查询词典 twin bed

Vi.上床,分层 apple-pie bed be brought to bed confined to one's bed die in one's bed feather bed flock bed get up on the wrong side of the bed get out of bed on the wrong side go to bed go to bed in one's boots keep one's bed keep to one's bed leave one's bed lie on the bed one has made lie in the bed one has made lie on a bed of thorns make one's make one's bed bed and lie on it make one's own bed make one's own bed and lie on it make the bed make a bed narrow bed narrow cell narrow house narrow home put to bed put to bed with a shovel stretch on the Procrustean bed

发生性关系；付印喝得大醉早睡早起因病躺在床上因病躺在床上病愈起床自作自受自作自受如坐针毡；坐立不安自作自受自作自受自作自受自作自受整理床铺整理床铺坟墓坟墓坟墓坟墓使睡；将扣紧准备印刷；准备编排直至印刷为止埋葬，下葬；扶送回家上床按照同一标准判断；强求一致 24 As you make your bed， so you must lie on it。

To be one of twin offspring.Twin executives; twin cities; a twin bed.

两个对等的执行人员；姐妹城市；一对配对单人床中的一个

The results show that the decalescence of catalyst bed affects the process of hydrogen peroxide catalytic decomposition greatly. If the catalyst bed is preheated or made up of materials with low thermal conductivity, that influence can be depressed. At the same time, the response characteristic of catalyst bed and the efficiency of catalytic decomposition can be improved. The low frequency pressure instability of catalyst bed occurs because of the coupling of catalytic decomposition and supplying. The decomposition plane pushes all the way through the catalyst bed during pressure oscillations, causing unreacted liquid hydrogen peroxide to be exhausted from the bed and leading to the appearance of liquid hydrogen peroxide channeling. Consequently, how to prevent or at least limit this channeling is the key to eliminate the pressure instability of catalyst bed. It was found that adding clapboard to the catalyst bed can depress the pressure instability efficiently.

结果表明催化剂床及催化剂的吸热对过氧化氢分解过程影响很大，对催化剂床进行预热或采用热导率低的材料制造催化剂床等措施，可以降低催化剂床壁面吸热对催化分解过程的影响，提高催化剂床的响应特性和催化分解效率；催化剂床的低频不稳定是催化分解过程与供应系统耦合产生的，催化剂床气体界面的波动过程中，液体过氧化氢穿透催化剂床形成过氧化氢液体通道，过氧化氢液体通道的产生和扩大是催化剂床不稳定的主要原因，也是消除催化剂床不稳定的关键，试验中在催化剂床内加入分流板成功地抑制了催化剂床的低频不稳定。

Switch can be adjusted back up hand-held point of view (maximum 80 degrees) and leg drop angle (100 degrees);◆ foot bed lowest point from the ground 130mm, the highest point of the bed from the ground 680mm; also elevated bed of different heights;◆ bed in back with plexiglass plate, the user can seat on the bed for X-ray;◆ aluminum fence, can also choose to use push-pull PP flip rail or fence;◆ lift back, the waist angle of tilt, to prevent the sliding body;◆ by about 2 degrees of seat angle;◆ foot can be bent 100 degrees and can easily get out of bed from the bed and sat up and on;◆ foot horizontal position may rise higher than the height of 120mm;◆ with quiet casters with brakes and can be locked and lifted;◆ durability, operational quality, improved operating performance moving bed;◆ equipped with ABS headboard can be instantly demolished;◆ electric device of high quality fully enclosed permanent magnet DC control system;◆ low noise, high safety, long life;◆ new materials with polyester fiber mattresses;◆ can also choose to use low-rebound double-foam mattress or mattress waterproof material;◆ has good air permeability and durability.

可用手持开关任意调节背部上升角度（最大80度）和腿部下降角度（最大100 度）；◆脚部床面最低处离地面130mm，床面最高处离地面680mm；还可升高床面不同高度；◆床体背部采用有机玻璃板，使用者可以座在床上进行X光检查；◆采用铝合金护栏，还可选择采用PP翻动护栏或推拉式护栏；◆抬升背部时，腰部有一定角度的倾斜，为防止身体的滑动；◆采用了约2度的座角；◆足部可以100度弯曲，能够很方便从床上坐起和上下床；◆足部可上升高度比水平位置高120mm；◆采用静音带刹车的万向脚轮，并能进行锁定和解除；◆耐久性、操作性优良，提高了病床搬运的作业性能；◆配有ABS床头板可瞬间拆卸；◆电动装置采用优质永磁直流全封闭式控制系统；◆噪音低、安全性高、使用寿命长；◆配有聚脂纤维新材料床垫；◆还可选择采用低反弹的双层海绵床垫或防水材料床垫；◆具有良好的透气性和耐用性。

Many nanotwins were formed in this triangular region. HREM observations showed that nanotwinning dislocations were nucleated at noncoherent twin boundaries with the local stress concentration, and the nucleation is related to the dislocation dissociations at the boundary ledges. The proceeding of these nanotwins is the homogenous shears of 1/6 [11〓] twinning dislocations, which is that the trailing 1/6 [112] twinning dislocations repel the leading twinning dislocations to proceed in the (111) planes. Therefore, twinning dislocations at the twin tip appear to be on one side of twin, forming a noncoherent twin boundary with a semilenticular shape.

在此三角区域内发现许多纳米孪晶的存在，通过高分辨电镜手段观察到纳米孪晶中的孪生位错是在具有原位应力集中的非共格入射孪晶界上形核的，纳米孪晶的形核与界面的台阶位错及其位错分解反应有关，纳米孪晶的行进是1/6[11〓]孪生位错均匀切变机制，即每一个（111）孪生面上对应一个孪生位错，其中拖尾的1/6[11〓]孪生位错将会推动领先的孪生位错行进，于是在形变孪晶头部位置的孪生位错排列常常出现在形变孪晶的一侧界面，形成一个半透镜状的非共格孪晶界。

In different conditions on fluidized state and stability of conical fluidized bed. The conlusions are: the conical angel of the conical fluidized bed is 20°, the fluidized state havesmall difference in conical distributor and distributor plate. The angle of conical bed increase,the fluidized state will have big difference. The angle is 60°and the conical as distributor, themass of fluidized is less, the most of material is the bottom of conical bed. The effect ofdistributor plate is much better than the conical distributor. Sawdust and rice hull can fluidize.The annular gap of conical distributor different, the angle of conical bed is same, the fluidizedquality of 10mm annular gap is better than the other conical distributors. The annular gap ismore wide, the conical bed have more slugging phenomenon and the pressure fluctuate is turnbig.In the experiment the flow of 2％and 4％distributor plates don\'t easy to control, becausethe pressure is very big and the pressure fluctuate of conical bed is too big.

在不同的条件下对锥形床的流化状态和稳定性进行了研究，结果得出：锥形床的锥角为20度时，分布锥和分布板的流化状态相差不明显，随着锥形床锥角的增大，分布锥和分布板的流化现象会出现明显的变化，锥形床锥角越大，分布锥的流化状态变化越明显，流化的的物料越少，大量物料都聚集在锥形床底部，而分布板在加料量少的情况下，能流化起来。10mm、15mm和20mm环隙分布锥在锥形床锥角相同条件下，10mm环隙分布锥的流化质量要好于其它两个分布锥，环隙越大越容易出现腾涌现象的产生，压降波动范围增大。2％、4％和6％开孔率分布板在本实验测定时，2％和4％开孔率分布板的流量不容易调节，同时产生的压降波动范围也很大，比较来说，6％开孔率分布板流化质量好些。

The lower part of a pulley block .Shaped like a pulley .Twin executives; twin cities; a twin bed.

两个对等的执行人员；姐妹城市；一对配对单人床中的一个

The multifunctional overturn bed has one bed frame with one side connected to the bed head and the other side connected to the bed tail, one leftwards overturn unit set to the left side of the bed frame, one rightwards overturn unit set to the right side of the bed frame, and one translation unit set between the leftwards overturn unit and the rightwards overturn unit.

本发明床身框架(3)的一侧与床头(4)固定连接，床身框架(3)的另一侧与床尾(2)固定连接，左侧位翻身装置设置在床身框架(3)内的左侧，右侧位翻身装置设置在床身框架(3)内的右侧，平移装置设置在左侧位翻身装置和右侧位翻身装置之间的床身框架(3)内。

A place where one may sleep; lodging:found bed and board at an inn.a maternity ward with 30 beds.drank milk before bed.(7) A place for lovemaking.(8) A marital relationship with its rights and intimacies.a flower bed.a clam bed; an oyster bed.(11) The bottom of a body of water, such as a stream.(12) A supporting, underlying, or securing part, especially:tomatoes on a bed of lettuce.

默认会在英汉简明词典和汉英简明词典等基本词典中查找，如果希望在更多专业词典中查找，请在输入词或短语后点击选择词库，在下面的词典列表中选中要在其中查找的词典左侧的复选框，然后点击"查询"即可。

Asked the American people why the United States Air Force equipment is extremely advanced and the security sector can not stop the hijacked aircraft, but also some scientists questioned: jet flame produced by combustion is not sufficient completely destroyed the structure of the twin towers, can not lead to the twin towers Finally, all the collapsed World Trade Center in ruins and found a high temperature molten metal is caused by thermite, it is very likely infer a person the use of explosives blew up the twin towers.

美国民众问道，为什么装备极其先进的美国空军和安全部门无法阻止被劫持了的飞机，也有科学家质疑：喷气式客机燃烧时产生的火焰不足以完全破坏世贸双塔的结构，不能导致双塔最后全部坍塌，而且在世贸中心废墟上发现的熔化金属是一种高温铝热剂所致，因此推断极有可能是某人使用炸药炸毁了双塔。

Just so you know where we're going...

只要让你知道我们的目标。。。

One of his friends acted as the gobetween in his business.

在这件事中，他的一个朋友充当了中间人。