查询词典 triple cylinder

Therefore,For the manufacturers of production and use of such hydraulic cylinder,To build top-loading test rig for high-pressure hydraulic cylinder type test is particularly important.

油缸生产厂家对其修理或制造的油缸，在产品鉴定或出厂时，必须按照国家规定及现行标准（GB/T 15622-2005），进行型式试验或出厂试验。

The heat consumption of turbine is 8167kJ/ after revising at the condition of the whole opening four valves (4VWO). At the rated load, the efficiency of high-pressure cylinder is 81.64%, and the efficiency of the middle and lower pressure cylinder is 90.53%.

试验研究表明，宁夏中宁发电有限公司的新型改进优化型机组(K156)性能基本能够达到设计指标，在设计额定负荷330MW下的热耗率为8339kJ/，汽轮机在四阀全开(4VWO)的工况修正后热耗率为8167 kJ/；在额定出力下，高缸效率达81.64%，中低压缸效率达90.53%。

Through treatment in the major repair, the exhaust steam pressure from the high-pressure cylinder has been decreased about 0.13 MPa, the exhaust steam temperature from the high-pressure cylinder being lowered about 14 ℃, substantially enhancing the efficiency of said turbines.

试验结果为：在135MW负荷时，高排压力和温度分别为2.84MPa和338.9℃，比设计值分别高出0.26MPa和21.7℃；实测高中压缸效率分别为76.36%和91.03%，比设计值约低4.7和1.9个百分点，考虑到高、中压缸间轴封

Inspection, screw open the cylinder high-pressure pipeline joints, using hand pump pumping pumps, fuel injection pump at the top of the case found that there is oil outflow tubing connector, the valve of the oil seal bad (of course such as a broken valve spring is also this would be the case), such as cylinder seals appear undesirable situation, it should conduct a thorough debugging injection pump maintenance, the replacement of dual pieces.

检查时，拧开各缸高压油管接头，用输油泵之手油泵泵油，如此时发现喷油泵顶部油管接头有油流出，则说明该出油阀密封不良（当然如出油阀弹簧折断也会出现这种情况），如多缸出现密封不良现象，则应对喷油泵进行彻底调试保养，更换偶件。

A correlation of the experimentaldynamic response of the vessels with the theoretical finite element calculations ispresented and discussed.1 The response of the end caps is dominated by transverseand torsional deformation of the plates.The membrane strain is negligible compareto the lateral strain.2 In the lengthwise direction of the inner cylinder,themembrane strain has the same magnitude as that of the bending strain. But for theouter cylinder,the former is much smaller than the later at the same direction.3 Forboth the inner shell and the outer shell,hoop strains are primarily due to themembrane deformation.The amplitude of the circumferential flexural strain isconsiderably small.4 Peak strains in the vicinity of the connection portion of theend caps and the shells are very high.This is important to assess the safety of thecontainer in case of repeated use or tests.5 The applying load to the end cap isdifferent from that to the inner shell plate, but peak stains and nodal displacementsof these two structural parts are nearly the same.It can be inferred that the dynamicresponse of the end cap is greatly affected by the structural vibration excited by theimpulsive loading.

结果表明：1在本文所考虑的载荷水平下，平板变形以板的横向弯曲和扭曲为主，中面应变幅值比较小。2对于内容器，其纵向变形中弯曲应变和中面应变大小接近；而对于外容器，其纵向变形以弯曲为主，中面变形比较小。3内、外壳体的环向变形主要是中面应变，弯曲应变分量很小。4平板和壳体连接处应变很大，这对于多次使用或实验时评价结构安全有指导意义。5尽管内筒底板和大封头上的作用载荷有一定差别，但应变峰值和节点位移峰值基本相近，这说明脉冲载荷激发起来的结构振动对封头的动态响应有很大影响。

Type twelve-cylinder engines have throw arrangements like the in-line six-cylinder engine.

型12缸发动机，有扔的安排一样，在网上六缸引擎。

In power, only a6l Audi is in-line 4-cylinder engine, although there are turbocharged gasoline direct injection system and with the help, but the maximum power and torque than the other two big 6-cylinder engine displacement is lower.

在动力方面，只有奥迪a6l是直列4缸发动机，虽然有涡轮增压和汽油直喷系统的帮助，但是最大功率和扭矩都要比其它两款大排量6缸发动机要低。

The excitation sources of vibration in a in-line 4-cylinder engine include second-order inertia force induced by piston reciprocating movement and rolling moment caused by the side force exerted on cylinder.

四缸发动机的主要激振源为活塞往复运动产生的往复惯性力和气缸承受的侧压力产生的倾覆力矩。

Low-pressure compressor cylinder on the restoration, embedded with the cylinder, the crankshaft, connecting rod, and other parts of the restoration.

对压缩机低压气缸的修复、缸套的镶配、曲轴、连杆等部件的修复。

Adopting 3-dimentional flow field design method, a modernizing retrofit of the flow passage for low-pressure cylinder of one 100 MW steam turbine in a power plant has been carried out under prerequisite of reserving the original low-pressure cylinder and the main shaft.

采用三维流场设计方法，在保留原低压缸和主轴的前提下，对某电厂6号100MW汽轮机低压缸通流部分进行了改造。

For you say, My doctrine is pure, And I am clean in Your eyes.

11：4 你说，我的道理纯净，我在你眼前清洁。

The method takes make water sedimentary in patient of be in hospital of leucocyte grow in quantity 30, according to clean middle make water bacterioscopy result, distinguish the patient to affect group and blame infection group, pathology of puncture of farther travel kidney analyses blame infection form.

方法取尿沉渣中白细胞增多住院患者30例，根据清洁中段尿细菌检查结果，将患者区分为感染组和非感染组，非感染组进一步行肾穿刺病理分析。