查询词典 to calcine

Therefore, new technology of using acetylene sludge to calcine clinker will be discussed in this article.

所以本文对利用电石渣煅烧水泥熟料的新工艺进行了研究。

The main object of this research is to investigate synthesis of Cu23Cl Cu and CuO nanoparticles through electrospinning and heat-treated method The research is mainly focused on preparative parameter and the change of heat-treated temperature to form the nanoparticles inlaid in silicon fibers the shape and color change are dicussed First of all to prepare the Polyvinyl butyral and silica dioxide complex nanofiber by electrospinning and then to investigate different heat-treated temperature and reactive time to being an influence on the products The results detected by SEM XRD TEM EDS FTIR combined sol-gel process and electrospinning can prepare Polyvinyl butyral and silica complex nanofiber The experimental result is found when heat-treated temperature is 100~4750C it can produce Cu23Cl nanoparticles; Above 4750C~ 4900C it can produce Cu nanoparticles; Above 450~7000C it can produce CuO nanoparticles And the viscosity is lain between 20~40cp and the sol-gel process time is 3hr it can produce the thinner fibers The average diameter of the fibers are 107 88±21 01nm;Due to the nanoparticles inlaid in the silica fibers the thinner fibers can be inlaid the smaller nanoparticles so this is the result that the experiment is expected To calcine the complex fibers is to produce surface silica fibers contain Cu23Cl Cu and CuO nanoparticles due to surface plasma resonance it make the color of the fibers become yellowish green from light white green turn into the red nuclear finally As the experimental result to utilize sol-gel process combine electrospinning can produce porous silica fibers contain Cu23Cl Cu and CuO nanoparticles

本研究旨在探讨「利用放电纺丝和热处理法来合成Cu23Cl、Cu和CuO奈米粒」之研究，实验著重在制备参数与热处理温度变化对所形成的奈米粒镶嵌在二氧化矽纤维中的形态与颜色变化探讨。首先，利用放电纺丝法制备出聚乙烯醇缩丁醛及二氧化矽之奈米纤维，比较不同的热处理温度与反应时间的改变对产物生成产生影响，进而研究不同热处理温度和时间对生成奈米粒的影响。产物经由SEM、XRD、TEM、EDS和FTIR等仪器分析结果显示，结合溶胶-凝胶法(sol-gel process)和放电纺丝法可产生聚乙烯醇缩丁醛及二氧化矽复合奈米纤维。实验结果发现，若热处理温度在100~4750C下可得到Cu23Cl奈米粒，475~4900C 可得Cu奈米粒，450~7000C以上可得 CuO奈米粒。而黏度介於20~40cp间和溶胶-凝胶时间为3hr时，可产生直径比较细的纤维，纤维直径为107 88±21 01nm；且由於奈米金属颗粒镶嵌在二氧化矽纤维中，直径比较细的纤维，可以得到比较小的奈米金属颗粒，这与实验预期相符。而锻烧此复合物产生多孔的二氧化矽纤维并包含Cu23Cl、Cu和CuO奈米微粒时，由於表面电浆子共震关系，而使纤维颜色由淡白黄绿色变成黄绿色，再变红褐色。由实验结果得知，利用溶胶-凝胶法(sol-gel process)结合放电纺丝法和不同热处理温度，可产生Cu23Cl、Cu和CuO奈米粒镶嵌在二氧化矽纤维。

In order to calcine calcium carbonate fines, the technique of high-temperature pelletization has successfully been used

为了煅烧碳酸钙细粉，已经成功地应用了高温成球技术。

The organic calcium can be acquired by two ways: one is to calcine, and the other is to add organic acid into eggshell power directly. The eggshell is a good source of calcium in food, and has broad development prospects.

通过煅烧法和直接反应法可以将蛋壳中的碳酸钙转化为有机酸钙，蛋壳是一种很好的食品级绿色钙源，发展前景广阔。

Mix materials with broken bauxite and coal gangue as chief raw materials are prepared according to requirement chemical composition of mullite grogs,then to mill, filtrate, dry, mold, desiccate and calcine the mix materials, finally to measure the properties of the synthetic materials.

按照莫来石料的化学组成要求，以铝矾土和煤矸石为原料，配制成混合料，然后分别经磨细、过滤、烘干、成型、干燥、煅烧工艺后，测定合成料的性能。

As it is difficult to observe the calcine status and to colligate and analyze lots of craftworks parameter in time, and to note and contrast well and truly abundant data in the kiln, it is necessary to carry out detection online continuously and real time aiming to the material quantity and temperature in the cement kiln, utilizing multimedia technology which links the theory of computer and image-disposal and radiate diathermancy.

针对水泥回转窑生产中难以定量观察封闭窑体内的煅烧状况；难以及时综合分析大量的工艺参数；难以准确记录对比大量数据等问题，利用多媒体技术将计算机与图像处理理论、辐射传热理论相结合，实现连续实时对水泥回转窑烧成带物料量和温度的在线检测。

Chinese codex (2000 edition) said that processing of ruddle is to calcine it thoroghly and quench with vinegar and grind it into meal.

《中国药典》2000年版规定，对代赭石的炮制要用"煅至红透，醋淬，碾成粗粉的方法"。

Some new technological measures,such as new reactors,gel method to remove silicon,direct dissolve acid to recrystallizate and direct calcine from zirconyl chloride,were used to reform zirconium dioxide production process.

文摘：采用新型反应器及胶凝除硅、直接酸溶重结晶、直接煅烧等技术对二氧化锆的生产工艺进行了改革，降低了原材料消耗及能耗，减少了废液排放量，并将回收的废物加工成副产品白炭黑，在生产过程中防治污染。

A new technology of direct fluidizing calcination for FGD gypsum is introduced in this paper. The technology is able to calcine FGD gypsum homogeneously, to control the quality easily, to produce plaster with high compressive strength and bending strength.

综合国内外石膏焙烧技术的发展，并结合脱硫石膏的物性特点，以及一定的焙烧实践经验，本文介绍了一种新型的脱硫石膏直接流化焙烧技术，该技术具有物料受热均匀、产品质量易控制、焙烧设备运行可靠等特点，通过该技术所焙烧的建筑石膏相均匀性好，强度高。

To obtain sulphuric acid, Cyrus Harding had only one operation to make,to calcine the sulphate of iron crystals in a closed vase, so that thesulphuric acid should distil in vapor, which vapor, by condensation, wouldproduce the acid.

赛勒斯·史密斯制造硫酸的最后一道工序，是把硫酸铁的结晶密封在瓶子里，进行锻烧，使之蒸发为水汽，经过冷却，就可以变成硫酸了。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。