位於染色体2B、5A和7A上的3个；SPUE和WPUE还分别受一对互作位点的影响。

Pass to count to Wisterch parameter , and the steel wire is different from the molding tool get in touch with the length, and settle the path the research taking the length work the stabber angle to get under differently pull to stir the term, mold core adoption of best severally why size, combine the best work stabber of research the Cape, and settle the path to take the length nextly steel wire is in the molding tool of have fever to measure, air inside dispel-heat calories, winding dispel-heat on the coil-canister , and its molding tool dispel-heat calories of, and cause the steel wire the temperature difference pass in and outing the molding tool to influence steel wire machine function, under the experiment inside pull to stir the term according to the same race different work stabber Cape half of adoption the Cape(7 degree,10 degree,12 degrees, the best mold Cape, experience mold Cape) settle the path to take the length(2-3 mm,3-4 mm,4-5 mms, theories length, experience length) to proceed to experiment, and get the conclusion, work stabber the Cape then is more big the steel wire get in touch with the length with

通过对Wisterch参数，钢丝与模具接触长度、定径带长度、工作锥角度的研究得到了在不同拉拨条件下模芯采用的最佳几何尺寸，并研究最佳工作锥角、定径带长度下钢丝在模具中的发热量、空气中散热量、卷筒上的散热量及其模具散热量的不同，导致钢丝进出模具的温度差别对钢丝机械性能的影响，在实验中根据同种拉拨条件下采用不同工作锥角半角、定径带长度进行试验，得出结论，工作锥角越大则钢丝与模具接触长度越短，钢丝变形越剧烈，在模具中发热量就越高，导致钢丝出模温度高，使钢丝强度、硬度升高，弯曲、扭转次数降低，并且降低模具使用寿命。在其它条件相同的情况下，定径带越长则钢丝与定径带简壁磨擦增大，使钢丝发热量加大，从而使钢丝强度、硬度略升高，弯曲扭转次数略降低但定径带的增大减小了钢丝变形产生的弹性后效使钢丝出模直径比较稳定。

In recent months has been broken for the trifling matter of trivial in the busy, busy the weekend it was to sit under the bodhi tree Sunday to take a stand no chance, not today, under the bodhi tree ...

近月来一直在为琐琐碎碎的事在忙，忙得把那原本要在週末週日到菩提树下坐一坐的机会都沒有，今天不在菩提树下。。。

A small, rubber-headed hammer used in examination or diagnosis by percussion.

叩诊槌用在通过''。'振荡'。''所作的检查或诊断中的橡皮头的''。'小'。''槌

Affixes are limited in number in a language, and are generally classified into three subtypes, namely, prefix, suffix, and infix, depending on their position with reference to the root or stem of the word.

语言中词缀的数量总是有限的，根据它们跟词根或词干的相对位置，一般可以把词缀分外三小类：前缀，后缀和中缀。