查询词典 twisted-pair

The objectives of this paper were to investigate the simulation and design of continuous multiple-station rolling forming process for a U-Section Steel Bar by CAE software-DEFORMTM Due to the limitation of elements number using a short strip 120mm went through all the stations to simulate the real continuous rolling forming on factory The roller gap was fixed as 0 30mm roll speed was 20 rad/sec and progressive angles were all equal for each rolling process which were the formed angle divided by by the number of station Three rolling processes were selected with 6 9 and 12 stations respectively During simulation processes two cases occurred Case A the strip was through a single station Case B the strip across two stations Because the strip laterals side was stretched and twisted during the process The model of case B closer to the practical process than case A and the calculated stress and strain on the tip of U section for case A were lower than these for case B by up to 15% From the result of case B for each process the stress for 12-station process was smallest 9-station process second and 6-station process next Because less-station can save larger cost and forming time but the bigger stress and strain for 6-station caused wrinkles on lateral sides not found on 9-station and 12-station Therefore 9-station process was a more suitable design than 12-station process smaller stretched and twisted and stress The progressive angles for 12-station was 7 5?

本文主要是以DEFORMTM有限元素软体模拟U型钢片连续道次成型与单一道次成型以确认单一道次模拟的是否可取代连续道次模拟之研究。因DEFORMTM 软体对於网格元素上的限制故使用较短素材120mm通过所有的成型站以模拟工厂实际连续成形方法。辊轮间隙固定为0 3mm；辊轮转速为20 rad/sec；弯曲角度的方法为将成型角度平均除以成型站数。有三种辊轮成型方式被选择分别为6站，9站，与12站。在模拟的过程中有两种现象会产生 Case A，素材通过单一成型站。Case B，素材会通过两个成型站。因为在模拟过程中素材的两端会有拉应力与扭力。Case B的模拟比Case A像实际的制程，并计算应力与应变在U型断面的Tip部中可发现Case A比Case B低约15%。从Case B的每站的结果可以得知，12站的成型应力最小，9站次之，6站最后。

Experimental results indicate that the B/A value greatly affects the internal Nusselt number and friction factor of the twisted tube because the parameters decrease with the increase of B/A and S/d values, more rapidly with the former, and that the Nusselt number and friction factor of the twisted oblate tube increase respectively by 30%~150% and 20%~50%, as compared with those of the smooth tube at the same Reynolds number and Prandtl number.

实验结果表明：高扭曲比螺旋扁管的管内努塞尔数和阻力系数均随B/A值和S/d值的增大而减小，但随B/A值的增加而减小得更快，B/A值对高扭曲比螺旋扁管的管内传热与流阻性能影响更大；在相同雷诺数和普朗特数下，高扭曲比螺旋扁管管内的努塞尔数为光滑管的1.3~2.5倍；阻力系数为光滑管的1.2~1.5倍。

A rotor structure for a rotating wing aircraft having substantially rigid rotor head means and rotor blades or wing means arranged in at least one pair, comprising blade angle bearing means (10, 12, 14, 16) for each rotor blade means, tension bar means (6,8) operatively interconnecting the rotor blade means of a pair which blade means are arranged diametrically opposite each other, said tension bar means having a high bending resistance, whereby transmission of bending moments from the rotor blades to the rotor head means is substantially prevented, each of said blade angle bearing means comprising a structure angularly movable in the wing flap direction and in the wing lead-lag direction, at least one of said blade angle bearing means of a pair comprising means permitting an axial motion of the respective tension bar means supported in said blade angle bearing means, and wherein said blade angle bearing means (10, 12, 14, 16) operatively support said tension bar means (6, 8) on said rotor head means (4) for pitch angle rotation of said tension bar means relative to said rotor head means (4), said rotor structure further comprising means (24) securing said rotor blade means (18) to said tension bar means (6, 8) in a manner rigid against rotation of the blade means about the longitudinal blade axis whereby the securing means prevent flapping, drag and lagging movements of the tension bar means, said tension bar means being constructed as torsion bars which are elastic relative to torsion about said longitudinal blade axis.

1转子结构为旋转翼飞机，有大幅刚性转子头部的手段和转子叶片或机翼的手段安排中至少有一对，组成的叶片角度轴承手段（ 10 ， 12 ， 14 ， 16 ）为每个转子叶片的手段，拉杆手段（ 6，8 ）手术互连转子叶片的手段，其中一对刀片的手段都是安排截然相反的对方说，拉杆手段，有一个高弯曲阻力，即传输弯矩从转子叶片向转子头的意思是，大幅防患于未然，每个叶片角度说，轴承的手段组成的一个结构angularly动产在机翼上皮瓣的方向和在机翼导致滞后的方向，至少有一个叶片角度说，轴承是指一对组成的手段，允许轴向的议案，分别紧张酒吧手段，支持在叶片角度说，轴承的手段，其中，叶片角度说，轴承的手段（ 10 ， 12 ， 14 ， 16 ）手术的支持表示拉杆的手段（ 6 ， 8 ）就表示，转子头部的手段（ 4 ）为俯仰角轮换说拉杆手段相对说，转子头部的手段（ 4 ）表示，转子结构进一步组成的手段，（ 24 ）说，确保转子叶片的手段（ 18 ）表示，拉杆手段（ 6 ， 8 ）在一个僵化的方式对旋转的叶片即是说，约纵向叶片轴，即确保手段防止扑，拖曳和落后变动的紧张局势，酒吧的手段，说拉杆手段，正在建造的，作为扭杆这是弹性相对扭转约说，纵向叶片轴。

We show that, for N parallel input states, an antilinear map with respect to a specific basis is essentially a classical operation. Later, We investigate the information contained in phase-conjugate pair |, and prove that there is more information about a quantum state encoded in phase-conjugate pair than in parallel pair.

在量子信息中，由于量子叠加性，人们发现在量子比特的情况下，相互正交的两量子态可以编码更多的信息，这在经典信息论中是不存在的。

A pair of new inodorous halfsilk black ladies' hose, a pair of new violet garters, a pair of outsize ladies' drawers of India mull, cut on generous lines, redolent of opoponax, jessamine and Muratti's Turkish cigarettes and containing a long bright steel safety pin, folded curvilinear, a camisole of batiste with thin lace border, an accordion underskirt of blue silk moirette, all these objects being disposed irregularly on the top of a rectangular trunk, quadruple battened, having capped corners, with multicoloured labels, initialled on its fore side in white lettering B.

639一双崭新、没有气味、半丝质的黑色女长筒袜，一副紫罗兰色新袜带，一条印度细软薄棉布做的大号女衬裤，剪裁宽松，散发着苦树脂、素馨香水和穆拉蒂牌土耳其香烟的气味，还别着一根锃亮的钢质长别针，折叠成曲线状。一件镶着薄花边的短袖麻纱衬衣，一条蓝纹绸百褶衬裙。这些衣物都胡乱放在一只长方形箱盖上：四边用板条钉牢，四角是双层的，贴着五颜六色的标签，正面用白字写有首字B。

I have a pair of sharp eyes, should not even think about any one of the insects have escaped; I have a jet-black feathers and a smooth one ; handsome I have a pair of wings, which let me fly particularly fast; Finally, I also the tail of a pair of scissors.

我有一双锐利的眼睛，任何一只虫都别想逃过；我有一身乌黑的羽毛，光滑得谁都想摸；我有一对俊俏的翅膀，它让我飞得特别快；最后，我还有一个剪刀尾巴。

What are the members of the following ordered pair: the first member of the pair is the best possible question I could ask you, and the second member of the pair is the answer to that question?

下面这个有序字符串对的元素具体是什么：第一个元素是我现在能问你的最好的问题，第二个元素是这个问题的答案？

A heavy duty tire comprises a tread portion, a pair of sidewall portions, a pair of bead portions each with a bead core therein, the bead core with an aspect ratio (HC 1 /WC) of from 0.43 to 0.58, and a carcass comprising a carcass ply of cords extending between the bead portions and turned up around a bead core in each bead portion from the inside to outside of the tire so as to form a pair of turnup portions and a main portion therebetween, the turnup portion comprising a turnup main-part extending along an axially inner surface, a radially inner surface and an axially outer surface of the bead core smoothly, and a turnup sub-part extending from the turnup main-part toward the main portion near the radially outer surface of the bead core.

本发明公开一种重载轮胎，包括：胎圈部分；一对胎侧部分；一对胎圈部分，每个胎圈部分中具有一胎圈芯，所述胎圈芯的高宽比(HC1/WC)在0.43到0.58范围内；以及胎体，其包括胎体帘布层，该胎体帘布层的帘线在胎圈部分之间延伸并且绕每个胎圈部分中的胎圈芯从轮胎内侧卷绕到轮胎外侧，而形成一对卷起部分以及位于该对卷起部分之间的主体部分，卷起部分包括沿胎圈芯的轴向内表面、径向内表面以及轴向外表面平滑延伸的卷起主部以及邻近胎圈芯的径向外表面而从卷起主部朝主体部分延伸的卷起子部。

Five pairs of 45S rDNA loci and two pairs of 5S rDNA signals were detected on chromosomes of Cucurbita moschata Duch. Luffa cylindrical Roem. contained five pairs of 45S rDNA loci and one pair of 5S rDNA loci. In Benincasa hispida Cogn., two pairs of 45S rDNA sites and one pair of 5S rDNA site were detected. In this species, 5S rDNA and one pair of the 45S loci were collocated closely in chromosome 7S. 45S rDNA chromosomal distribution patterns were highly conserved among the three species, althoufh their number varied markedly. The 5S rDNA sites on chromosomes among the three species were highly polymorphic.

南瓜有5对45S rDNA位点， 2对5S rDNA位点；丝瓜具有5对45S rDNA位点， 1对5S rDNA位点；冬瓜具有2对45S rDNA位点， 1对5S rDNA位点， 5S rDNA位点与其中一对45S rDNA位点都位于7号染色体短臂上，并在物理位置上紧密相邻。45S rDNA在这3种作物染色体上数目变化较大，但在染色体上都倾向分布在短臂末端，其分布模式较为一致。5S rDNA在这3种作物染色体上数目相对保守，但在染色体上分布的位置变化较大。

Furthermore,the optimal approximation bisymmetric solution pair to a given bisymmetric matrix pair in Frobenius norm can be obtained by finding the least norm bisymmetric solution pair of new matrix equation ,where .

另外，给定双对称矩阵对，通过求矩阵方程的双对称解对，得到它的最佳逼近双对称解对。

More direct, directer ; most direct, directest

径直的，笔直的

Do you know how to use a chain saw?

你知道如何使用链锯吗？