查询词典 torch holder

Trans-Blot Cells and Systems 170-3825 Trans-Blot Cell With Wire Electrodes and PowerPac HC Power Supply, 100120/220240 V, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm), power supply, power cord, instructions 170-3850 Trans-Blot System With Plate Electrodes and PowerPac HC Power Supply, 100120/220240 V 170-3853 Trans-Blot System With Plate Electrodes, Super Cooling Coil, and PowerPac HC Power Supply, 100120/220240 V, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm), power supply, power cord, instructions 170-3910 Trans-Blot Cell With Wire Electrodes, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm) 170-3939 Trans-Blot Cell With Plate Electrodes and Super Cooling Coil, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm) 170-3946 Trans-Blot Cell With Plate Electrodes, includes 2 gel holder cassettes, buffer tank, lid with power cables, 4 fiber pads, 1 pack precut blot absorbent filter paper (15 x 20 cm) Trans-Blot Cell Accessories 170-3912 Super Cooling Coil, required for all high-intensity transfers 170-3913 Gel Holder Cassette, includes 2 fiber pads 170-3914 Fiber Pads, 15.5 x 20.5 cm, 6 170-3920 Trans-Blot Standard Wire Electrode Card, cathode 170-3921 Trans-Blot Standard Wire Electrode Card, anode 170-3922 Trans-Blot Cell Buffer Tank 170-3923 Trans-Blot Cell Lid With Power Cables 170-3943 Trans-Blot Platinum Anode Plate Electrode 170-3944 Trans-Blot Stainless-Steel Cathode Plate Electrode 170-3945 Trans-Blot Plate Electrode Pair, platinum anode and stainless-steel cathode 16 规格:说明: Trans-Blot Plus

电泳转印槽组件 1。缓冲液槽及带有电缆的盖 2。凝胶支架转印夹 3。纤维衬垫 4。电极丝 5。电极板 6。特级冷却芯 Trans-Blot 转印槽是功能灵活的转印设备，可理想地用于多种转印应用。Trans-Blot 转印槽特点包括：*能进行多胶转印，可容纳3 块PROTEAN I xi 凝胶、6块Criterion 凝胶、12块Mini-PROTEAN 3 或Ready Gel 预制胶*多组参数灵活可设，可调节的电压设置（从30 V 的过夜转印到200 V 的1 小时快速实验）*电极间距设置为8 cm 用于标准印迹杂交，或设置为4cm 用于高强度印迹杂交*可选择板式电极：涂有铂金的钛作为正极，不锈钢为负极，能提供高强度电场和比其它电极更高的电流密度。或选择较经济的铂金电极丝*通过特级冷却芯和水循环仪来调节温度―是天然酶（4°C）或高强度转印的理想选择，随着转印时间增加（多达24 小时），不会引起缓冲液耗竭（在高强度转印中必须使用冷却芯，也推荐用于所有板式电极的应用）*带铰链的凝胶支架转印夹能避免滑动，确保凝胶与印迹膜间的紧密接触；每个转印夹都有颜色标记以保证在转印槽中的正确定位 Trans-Blot 转印槽的锁闭凝胶支架转印夹系统。转印夹（1）支撑凝胶（2）印迹膜（3）两侧有纤维衬垫和滤纸（4）确保凝胶三明治内的完全接触。凝胶夹垂直插入缓冲液槽中（5）。

Durable design Water-cooled Anti-collision sensors torch 100 percent contained occasional welding current maximum rate: 300A A high degree of mechanical stability Torch angle: 60 ° Torch Length: 314 mm 3.10.2 torch cable assembly Water-cooled, leather jacket, by the rapid joint connecting wire feeding machine and welding torch.

坚固耐用的设计水冷焊枪防碰撞传感器 100%暂载率最大焊接电流： 300A 高度的机械稳定性焊枪角度：60°焊枪长度：314毫米 3.10.2 焊枪电缆总成水冷式，真皮外套，由快速接头连接送丝机与焊枪。

If the blank is wrinkling on the blank holder surface, the cause is most likely one of four factors: insufficient blank holder force; a poor fit between the die face and blank holder surface; an equalizer block that is holding the die face apart from the blank holder surface; or severe blank holder deflection.

如果板料在压边面上起皱，绝大多数起因是后面四个因素之一：不充分的压边力；凹模和压边圈表面不良的匹配；凹模和压边圈间的平衡块；或者是压边圈的严重变形。

If the blank is wrinkling on the blank holder surface, the cause is most likely one of four factors: insufficient blank holder force; a poor fit between the die face and blank holder surface; an equalizer block that is holding the die face apart from the blank holder surface; or severe blank holder deflection.

如果展开平板在压边圈面上起皱，绝大多数起因是后面四个因素之一：不充分的压边力；凹模和压边圈表面不良的匹配；凹模和压边圈表面间的平衡块；压边圈的变形。

If the blank is wrinkling on the blank holder surface, the cause is most likely one of four factors: insufficient blank holder force; a poor fit between the die face and blank holder surface; an equalizer block that is holding the die face apart from the blank holder surface; or severe blank holder deflection.

褶皱起因于不充分的拉伸或失去控制的压缩变形。如果板料在压边面上起皱，绝大多数起因是后面四个因素之一：不充分的压边力；凹模和压边圈表面不良的匹配；凹模和压边圈间的平衡块；或者是压边圈的严重变形。

Ran through the Olympic torch, the host country often in the last paragraph in the distance, the arrangement with the characteristics of representative figures, such as winning glory for the country's Olympic gold medallists, in the fanatical appreciation of the audience before holding high the torch, Raochang A week later, Taiwan torch lit torch run.

然借着奥林匹克火炬，各主办国常在最后一段路程中，安排具有代表性与特色的人物，如为国争光的奥运金牌选手等，在狂热赞赏的观众前高举火炬，绕场一周后，跑上圣火台点燃圣火。

Beijing Olympic Torch in Sanya, the chief of 30.09 km transmission line will be shown in Sanya in the development of new take-off of Landmark, known as Sanya Olympic Ark of the Phoenix home port on the island of "Fire Phoenix Plaza" at the starting line ceremony, lit in Transfer the first torch, the torch will then along the torch after Gao Qing-feng new bridge - the world held elections beautiful Miss crown - Welcome Road - on River Bridge - on the Square - Haihong Square - Tianya Bay Beach - Tianya stone plaza.

北京奥运圣火在三亚的传递路线总长30.09公里，将在昭示着三亚发展新腾飞的地标、被誉为三亚奥运方舟母港的凤凰岛上的&火凤凰广场&举行起跑仪式，点燃境内传递的第一支火炬，随后火炬手们将高擎火炬沿途经过新凤桥—举办过世界性小姐选举的美丽之冠—迎宾路—月川桥—海月广场—海虹广场—天涯湾沙滩—天涯石广场。

In Shenyang, by Chinese adolescent network association is sponsorred, the Olympic Games " torch relay " the city is participated in undertake " network torch transfers an activity ", came on March 24 on August 8, with the Olympic Games " torch relay " undertake at the same time; Regard the Tecent of instant chatting tool as QQ, also roll out on official webpage " torch is online deliver " webpage.

在沈阳，由中国青少年网络协会主办，奥运会&火炬接力&城市参与承办的&网络火炬传递活动&，在3月24日至8月8日，与奥运会&火炬接力&同时进行；作为即时聊天工具的腾讯QQ，也在官方网页上推出&火炬在线传递&网页。

To adopt band type rail rolled by stainless steel and chain type drive method run circumferential movement along with the pipe to be cut by flame cutting carriage,cutting torch will run radial movement driven by ball bearing screw by step motor along with the pipe to be cut,the above two dimension movement compose to inclined cutting movement of cutting torch,the inspection of circumference position of cutting torch,the determination of radial position and return point of cutting torch all controlled by SCM.

为了满足钢管斜截切割的要求，建立了钢管斜截切割的数学表达式，采用不锈钢轧制的带形轨道和链式传动的方式使火焰切割小车沿被切钢管做周向运动，割炬沿被切钢管的轴向运动由步进电动机带动滚珠丝杠完成，上述两维运动合成为割炬的斜切运动，割炬周向位置的检测、割炬轴向位置及折返点的确定均由单片机控制完成。

At same time there are torch holder on the torch carriage, which can be directly adjust to move up and down flexibly to avoid the damage on torch carriage when collision happens.

同时移动体具有夹持器，也可以直接灵活地上下运动，可防止因碰撞而损坏割炬移动体。

Metrorrhagia is also gynaecological problems of common diseases.

崩漏是妇科常见病也是疑难症。

WordFTP gives you the convenience and timesaving you need.

wordftp让您的方便和省时您所需要的。