查询词典 turbine-engined

Based on ASME PTC6 Turbine Performance Acceptance Test Code,the principle of calculating the specific enthalpy of exhaust steam from low-pressure cylinder has been determined.

根据ASME PTC6汽轮机性能验收试验规范确定低压缸排汽比焓的计算原则，介绍了目前国内外对计算低压缸排汽比焓及热力过程线的4种处理方法，并对各种方法的优缺点进行了具体的分析。

In view of the existing problems of the unreasonable steam distribution in condenser, optimal revamp for No.2 turbine low-pressure cylinder air-outlet channel is carried.

潍坊发电厂#汽轮机低压缸的排汽在凝汽器内分布不合理，造成凝汽器换热管热负荷不均匀。

Adopting 3-dimentional flow field design method, a modernizing retrofit of the flow passage for low-pressure cylinder of one 100 MW steam turbine in a power plant has been carried out under prerequisite of reserving the original low-pressure cylinder and the main shaft.

采用三维流场设计方法，在保留原低压缸和主轴的前提下，对某电厂6号100MW汽轮机低压缸通流部分进行了改造。

With the rapid increase of the reduced head and unit capacity of hydro turbine in recent years, more and more attention is paid to the vibration of units and mill construction.

摘要随着近年来水轮机的引用水头和单机容量的急剧加大，机组振动和厂房结构振动问题越来越受到人们的关注。

FRP composites of excellent performance are widely used in wind turbine blades, nacelles and nosecone.

玻璃钢复合材料以其优良性能，在风力机的关键部件叶片及机舱罩和导流罩上得到应用。

D models are the most widely spread in the world of turbo-machinery for its simplicity, but they are indeed purely empirical correlations which not only fail to provide detailed information inside one or more components, but also require significant effort to recreate themselves if engine operating conditions or component representations change; quasi 3-D models have been the workhorses for compressor and turbine design for many years, and the primary benefit of using quasi 3-D system models is to facilitate the design and detail analysis of a particular component across the range of possible boundary conditions; Full 3-D models are gradually replacing quasi 3-D ones by virtue of requiring no exit flow angle model and loss model and being capable of predicting secondary flow in cascade.

零维模型由于使用时简单易行，因此在涡轮发动机的仿真中得到广泛应用，但零维模型作为纯粹的经验关系式无法反映部件内部的流动细节，并且一旦部件有少许改动则新特性的建立耗费巨大；准三维模型由于能够详细地提供部件内部的流动情况，方便设计而成为涡轮和压气机设计的主要工具；全三维数学模型正逐步取代准三维模型在涡轮设计中的主导作用，同后者相比前者能够预测叶轮机械内的二次流动，在粘性流计算时不需要气流角和损失的经验公式，因此拥有巨大的发展前景。

The test method of the magnetic memory of the vanes of a turbine was studied.

研究了汽轮机叶片的磁记忆检测方法。

Researching two key technic to uprating and refurbishing of the Hydropower Station.(1)The optimizely design to the runner of hydraulic turbine;(2)The design of the micro-computer field excitation device.

本文结合安徽省蚌埠闸水电站的具体情况，研究和探讨了中小型水电站老机组技改增容的关键技术，设计出技改增容的总体方案。

Of the U tube bundle, is heated to the boiling temperature, turns to steam, and then travels to the turbine set in thebuilding.

二回路的水在U形管束外壁流动，当被加热到沸腾温度时，转变成蒸汽，然后进入汽轮机。

The hitch is that syngas from waste is full of tarry residue that tends to gum up the turbine.

缺点是垃圾生成的合成气体中所含的大量的焦油状残渣会把涡轮机粘住。

According to the clear water experiment, aeration performance of the new equipment is good with high total oxygen transfer coefficient and oxygen utilization ratio.

曝气设备的动力效率在叶轮转速为120rpm～150rpm时取得最大值，此时氧利用率和充氧能力也具有较高值。

The environmental stability of that world - including its crushing pressures and icy darkness - means that some of its most famous inhabitants have survived for eons as evolutionary throwbacks, their bodies undergoing little change.

稳定的海底环境─包括能把人压扁的压力和冰冷的黑暗─意谓海底某些最知名的栖居生物已以演化返祖的样态活了万世，形体几无变化。