查询词典 time-base control

According to the characteristics of gas-collector pressure and suction-control of blower system for coke oven in Xiangtan iron and steel company, primary system is developed. Fuzzy control technology and routine PID technology are combined, and the control method of the pressure of gas collector in coke oven is given based on the fuzzy theory ,then decoupling control is adopted for coupling phenomenon.

针对湘钢焦炉集气管压力和鼓冷系统吸力控制特点，对原有系统进行改造，将模糊控制技术和常规PID控制技术相结合，提出了一种基于模糊理论的焦炉集气管压力控制方法，结合相邻通道的波动引起的耦合现象，采用模糊解耦原则进行解耦控制。

According to the characteristics of gas-collector pressure and suction-control of blower system for coke oven in Xiangtan iron and steel company, primary system is developed. Fuzzy control technology and routine PID technology are combined, and the control method of the pressure of gas collector in coke oven is given based on the fuzzy theory ,then decoupling control is adopted for coupling phenomenon.

中文摘要：针对湘钢焦炉集气管压力和鼓冷系统吸力控制特点，对原有系统进行改造，将模糊控制技术和常规PID控制技术相结合，提出了一种基于模糊理论的焦炉集气管压力控制方法，结合相邻通道的波动引起的耦合现象，采用模糊解耦原则进行解耦控制。

The oil pump control system of governor oil pressure unit at power plant of Naban reservoir was modified with contact-free,soft start,intelligent pressure control unit,which not only remove the defects from traditional oil pump motor control mode consisting of relay and contactor,but also upgrade the control automation degree,improve starting performance and permit convenient operation.

通过利用无触点的智能软启动压力控制装置对那板水库电站调速器油压装置油泵控制系统的改造，解决了油泵电动机采用传统继电器———接触器控制方式所存在诸多缺陷，提高控制的自动化程度，改善启动性能，方便操控，经过3年多的应用，运行良好，为水电站的调速器油压装置油泵控制提供了一个好的借鉴。

Other methods of financial control mainly have authorization control, inner diversion, quota control, progress chart control.

然后提出了是否通过授权分散财务控制权的决策分析方法，集团公司剩余财务控制权、特定财务控制权分配的决策分析方法。

This paper summarizes the Shanghai Xinhua latest generation of network-based automatic control system- TiSNet-XDC800 in the application of boiler control of the Shenzhou woolen mill; the boiler control system's components are introduced, and analysis of the application of servo motor control in the project, and gives the final operation results; Finally, a review of the application XDC800 at the scene is done.

新华控制技术有限公司，上海 201108摘要：概述了上海新华集团最新推出的新一代基于网络的自动化控制系统—TiSNet-XDC800在申洲毛纺厂锅炉控制中的应用。介绍了锅炉控制系统的构成，重点分析了XDC800对伺服电机的控制策略和现场控制效果。最后对XDC800在现场的应用进行了总结。

Quasi-constant torque control is used when the speed is lower than 125 km/h, and constant power control is applied when the speed is higher than 125 km/h. Direct rotor flux oriented control system is employed and three-level neutral point clamped traction inverter with SVPWM control is adopted.

在速度低于125km/h采用准恒转矩控制，速度高于125km/h采用恒功率控制，采用直接转子磁场定向控制系统，牵引逆变器采用空间电压矢量控制的带中点钳位二极管的三电平拓扑结构。

The total proteins from TGIF transfectant and vector control cells were separated by 2D electrophorosis. 760±41 and 680±38 spots were detected in TGIF transfectant and vector control cells respectively. Locus repeat analysis of protein spots showed that the mean deviation in IEF direction in TGIF transfectant and vector control cells were 0.864±0.123 mm and 0.843±0.115 mm respectively whereas the mean deviation in SDS-PAGE direction in these two cells were 0.812±0.109 mm and 1. 125±0.123 mm respectively. So the well-resolved and reproducible 2DE patterns from TGIF transfectant and vector control cells were established.

通过双向凝胶电泳分别分离TGIF转染细胞和PcDNA3.1空白质粒转染细胞的总蛋白质，测得两组细胞的蛋白质斑点数分别为760±41和680±38个；位置重复性分析表明TGIF转染细胞在等电聚焦方向上的平均偏差为0.864±0.123mm，在垂直板SDS-PAGE电泳方向上的平均位置偏差为0.812±0.109mm；PcDNA3.1空白质粒转染细胞在IEF方向上的平均偏差为0.843±0.115mm，在垂直板SDS-PAGE电泳方向上的平均位置偏差为1.125±0.123mm。

Advanced optimum control scheme was presented after the analysis of shortage in traditional three wash control scheme of boiler water level. In the new control scheme, the pressure of steam was used to be a complement control parameter.

分析了传统三冲量锅筒水位控制方案的不足，引入压力参数作为补充控制量，提出了改进的优化控制方案。

With strong technical force, high-quality staff team and the courage to open up the spirit of technology, Anton has developed a series of international advanced level of intelligent instruments and meters, the main products are: LU-900M Series can adjust the temperature control device, LU-R / C Series process control logger, LU-190 Series Intelligent Power Detector, LU-C Series pressure transmitter, LU-A/B/AB Series°¤with electrical isolation, LU-50 Series Intelligent Flow Totalizer Miriam count, JKH phase-shifting flip-flop, DP series digital current and voltage table, a type of temperature control cabinet, ANTHONE DCS Distributed Control System.

凭借雄厚的技术力量、高素质的员工队伍和勇于开拓技术的精神，安东公司开发出了一系列具有国际先进水平的智能仪器仪表，主要产品有：LU-900M系列只能温度控制调节仪、LU-R/C系列过程控制记录仪、LU-190系列智能电力检测仪、LU-C系列压力变送器、LU-A/B/AB系列隔离安全栅配电器、LU-50系列智能流量积算仪、JKH移相触发器、DP系列数字电流电压表、个类型温度控制柜、ANTHONE DCS集散控制系统。

S7-200 PLC can control frequency converters, sensor and stepping motors is introuced. This control system can implement initiative tub wheel closeloop speed control, passivity tub wheel strength control.

介绍了S7—200PLC在电缆对缠机中实现对变频器、传感器、步进电机三者的协调控制，从而实现了其主动鼓轮的速度闭环控制和被动鼓轮的拉力闭环控制。

Finally it offers the analysis of the fault-tolerance system as well as its test verification.

这样，运行于空间环境中的系统的设计目标就是在保证系统实时性

However, it is still difficult to find out the real reason of the increase of the keratinized gingiva during the orthodontic extrusion whether it is due to the proliferation of the gingival tissue or to its elastic nature, that is because the proliferation of the fibroblasts as well as the connective tissue changes in volume and the intra-fibers spaces were all immeasurable in most of the studies.

然而，仍然难以找到真正的原因增加的角化牙龈在正畸挤压它是否是由于扩散的牙龈组织或其弹性性质，这是因为增殖的成纤维细胞以及作为结缔组织的变化量和内部纤维空格都是不可估量的，大多数的研究。