查询词典 time

At the same time, on the base of analysis of the present situation, the development trend and the leading edge technology, the necessity and feasibility about the exploitation of the full hydraulic bulldozer"s sate monitoring and fault diagnosis system is given; According to the structure, working feature and working environment, it works out system schema and system composition; The system is divided into display module, communication module and fault diagnosis module by means of block design, the implementation method and key parameter are also given; In light of the features of the full hydraulic bulldozer, the state monitoring and fault diagnosis platform composed of controller RC6-9 and display DI2/10 is designed based on CAN-Bus and the hardware design is completed; It lists the measured values and state of monitored parameters which should be real-time displayed in monitoring module as well as the data which will be transmitted; Furthermore, On the base of the study of, it gives 34 kinds of constant faults" diagnosis methods; Using BODAS software and DPS software, it compile the program code of the controller and the displayer; At last, this paper design and make the simulation test device of control system of construction machinery, through the experiment, the realizability, the categoricalness, the reliability, the stability and real-time are tested, in addition, the improved methods are given.

本文收集整理了国内外智能推土机研究的相关文献资料，综合分析了国内外智能推土机的研究现状、发展趋势和前沿技术，论证了开发全液压推土机智能系统的重要组成部分&全液压推土机状态监测与故障诊断系统&的必要性和可行性；根据全液压推土机的结构、作业特点和作业环境，制定了全液压推土机状态监测与故障诊断系统方案，确定了系统的结构组成；采用模块化设计方法，将整个系统分成了显示、通信和故障诊断三个模块，给出了各模块功能的实现方法，确定了各模块的关键技术参数：选用RC6-9和DI2／10作为系统的控制器和显示器，用CAN总线搭建了系统的通信平台，完成了系统的硬件设计；确定了系统监测参数和通信数据，对全液压推土机常见故障特征进行了分析，给出了34种常见故障的诊断方法；在BODAS软件和DPS软件的集成编程环境下，编写了控制器和显示器程序；设计并制作了工程机械控制系统模拟试验板，并在此基础上通过多次的程序调试与试验，对所设计的全液压推土机状态监测与故障诊断系统功能的可实现性、完备性、可靠性、稳定性和实时性进行了检验，证实了此系统的可行性，并提出了进一步的改进方案和措施。

The results showed: for the toxicity of two kinds of pollutants, the Cd(superscript 2+) is more poisonous that the Pd(superscript 2+). For the sensitivity to the pollutants, the P. caudatum, C cathayensi and D. japonica increase evidently in turn. The statistical analyses indicated that the single and combined toxicity effects both increase with the exposed time extended, especially for the combined toxicity (P.05), showing a marked time-effect relation. As for the single effect, ii increase prominently with Pb(superscript 2+) and Cd(superscript 2+) concentrations (P.05); But in the case of binary effect, the results showed obviously a time-effect (P.01) as well as a concentraction-effect relations.

结果表明：在同等条件下，Cd(上标 2+)对三者的致毒效应都明显强于Pb(上标 2+)；3种动物中，草履虫最敏感，而圆田螺耐受能力最强；随单一毒物浓度的增大以及暴露时间的延长，两者的致毒效应都显著增大，表现出明显的浓度－效应和时间－效应关系；二者复合作用时，对3种动物的致毒效应主要表现为与二组分的浓度比例有关。

Along with the mining industry declining, the settlement distribution, the population aging (in 96 year Tongshan Village old person ratio nearly 30%) with industrial reforming, under such environmental chane, Japanese Colonial Periodaround the time, the gold ore prosperous time, after the Recession of Taiwan in the recovering time historical vein, the substantive space, how does the social space's change live regarding the place maintains with is balanced; How between the reciprocity to achieve settlement old person each other's interaction and the familiar environment?

随著矿业的没落，聚落的分布，人口的老化(96年铜山里老人比率近30%)与产业的转型，在这样的环境变迁下，日治时期前后、金矿兴盛时期、光复时期之后的历史脉络里，实质空间、社会空间的改变对於地方之居住如何相维持与平衡；相互关系之间如何达到聚落老人彼此的互动与熟悉的居住环境？

Preparation of the cathode includes:shaping under the press of 40Mpa, sintering at 550℃for 1 hour and at 900℃for 8 hours and threading with molybdenum bar; Considering the literatures we choose CaCl2 as salt for preparation titanium. Pretreatment of salt is for 1 hour at 100℃and for 2 hours at 300℃. Partial pressure of oxygen which need lower than 5.11×10-7Pa to reduct titanium oxides and hygroscopic property of salt need a sealed equipment to electrolyse. And finally successfully designed a satisfied one and the results show that the equipment can be satisfied the requirment of the experiment. Flow of the inert gas is 1.5L/min, the voltage is 2.8 V, temperature is 850℃and time is 2 hours during pre-electrolysis. Flow of the inert gas is 0.2L/min, the voltage is 3.1 V, temperature is 900℃and time changes with the mass of TiO2 during electrolysis, namely the greater need the longer time; To eliminate influence of salt and other impurities, the products need to wash with distilled water and dilute chlorhydric acid , then wash with dilute hydrochloric acid under supersonic wave assistant. Finally, electrometical properties of the electrolysis of TiO2 is researched by cyclic voltammetry and chronoamperometry, and results show that there are two main reodox steps, namely from TiO2 to TiO and from TiO to Ti.

阴极制备主要包括40MPa压力下模压成型、两段式烧结(1小时内升至550℃保温1小时，再1小时升温至900℃保温8小时)及烧结后TiO2块打孔用钼棒串接三个主要环节；实验中选用CaCl2作为电解熔盐，并对其进行预处理(100℃，保温1小时； 300℃，保温2小时)；经热力学计算，还原钛氧化物的氧分压至少要低于5.11×10-7Pa，结合电解过程中所用熔盐CaCl2有极强的吸水性的特点，电解装置应有较高的密封性，自行设计了一套密封性可靠的电解装置，便于实验过程中熔盐预处理和氧分压的控制；通过干燥处理预电解过程中Ar流量大约为1.5L/min、电压为2.8 V、温度为850℃、时间为2小时，电解过程中Ar流量大约为0.2L/min、电压为3.1V、温度为900℃，实验结果表明电解时间与TiO2质量密切相关，质量越大需要电解的时间越长；通过自来水冲洗—稀盐酸浸泡、洗涤—在超声波辅助作用下稀盐酸洗涤，可减少熔盐及其它杂质对电解产物检测结果的影响；最后，通过循环伏安法、计时电流法对电解机理的研究，确定电解还原TiO2制备金属钛主要经历了TiO2-TiO-Ti的过程。

The overview is in 20 centuries before 90 time the methane chloride of our country production basically uses conventional technology, but all sorts of craft lag behind quite mostly, begin to change methanol chloridize technology in succession from 90 time, but the technical level at that time and foreign photograph are older than difference, main show is dimensions quality of tall, product needs small, specific power consumption," 3 useless " big, equipment corrodes discharge capacity to wait for a problem badly.

梗概： 概述在20世纪90年代以前我国的甲烷氯化物生产主要采用传统技术，但各种工艺大多比较落后，自90年代开始纷纷改走甲醇氯化工艺，但当时的技术水平和国外相比差距较大，主要表现为规模小、能耗高、产品质量差、&三废&排放量大、设备腐蚀严重等新问题。

Bergson's critique of chronometric theories of time argued for psychological time as duration – an argument in which time equals space.

柏格在对时间精确计时理论的批判中讨论心理学时间是一段持续的时间，这是一场将时间和空间等同的讨论。

Of difference of Japanese economy area contractible and main happen in 60, 70 time, expand somewhat instead in 80 time, 90 time is main as a result of bubble economy undone narrow somewhat again.

日本经济区域差异的缩小主要发生在60、70年代，在80年代反而有所扩大，90年代主要由于泡沫经济的破灭又有所缩小。

The reliability of analysis result depends largely on the in-house experimental conditions. Unlike the previous analysis that only concerns the sole effect of permeable pressure, this article considers both permeable and confining pressure and deformation characteristics of concrete material under the interaction of them according to the real work state of construction, which may leads to the changing pattern of permeable rate as listed below: permeable rate always reaches its peak with the time process going on, than goes down and remains straight on some certain value; The PR will tend to decline while the confining pressure is increased, and the time taken before the peak will be extended as well; Under the constant permeable pressure and circularly changing confining pressure, the minus-exponential ascend and descend relationship could be applied between the PR and Time axes respectively with crannied and intact concrete samples, and the PR of crannied concrete is far more larger than that of intact concrete. The change pattern of concrete could also be mathematically analogized using the least square method.

室内的实验条件是研究成果可靠性的重要因素，而以往的研究都只考虑了渗透压单一作用，本文根据混凝土结构的实际工作状态，同时考虑了围压与渗透压共同作用下的混凝土材料的渗透性变化特征，得出了混凝土材料在围压作用与渗透压共同作用下的渗透率的变化规律：渗透率都是随时间推移先达到一个峰值，再降低并趋于平稳；渗透率会随围压的增大而减小，并且峰值的到达时间也会随之延长；在渗透压不变，围压升降循环的情况下，有裂缝、无裂缝混凝土的渗透率变化规律是随时间成负指数关系上升、下降，且有裂缝混凝土试件的渗透率远远高于无裂缝混凝土的渗透率，并对混凝土的变化规律运用最小二乘法进行数学拟合。

The longest time was 22 months.the shortest time was 12 months. Conclusion The extraction planing of missing the first molars in class Ⅰmalocclusion is different from routine extraction mode.This clinical study indicated that it should chose nimble planing and for decurtate treatment time,according to arch crowding, profile and existing of the third molars.

第一磨牙缺失的患者在I类错牙合畸形中的拔牙模式有别于常规，要根据患者牙弓的拥挤程度，面型突度及有无第三磨牙等情况选择治疗计划和有利于缩短疗程的矫治方法。

E. , to improve its real-time response speed, remove its priority inversion inside the kernel, and eliminate the nondeterministic time delay introduced into a running real-time process due to resource contension so as to enhance determinability in the kernel.

作者在归纳、分析的基础上，首先提出操作系统实时化的指导原则，即提高系统的实时响应速度，消除操作系统核心内部的优先级反向，及进程在执行过程中由于资源竞争而给程序执行引入的不确定时间延迟，提高系统的确定性。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐