查询词典 transmission grating

Based on the influence of reflection phase of fibre Bragg grating on the transmission spectrum of fibre Bragg grating Fabry-Perot cavity, the reason for the error of traditional coupled mode theory when calculating the reflection phase of uniform FBG is analyzed.

基于光纤Bragg光栅反射复振幅相移对FBG法布里-珀罗腔透射谱的影响，分析了传统耦合模理论计算均匀FBG反射复振幅相移产生误差的原因。

The mode field of photonic crystal fiber structured with hexagon symmetry hole cladding was analyzed by coupled-mode, and the effective indexes of base mode of different wave length were got. The characteristics of this photonic crystal fiber grating were computed and simulated by coupled-mode method and transmission matrix method. Moreover, the differences were compared between conventional fiber grating and photonic crystal fiber grating on their reflection spectrum and delay.

利用多极法对包层空气孔为正六边形对称结构光子晶体光纤的模式场进行了分析，计算出不同波长下基模的有效折射率，结合使用模式耦合理论和传输矩阵法对基于光子晶体光纤的布拉格光栅特性进行了计算和仿真，对比了常规单模光纤所成光栅与相同光栅周期的光子晶体光纤布拉格光栅反射谱及时延特性之间的差异。

The transmission grating is coupled to X-ray CCD , and a set of system for measuring soft X-ray spectra is obtained.

采用七道和十道的两台软X光谱仪同时测量双盘靶初次级辐射的软X光谱，并进行物理分析。

A method of relative calibration for "Shanghai"soft X-ray film,using transmission grating on synchrotron radiation source,is introduced.

介绍了在同步辐射源上用透射光栅对"上海"软X光胶片进行相对标定的方法，初步研究了"上海"胶片的特性，得到了在276eV和930eV两能点的胶片黑密度与相对曝光量的关系曲线；应用标定结果，计算了光栅的衍射效

Study on transmission spectrum of ZnO films;2. Study of Measuring Grating Parameters with Transmission Spectrum and Design of Perfect Anti-reflection Coating;3. Kinetics of the oxidation process of the copper films in the thickness range of 16～22 nm at 140 ℃ was studied by using transmission spectrum and sheet resistance methods.

采用方块电阻和透射光谱两种方法为表征手段，测量16～22nm范围内不同厚度Cu薄膜在140℃下完全氧化所需要的时间，得到了Cu薄膜氧化反应的动力学曲线，并利用X射线衍射分析了氧化产物的晶相结构和成分。

The method of diffractive optical elements, such as processing and transmission grating dense optical material from the traditional extended to ordered nano-pore materials, is expected to apply to the manufacture of high performance diffractive optical elements.

该方法将衍射光学元件如透射光栅的加工由传统的致密光学材料扩展到有序纳米孔材料上，有望适用于制造高性能衍射光学元件。

A transmission grating with an area of 1 mm × 1 mm, a pitch of 300 nm, and a gold thickness of 1 μm for X-ray imaging and microscopy is successfully fabricated by combining electron beam lithography, X-ray lithography, and electroplating.

利用电子束光刻、X射线光刻和微电镀技术，成功制作了面积为1 mm×1 mm，周期为300 nm，金吸收体厚度为1 μm的用于X射线显微成像的透射光栅。

With given parameters of the fiber grating, the transmission spectrum of the long-period fiber grating was obtained by simulation with Matlab. As a result, the position of the resonant wavelength of the long-period fiber grating is decided by the grating′s period. The attenuation changes with the length and refractive index of the grating.

在设定的光纤光栅参数条件下，通过Matlab进行模拟得到了最终需要的长周期光纤光栅透射谱，并由此得出：长周期光纤光栅谐振波长出现的位置主要由光栅的周期决定，损耗大小可以通过调节光栅长度和折射率来实现。

Higher order contributions in the spectral radiation standard and metrology beamline were researched using transmission grating and IRD AXUV100G photodiode detector.

采用自制的840/mm金膜自支撑透射光栅和美国IRD公司的AXUV100G光电二极管探测器，定量研究了光谱辐射标准和计量光束线在5-140 nm波段的高次谐波。

The numerical calculation shows that the space distibution of the electromagnetic field in each sub-micro-layer changes with the varing transmission depth in the relief grating, the space distribution in each sub-micro-layer is uniformer than that in isotropic grating and the optical parameters of the anisotropic relief grating and the incident beam have a large impact on the space distribution of the electromagnetic field in relief grating and so on.

数值计算表明，光波场光强的空间分布随透射深度的变化而变化，各向异性介质光栅体内光波场的空间分布相对各向同性介质要均匀，光栅材料的性质参数和光束的入射参数对光波场光强的空间分布有较大的影响等。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。