查询词典 throttling valve

This less restrictive flow path design improves flow while maintaining the same excellent throttling characteristics as a globe valve.

这种结构对流道的阻力较小，从而在保持截止阀具有相同的节流性能的基础上改善了截止阀的介质流动性。

If uneven pressure should cause the regulator to pulsate, its action can be stabilized by throttling the valve.

如果压力不稳定，会导致调节阀跳动，对这种阀门进行节流可以稳定系统压力。

This is because the sleeve valve is throttling the form of improved stability and maintenance of better than single-seat valve, but it's weight, aiming to halt and leakage targets with single-seat valve in line, how can it replace the single-seat valve it?

这是因为套筒阀只是改进了节流形式、稳定性和维护好于单座阀，但它重量、防堵和泄漏指标上与单、双座阀一致，它怎能取代单、双座阀呢？

Downhole throttling technology is to adjust downhole pressure through installing the throttle valve in an appropriate position on the tube. The gas flowing through the throttle valve is heated up by the geotherm and the conditions of gas hydrate formation are changed, so as to effectively prevent gas hydrate formation, decrease transportation pipeline pressure, eliminate attemperator, and reduce the cost of gas production.

井下节流技术将井下节流器置于油管某一适当位置来实现井筒节流降压，并充分利用地热对油管内流体加热，使节流后气流温度高于节流后压力条件下的水合物形成初始温度，从而达到降低地面管线压力，取消地面加热保温装置、降低气井开采成本的目的。

With the reasonable hypotheses to the configuration of the desuperheater and pressure reducer, the mathematical models about the decompression valve and the throttling disk were established.

通过对喷水减温减压器结构的合理简化，建立了减压阀和节流孔板的数学模型。

This company except provides the complete set throttling gear to the user "before to reducing expenses, to take presses the installment, after 10D, 5D the measuring tube, the attachment flange, directs the pressure tube, the valve and the fastener" and the appendix (condenser, subsider, air or gas collector, balancer, disconnector and so on) outside, but also provides each kind of throttle alone according to the user need and takes presses the installment and so on.

本公司除向用户提供成套节流装置《包括节流件、取压装置、前 10D、后5D测量管、连接法兰、引压管、阀和紧固件》及附件（冷凝器、沉降器、集气器、平衡器、隔离器等）外，还根据用户需要单独提供各种节流件和取压装置等。

This paper deals with the theoretical analysis and experimental results of the hydrostatic bearing of the valve plate friction pair with triangular throttling groove.

本文对具有三角阻尼槽的平面配流摩擦副的静压支承油膜进行了理论分析和实验研究。

Valve is the use of diaphragm, spring, piston and other sensitive components to change the valve clearance between the valve and valve seat, when the medium when produced by throttling, the pressure drop and its decompression valve.

减压阀是利用膜片、弹簧、活塞等敏感元件改变阀瓣与阀座之间的间隙，当介质通过时产生节流，压力下降而使其减压的阀门。

Then, the method to estimate cavitation erosion characteristic of high pressure piston plunger pump by analyzing impingement angle on outlet of throttling groove is put forward. That is, to hold the impingement angle range of 30°～60°as appraisal criterion of cavitation erosion characteristic on high pressure hydraulic plunger pump.4 The throttling characteristic of hydraulic control valve is studied by CFD calculation and experiment.

最后，提出了一个通过分析节流槽出口处的射流方向来评价高压轴向柱塞空蚀特性的空蚀评价方法，即将节流槽出口的射流角范围30°～60°作为评价高压轴向柱塞泵空蚀特性的标准。4对液压控制阀的节流特性进行了CFD数值计算和试验研究。

As shown in Figure 11-25, when the airflow from a time of entry, one-way valve is on the top of the seat, the air can only flow from the throttle port of export 2, throttle valve throttling traffic is limited by the size of the mouth, adjustment screw can be adjusted throttle area.

如图11-25所示，当气流从1口进入时，单向阀被顶在阀座上，空气只能从节流口流向出口2，流量被节流阀节流口的大小所限制，调节螺钉可以调节节流面积。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。