查询词典 torque force

Therefore, the torque required to open the gate valve required torque than the closure of large, in addition, for a pair of contact between the sealing surface, the Non Rising Stem Resilient Seated Gate Valves coefficient of static friction between them than the dynamic friction coefficient, to make them from the static state generate the relative movement is required to exert greater force to overcome the static friction; due to temperature changes, so that the sealing surface pressure between the larger, need to overcome the static friction force also will be bigger, so that when you open the valve on the stem nut on the sometimes increase the torque exerted a lot.

所以，开启闸阀所需的力矩比关闭闸阀所需的力矩大，此外，对于一对互相接触的密封面来说，它们之间的静摩擦系数也比动摩擦系数大，要使它们从静止状态产生相对运动，需施加较大的力以克服静摩擦力；由于温度变化，使密封面间的压力变大，需要克服的静摩擦力也随之变大，从而使开启闸阀时，对阀杆螺母上施加的力矩有时会增大很多。" Moment analysis of valve operation "是由中国闸阀网提供的国际阀门新闻，译文仅供参考。另外，中国闸阀网还提供相关产品搜索：闸阀型号、闸阀价格、闸阀技术、闸阀新闻、闸阀生产商等。

It is shown that the friction force and bulkhead thrust are the main factors of shield thrust setting, while the friction between the cutterhead and soil is the main factors of cutterhead torque setting. Friction force between shield and soil would make front soil of shield upheave, and subsidence of surface soil is induced by ground loss when the friction force between the cutterhead and soil results in the surface settlement asymmetrical distribution.

通过计算发现，盾构施工中盾壳摩擦和正面推力是盾构推力设置的主要因素，而刀盘与土体摩擦是刀盘扭矩设置的主要因素，盾构前方土体隆起主要由盾壳摩擦引起，刀盘摩擦作用主要引起地表沉降的非对称分布，地表沉降主要由盾尾空隙产生。

The constraint force/torque dexterousness is defined as the ratio of minimum singularity value to maximum one of the force/torque constraint matrix, by which the performance of the combinations of actuating inputs is evaluated.

将约束力/力矩矩阵的最小奇异值与最大奇异值之比定义为约束力/力矩各向同性度，并以此为指标对各驱动输入组合的优劣性进行评价。

Torque is the torque in the physics of small, equal to the product of force and lever arm, the international unit is Nm Nm, In addition we can also see kgm, lb-ft of torque of this unit, as a result of G = mg, when g = 9.8 when, 1kg = 9.8N, so 1kgm = 9.8Nm, and the foot-pound is lb-ft of torque imperial units, 1lb = 0.4536kg; 1ft = 0.3048m, can be calculated 1lb-ft = 0.13826kgm.

扭矩在物理学中就是力矩的大小，等于力和力臂的乘积，国际单位是牛米Nm，此外我们还可以看见kgm、lb-ft这样的扭矩单位，由于G=mg，当g=9.8的时候，1kg＝9.8N，所以1kgm＝9.8Nm，而磅尺lb-ft则是英制的扭矩单位，1lb=0.4536kg；1ft=0.3048m，可以算出1lb-ft＝0.13826kgm。

The results of lattice beam internal force calculated method based on double parameter groundsill model are more approach the experiment measured values because of consideration of the pass of shearing force in soil, and its calculated workloads are similar with the method of winkler elastic foundation. Besides, the thesis also discusses the moment of torque affected results on node stress situation and the correction of stress value at the bottom of cross node of lattice beam. Due to the repeat calculation of node area during internal force calculation, the stress value of the bottom of beam is lower, this may lead the calculated value unsafe, but the corrected stress value will more approach to practical situation.

对格构梁的内力计算提出基于双参数地基模型的格构梁内力计算方法，其计算结果表明，双参数地基模型上的格构梁内力由于考虑土中剪力的传递更加接近于试验实测值，其计算工作量与winkler弹性地基梁法相当，此外，文中还探讨了扭矩作用对格构梁节点受力情况的影响结果以及格构梁交叉节点底部的应力值的修正，由于内力计算过程中节点处的面积被重复计算，使得梁底应力偏小，可能导致计算结果的偏于不安全，修正后的应力值更接近于实际情况。

In order to make cross joint type universal coupling long service life , puts forward setting up the torque examining system to control the torque, inspecting the position of input and output equipment to control the space position of the coupling and reduce the influence of additional force moment and control ling the balance force and the bearing clearance and so on, to avoid the coupling premature failure or shattering of the coupling.

为使十字轴式万向联轴器长寿命服股，提出了设置转矩测试系统控制转矩；通过监测输入及输出设备的位置控制联轴器的空间位置，以减少附加力矩的影响；控制平衡力及轴承间隙等技术控制措施，避免联轴器过早失效或损坏。

The electromagnetic torque and force were calculated with virtual displacement method. The friction torque was done with friction law. And then the output torque was calculated.

用虚位移法计算了电磁转矩和电磁吸力，用摩擦定律计算了摩擦转矩，进而计算出输出转矩。

The quadriceps force, tibiofemoral compressive force, tibiofemoral shear force and rotational torque were applied to intact and ACL sectioned knee specimen respectively.

然而，以往在尸体上进行的解剖学或生物力学的实验研究多未考虑对标本施加生理性负载，由此得出的结论与实际差距较大。

Transmitted torque was composed of magnetic force torque and viscosity torque. Maximal diameter of the actuator disk was key size to improving torque. Torque by unit moment of inertia decreases and viscous power loss increases with maximal diameter increasing.

机构传递的力矩由磁致力矩与粘性力矩构成，圆盘外径是提高传递力矩的关键尺寸；外径的增大会减少单位转动惯量所传递的力矩，增大粘性功率损失。

During same arc of motion, distance traeled by point on surface of 22-mm head, I, is less than on 32-mm head,II. A-B is shorter than E-F, and therefore leer arm of frictional torque force is less with 22-mm head.

在相同的活动度内，22mm头表面一点的滑动距离比32mm头小。A－B小于E－F：因此22mm头的摩擦扭矩力臂较小。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失