查询词典 tip over

The main research tasks and results are as follows:(1) Through comparing the stress intensity factor of compact tension specimen calculated by finite element software with the theoretical value, the feasibility of calculating fracture parameters of crack tip in ABAQUS software was verified.(2) The relationship between the elastic modulus of the material and research scale was studied based on deriving the cohesive stress theory and other relevant theories. And the elastic modulus of the material on meso-scale was determined.(3) Global model and sub-model of the finite element were built in th...e macro-scale, and stress-strain field nearby the crack tip was analyzed, and the results show that the detailed stress-strain in the crack tip could be obtained by using the sub-model technique.(4) In meso-scale, the crack growth model was also established by assuming the crack propagating along the grain boundary, and the detailed stress-strain field in the crack tip was obtained.(5) The effect of crack length on Von Mises stress, and maximum principal stress and strain was analyzed in meso-scale when equivalent KI equals 30MPa.m1/2. And the results show that except for crack tip area, the stress-strain distribution in whole specimen is not affected.

主要完成研究内容和取得成果如下：(1)利用有限元软件计算出紧凑拉伸试样的裂纹尖端应力强度因子KI值，其结果与理论值一致，从而验证了利用ABAQUS计算裂纹尖端相关断裂参量的可行性；(2)在研究内聚应力等相关理论的基础上，推导出了研究尺度与材料弹性模量的近似关系，并确定了介观尺度上的弹性模量；(3)在宏观尺度上建立了全局有限元计算模型和子模型，得到了裂纹尖端应力应变场分布，结果表明利用子模型技术获得比较准确的裂纹尖端应力应变场分布是可行的；(4)在介观尺度上利用平均晶粒尺度的方式建立了裂纹沿晶扩展模型，得到了裂纹尖端断裂过程区的微观应力应变场；(5)当应力强度因子为30MPa.m1/2时，分析了介观尺度上在裂纹沿晶扩展过程中裂纹长度对Mises应力、最大主应力和应变的影响，结果表明，裂纹扩展长度对试样整体应力应变分布影响不大，而对裂纹尖端区域有较大影响；(6)介。。。

Common reasons for modifying these structures are to change tip projection, alter tip rotation, decrease the distance between the tip-defining points, reduce tip fullness, create a supratip break, and adjust the relationship between the columella and the alar rims.

改变这些结构的常见原因是为了改变鼻尖突出度，改变鼻尖旋转度，缩小鼻尖表现点之间距离，缩小肥厚鼻尖，形成鼻尖上区转折和调整鼻小柱和鼻翼环之间的关系等。

A calculation method for the ultimate tip resistance of rock socketed pile was conducted. The geostatic stress of soil and rock was considered as homogeneous load on the tip plane of the pile, and then the force of the pile tip was decomposed into some simple forces. According to the theory of slipping line, the most dangerous point on the tip plane of the pile was confirmed, and the stress of the point was obtained according to Mindlin solution.

为求出桩端极限承载力的表达式，本文将嵌岩段以上岩土层自重视为作用在基岩半平面上的均布荷载，把桩端合力分解为相对简单的荷载作用于基岩平面上，利用滑移线理论并通过叠加的方法分析出桩端基岩破坏时的最危险点。

The numerical results show that:(1) the throughflow wake is considerably influenced by the tip clearance. The low-kinetic-energy fluid accumulated in the shroud/pressure side of the unshrouded impeller, but in the shroud/suction region for 0.0 tip clearance;(2) there possibly exists an optimum size of the tip-clearance which is not the zero tip clearance to make the flow loss minimized.

研究结果表明，(1)NASA低速大尺度离心压缩机半开式叶轮的低速尾迹区在压力面与轮盖的角区，而相应的闭式叶轮的低速尾迹区聚集在轮盖的中心位置；(2)数值实验表明，叶顶间隙并非越小越好，可能存在一个最优间隙，使得叶轮流动损失最小。

The airfoil (18) includes a tip cap (32) extending between the pressure (20) and suction (22) sidewalls; and spaced-apart suction-side (34) and pressure-side tip (36) walls extending radially outward from the tip cap (32) to define a tip cavity (38) therebetween.

在压力侧壁(20)和抽吸侧壁(22)之间延伸着一个顶端盖(32)，从该顶端盖(32)沿径向向外延伸着互相间隔开的抽吸侧顶端壁(36)和压力侧顶端壁(34)，在它们之间形成一个顶端凹腔(38)。

It is indicated that this loss will not change with the increase of the Reynolds number but the intensity of the passage vortex increases with the decrease of the Reynolds number. The tip leakage flow will weaken with the increase of the passage vortex because of the interaction between the passage vortex and the tip leakage vortex, and the position of the tip leakage vortex is more close to the middle of the passage. In addition, the distributions of the total pressure loss and the flow angle at the exit of the cascade are influenced by the intensity and the position of the tip leakage vortex.

结果表明：对于间隙存在造成的流动损失，数值模拟结果与实验结果及 Denton的预测值都十分接近，基本上不随着雷诺数的变化而变化；但是，随着雷诺数的减小，通道涡增强；间隙泄漏涡在和通道涡的相互作用中，强度减弱，在叶栅出口处的位置更加靠近中叶展；出口处的总压损失和气流角的分布也由于间隙泄漏涡强度和位置的变化而发生改变。

Turn over, tip over, tump over同义词:tip over, turn over, upset, knock over, bowl over, tump over同义词:overrule, override, overthrow, reverse4. cause the downfall of; of rulers同义词:overthrow, subvert, bring down同义词:revoke, annul, lift, countermand, reverse, repeal, rescind, vacate

本站所收集信息资料为网络转载版权属各作者并已著明作者旨在资源共享、交流、学习之用，请勿用于商业用途，本站并不保证所有信息、文本、图形、链接及其它内容的绝对准确性和完整性，故仅供访问者参照使用。

The main contributions of the second part of this dissertation are focused on the cryptographic properties of logical functions over finite field, with the help of the properties of trace functions, and that of p-polynomials, as well as the permutation theory over finite field: The new definition of Chrestenson linear spectrum is given and the relation between the new Chrestenson linear spectrum and the Chrestenson cyclic spectrum is presented, followed by the inverse formula of logical function over finite field; The distribution for linear structures of the logical functions over finite field is discussed and the complete construction of logical functions taking on all vectors as linear structures is suggested, which leads to the conception of the extended affine functions over finite field, whose cryptographic properties is similar to that of the affine functions over field GF (2) and prime field F〓; The relationship between the degeneration of logical functions and the linear structures, the degeneration of logical functions and the support of Chrestenson spectrum, as well as the relation between the nonlinearity and the linear structures are discussed; Using the relation of the logical functions over finite field and the vector logical functions over its prime field, we reveal the relationship between the perfect nonlinear functions over finite field and the vector generalized Bent functions over its prime field; The existence or not of the perfect nonlinear functions with any variables over any finite fields is offered, and some methods are proposed to construct the perfect nonlinear functions by using the balanced p-polynomials over finite field.

重新定义了有限域上逻辑函数的Chrestenson线性谱，考察了新定义的Chrestenson线性谱和原来的Chrestenson循环谱的关系，并利用一组对偶基给出了有限域上逻辑函数的反演公式；给出了有限域上随机变量联合分布的分解式，并利用随机变量联合分布的分解式对有限域上逻辑函数的密码性质进行了研究；给出了有限域上逻辑函数与相应素域上向量逻辑函数的关系，探讨了它们之间密码性质的联系，如平衡性，相关免疫性，扩散性，线性结构以及非线性度等；讨论了有限域上逻辑函数各类线性结构之间的关系，并给出了任意点都是线性结构的逻辑函数的全部构造，由此引出了有限域上的"泛仿射函数"的概念；考察了有限域上逻辑函数的退化性与线性结构的关系、退化性与Chrestenson谱支集的关系；给出了有限域逻辑函数非线性度的定义，利用有限域上逻辑函数的非线性度与相应素域上向量逻辑函数非线性度的关系，考察了有限域上逻辑函数的非线性度与线性结构的关系；利用有限域上逻辑函数与相应素域上向量逻辑函数的关系，揭示了有限域上的广义Bent函数与相应素域上的广义Bent函数的关系，以及有限域上的完全非线性函数与相应素域上向量广义Bent函数之间的关系；给出了任意有限域上任意n元完全非线性函数存在性与否的完整证明，并利用有限域上平衡的p-多项式的性质给出了有限域上完全非线性函数的一些基本构造方法。

This is the same as the "batching" tip from the work section above (as is the previous tip, and the next tip).

这和上面工作部分的批量处理的道理是一样的（这和前面的建议以及后面的建议是一致的）。

The detailed comparisons between the higher—order near tip solution and the well—known modified Prandtl field are also given in this paper.For the compressible materials, in order to satisfy the higher-order compatibility equation of the rate of deformation in the centered fan sector, which is a quite difficult problem unresolved in the previous studies, a particular term must be added to the expansions of the stress components in the regular logarithmic power series adopted by many researchers before. A higher-order near tip field with tangential velocity jump ahead of the crack tip is derived first, of which the dominant terms are the solution widely accepted.

对可压缩材料，本文首先采用非规则的对数幂级数渐近展开方法，克服了过去研究中存在的中心扇形区变形率协调方程的高次渐近式不能被满足的困难，并得到了一个切向速度在裂尖前方存在间断的高阶渐近解，该解的主项就是目前被广泛接受的关于可压缩材料的尖端场解。

More direct, directer ; most direct, directest

径直的，笔直的

Do you know how to use a chain saw?

你知道如何使用链锯吗？