查询词典 two-component

Professional Main Products are:(1) all kinds of electric locks Product Series: electromagnetic lock series, electric plug lock series, electric locking series lock series, hotel lock series, all kinds of special-shaped electric lock series;(2) sizes Intelligent Access Management Series: Single door machine, access control attendance machine, fingerprint access control machine, single-door two-way controller, two two-way controller, four one-way controller (communication mode may choose 485 or TCP / IP);(3) access control electric locks surrounding attachment Series: electric plug lock folder dedicated Frameless door, magnetic lock dedicated stent, the models go out button, a dedicated lock access control power supply, various types of access control card , EMID reader / issuer, and intercom access control system, a dedicated power lock delay.

专业主营产品有：（1）各式电锁产品系列：电磁锁系列、电插锁系列、电锁口系列、指纹锁系列、酒店锁系列、各式异形电锁系列；（2）大中小型智能门禁管理系列：单门一体机、门禁考勤机、指纹门禁一体机、单门双向控制器、两门双向控制器、四门单向控制器、（通讯模式均可选择485或TCP/IP）；（3）门禁电锁周边附件系列：电插锁专用无框门夹、磁力锁专用支架、各款式出门按钮、门禁专用锁电源、各类型的门禁感应卡、EMID读卡器/发卡器、对讲门禁系统锁延时专用电源。

In the second part of of this thesis, we firstly derivate the operation condition of intracavity SHG of dualwavelength laser from the rate equation, and then numerically calculate the relationship between the laser operation parpmeters and the pumping powers. And then we discuss two possible ways to get balancing outputs of the harmonic waves of the two wavelengths. By comparing the two ways, we find that the method by increasing the geometrical factor of 1079. 5nm SHG has the higher efficiency than the method by adding the additional loss of 1079. 5nm basic wave. Besides, the first method is easier to realize in experiment than the second method.

本论文第二部分从速率方程出发，通过求解速率方程的稳态解得到了Nd：YAP腔内倍频双波长激光的连续运转条件，数值计算得到了随泵浦功率变化的激光运转情况；计算、分析了通过增加主波长的倍频耦合几何因子和增加主波长的腔内损耗两种方法获得均衡的双波长倍频输出的运转情况，通过二者的比较，发现增加倍频耦合几何因子的方法比增加损耗的方法效率更高，而且在实验上更易于实现。

However, as the Sun bak'd these Two, very dry and hard, I lifted them very gently up, and set them down again in two great Wicker-Baskets which I had made on purpose for them, that they might not break, and as between the Pot and the Basket there was a little room to spare, I stuff'd it full of the Rice and Barley Straw, and these two Pots being to stand always dry, I thought would hold my dry Corn, and perhaps the Meal, when the Corn was bruised.

无奈之中，只得用一把腰刀来改做；这种腰刀是我从船上的武器舱中取出来的。好在第一次收成不多，所以割起来也没多大困难。而且，我收割的方法也非常独特：只割下麦穗或稻穗，把茎干留下来。我把穗子装进自制的大筐子里搬回家，再用双手把谷粒搓下来。收获完毕后，我发现原来的半斗种子差不多打了两斗稻和两斗半多的大麦。这当然只是我估计估计罢了，因为当时手头根本就没有量具。

Butt Weld and docking and corner combinations Weld, in Weld ends located arc plate and extraction plate in igniting board then leads to the welding seam, joint halfway shall weld joints in front of 2.0 mm Department Firing arc, welding pieces after preheating rod will return to weld the origin, pool filled to the required thickness, before forward welding; Welding speed : Isokinetic welding requirements to ensure weld thickness, width uniform, which masks to look for hot metal and slag bath equidistance (2-3 mm)%; Arc welding rod length : different models and determined that the general requirements of arc length is stable, acid electrode generally 3-4 mm, 2-3 mm normally alkaline electrode%; Welding perspective : According to determine the thickness of two pieces of welding, welding angle has two aspects : First, the angle between the direction of the rod and welding of 60-75 ; The second is the angle between two electrodes and welding around, the same thickness as welding, welding and welding pieces incident angle of 45 ; When the thickness ranging from welding, welding electrode and thick and thin pieces of welding electrode side angle greater than the angle between the side pieces; Arc : admission to the end of each weld should be filled crater, in the direction opposite to the direction of the back-arc welding, arc welding unchanged inside pit in 1974, to prevent the crater bite of meat.

对接焊缝及对接和角接组合焊缝，在焊缝两端设引弧板和引出板，必须在引弧板上引出后再焊到焊缝区，中途接头则应在焊缝接头前方15～20㎜处打火引弧，将焊件预热后再将焊条退回到焊缝起始处，把熔池填满到要求的厚度后，方可向前施焊；焊接速度：要求等速焊接，保证焊缝厚度、宽度均匀一致，从面罩内看熔池中铁水与熔渣保持等距离（2～3㎜）为宜；焊接电弧长度：根据焊条型号不同而确定，一般要求电弧长度稳定不变，酸性焊条一般为3～4㎜，碱性焊条一般为2～3㎜为宜；焊接角度：根据两焊件的厚度确定，焊接角度有两个方面，一是焊条与焊接前进方向的夹角为60～75 ；二是焊条与焊接左右夹角有两种情况，当焊件厚度相等时，焊件与焊件夹角为45 ；当焊件厚度不等时，焊条与较厚焊件一侧夹角应大于焊条与薄焊件一侧夹角；收弧：每条焊缝焊到末尾，应将弧坑填满后，往焊接方向相反的方向带弧，使弧坑甩在焊道貌岸然里边，以防弧坑咬肉。

The film is a true story that occurred in Hollywood in 1997 along the northern bank robbery, two robbers took the AK-47 bullet-proof vests, and their only holding a pistol against the police (special forces have not arrived) So a fierce gun battle began, many police officers and the public were injured, fortunately, although 20 were shot, but no police or civilian deaths, the only two deaths that the two culprits .

本片是一个真实故事，那是1997年发生在好莱坞北部一起银行抢劫案，两个匪徒拿着AK-47 穿着防弹衣，而和他们对抗的警察只拿着手枪，于是一场激烈的枪战开始了，很多警察和市民都受了伤，幸运的是，虽然有20人中弹，但是没有一个警察或平民死亡，唯一的两个死亡的就是那两个匪徒。

Inthis paper, a new method is presented, in which we measure the thickness ofsurface film layer by means of measuring the distance between correspondingtwo dark lines in two groups of white light interference fringes that are res-Pectively produced by two beam reflected by two surface of the thin filmlayer and another beam coming from another arm in Michelson interferome-t...

本文提出一种新方法，它利用迈克耳逊干涉光路，通过对膜层前后两表面反射光束和来自另一臂的反射光束产生的两组白光干涉纹黑线间隔的测量，即可得到表面膜层的厚度、这种测量方法迅速、简便、设备简单、精确度高、不损伤膜层表面，适合在实验室和工厂广泛应用。

Ming-yee won two Golden Bell Award, two Golden Horse Awards and has two daughters.

仪铭得过2座金钟奖、2座金马奖，育有2个女儿。

Delegates Dining Room in the provision of traditional Romanian cuisine Caru'cu Bere restaurant, 1,000 yuan enough to support 4 individual dinner, including a Romanian cheese, two tripe soup, two duck breast and potatoes, two acid-zhi disabilities, there is a bottle of Romanian wine.

代表餐厅在提供传统罗马尼亚菜的Caru'cu Bere餐厅，1000元人民币足够负担4个人的晚餐，包括一份罗马尼亚芝士，两份牛肚汤，两份鸭胸肉和土豆，两份酸芝士，还有1瓶罗马尼亚红酒。

Two-dimensional electrophonesis was used to analyse the different compositions between resistant and susceptible accessions, There is one different spot between two accessions from Coomassie Brilliant Blue-stained gel, and three spots between two accessions from silver-stained gel.

双向电泳分析Mineirao柱花草和CIAT2312柱花草的蛋白质，考马斯亮蓝染色有1个显著差异点，再银染，有3个显著差异点。

Methods 100 examples,randoms choosing scheduled time line underbelly operation (operation,the womb cut completely or satisfy time eager operation,ovary tumour operation including cutting the palace product open) divide into two set,a forms:give hard film outside rentaini 0.4 mg + 0.75% bupivacaine 20 ml formulating cheng 100 ml analgesias,b group behind the skill:100 ml compounding cheng ease pain,comparatively,the life body collects,optesthesia simulates grade and bad reaction in giving hard film outside rentaini 0.4 mg + interest rate of 0.75% bupivacaine 20 ml + fluorines pai many 2 ml after the skill.results two set of patient skill queens circulation stabilizes equally,skill queen vas difference has no statistics significance,two set of analgesic effects have no notable difference,b many by-reaction of fluorine pai benefit appears on group but.

择期行下腹部手术(包括剖宫产手术、子宫全切或次全切手术、卵巢肿瘤手术)100例，随机分成两组，a组：在术后予硬膜外芬太尼0.4mg+0.75%布比卡因20 ml配制成100 ml镇痛。b组：在术后予硬膜外芬太尼0.4mg+0.75%布比卡因20ml+氟哌利多5mg配制成100ml镇痛，比较生命体征、视觉模拟评分和不良反应。结果两组患者术后循环均稳定，术后vas差异无统计学意义，两组镇痛效果无显著差异，但b组出现氟哌利多不良反应。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。