查询词典 train load

Joint behavior of beam and column is the key of entire structure.This paper uses finite elemnt analyzing software ANSYS to analyze the bearing mechanics of joint under monotonic load and periodic load,and gets load-displacement curves,viscosity curves and frame curves.The paper mainly analyzes how axis-push ratio,gradation of concrete,plate layout and steel type to affect tensibility performance and viscosity feature of joint.The results indicate that concrete-filled squar tube column has good tensibility performance and dissipative ability.

梁柱节点的性能是影响结构整体性能的关键，而目前对方钢管混凝土柱—钢梁节点抗震性能的研究工作尚不完善，本文通过有限元软件ANSYS来分析方钢管混凝土柱—钢梁节点，研究节点区在单调荷载和低周反复荷载作用下的受力机理，得节点区的荷载位移曲线、滞回曲线及骨架线；着重分析方钢管混凝土柱的轴压比、混凝土等级，隔板形式和钢材型号在低周反复荷载作用下对节点延性和耗能等抗震性能指标的影响。

And since the actual load table cannot be directly used for computation, an equivalent trapeziform load chart is got from the original load table according to equal-damage principle.

由于实际载荷谱不便于用来进行损伤和寿命计算，所以按照等损伤的原则对载荷谱进行了转换，得到一个等效的梯形载荷谱。

By way of eight experiments and statistical analysis of loads of overhead crane in actual usese, we have got that the lifing load is stationary, normal and homogeneous Poisson, and got distribution function of lifting load, the load spectrum factor, the rain-flow counting results of stresses and statistical results of location of the trolly, that will provide a large number of datas for reliabilitic design of overhead crane.

通过对八台桥式起重机现场使用载荷的实测试验与统计分析，得出桥式起重机吊重载荷的平稳性、正态性、齐次泊松性、幅值分布、载荷谱系数，以及应力的雨流计数结果、小车位移分布等，为桥式起重机可靠性设计提供了大量的统计数据。

The Ti_3SiC_2-SiC multiphase ceramic were fabricated by in situ synthesis under hot isostatic pressing.The examinations indicate that,the dominant wear mechanisms change with load increasing under unlubricated conditions,it is main abrasive wear under low load,and it is main adhesion wear under high load.Lubricating oil improves the friction coefficient and wear rate of Ti_3Si...

结果表明：干摩擦条件下随载荷的变化，占主导地位的磨损机制将发生变化，在低载荷下以磨粒磨损为主，高载荷下以粘着磨损为主；同干摩擦相比，润滑油对摩擦副的摩擦磨损性能的改善均很显著；Ti3SiC2/SiC复相陶瓷的磨损主要由粘着和微断裂引起的。

Axial load, in-plane bending load and out-plane bending load are considered inthe loading-carrying capacity of T-shaped unstiffened and inner-stiffened RHS-CHSjoints in this paper.

在T形非加劲与加劲RHS-CHS节点研究中，分别考虑了支管轴向力作用、平面内弯矩作用、平面外弯矩作用三种单荷载作用情况。

Results 1.After treated by:program freezing,the maximum load of the allografts has no evident decrease and the cell activity of allografts was preserved well,the frozen hurt after program freezing was more slight than －80℃ deepfrozen,2.No evident reject reaction can be seen during the healing process after deep frozen and the reject reaction declined as the time pass by.3.Three weeks afer the allografting,there was no significant difference between the two al lografting groups in maximum load(P＞0.05),Eight weeks later,the maximum load of the group that was preserved by liquid nitrogen after program freezing(76.60±4.67)N was better than the group that was preserved by －80℃ deepfrozen(75.99±4.20) and similar with the autografting group(76.72±2.55).4.The healing process and histological behavior of the two deepfrozen groups are similar with the autografting group,and the program freezing group is better.

结果 a经程序冷冻液氮保存方法处理后，髌腱的最大载荷无明显下降，细胞活性得到了较好的保存，组织学观察冷冻损伤较－80℃深低温保存方法轻微；b程序冷冻液氮保存处理的移植物在术后未表现明显的排斥反应，且免疫反应随时间的推移而下降；c移植后3周，各组移植物的最大载荷无显著差异(P＞0.05)，移植后8周，程序冷冻液氮保存组移植物的最大载荷(55.87±1.86)N优于－80℃深低温保存组(52.14±2.79)，而和自体移植组相近(57.70±2.76)N；d从组织学观察看，－80℃深低温保存组和程序冷冻液氮保存组移植后的愈合过程均和自体移植组相似，而程序冷冻液氮保存组的愈合过程和组织学行为更接近于自体移植组。

The "load of the flies", namely the king of flies, derives from the rabbinical baalzebub. and in the bible the "baal" means the "head of all evils". in english,"load of the flies" is the load of dirties, and it is also the thesaurus of ugly soul.

蝇王&即苍蝇之王，源于希伯莱语baalzebub，在《圣经》中&baal&被当作&万恶之首&，在英语中，&蝇王是污秽物之王，也是丑恶灵魂的同义词。

When wind energy and solar energy are sufficient, wind turbine and photovoltaic arrays can satisfy load demand and at the same time they can feed electrolyzer; when wind energy and solar energy cannot satisfy load demand, the FC system will provide supernumerary electric energy, at the same time the deficient part of load power excessing the maximum power supply ability of FC system can be fed by UC bank in a short-term.

当风能与太阳能充足时，风机与光伏阵列可满足负荷的需要，同时还可向电解池供电；如果不能满足负荷的需要则由燃料电池提供额外的电能，同时由超级电容在短时期内向负荷提供燃料电池最大功率以外的那部分电能。

Being aim at the optimization issue of load of antenna near ground, it combines many GA strategies and puts forward strategic meme. And it puts out co-evolution algorithm of load of antenna design. And it emulates the optimization design of load of antenna near ground. Finally, it valuates the co-evolution algorithm's efficiency on the continuum search issues of multi-variable and multi-peak value.

针对近地天线加载优化设计问题，结合多种改进GA策略，提出了策略型拟子，给出天线加载设计的共同进化算法，对有耗半空间对称偶极子天线加载优化设计作了仿真实验，验证了共同进化算法对多变量多峰连续搜索问题上的有效性。

Elastic buckling and inelastic buckling of arch with and without out-of-plane brace under full span distributed load and concentrated load are investigated The effects of the brace to the out-of-plane buckling load of arch are studied.

对拱结构在全跨均布荷载和跨中集中荷载作用下的平面外屈曲性能进行了研究，其中考虑了屈曲前变形路径的影响和面外支撑情况，为工程设计提供了有参考价值的建议。

The dissecting of samples in group2 were difficult. The root of pulmonary artery and ascending aorta failed to be unfolded because fibrous tissue was tough, right and left fibrous trigone were too firm to be solved by hand. Cardiac muscle fibers couldn't be stripped along myofibrillar trajectory since they were prone to break because of their friability.

组2的心脏解剖困难，表现为纤维组织坚韧，游离肺动脉非常困难；徒手无法松解左、右纤维三角，肺动脉和主动脉根部的游离非常困难；心肌纤维坚硬、质脆，解剖时容易断离成碎块，无法沿纤维走行方向剥离。

We have battled against the odds in a province that has become increasingly violent.

我们对在一个争夺日益激烈省的可能性。