查询词典 thread-cutting

Put two adjacent fabrics(single-fibre cloth), each measuring 5 cm ×4 cm , side by side on a specimen measuring 10 cm × 4 cm, next, either sew roughly four sides of the specimen with white cotton sewing thread, or fold in half the specimen into 5 5 cm ×4 cm size so as to lay the adjacent fabric inside, and sew roughly at its near centr of the specimen with white cotton sewing thread to make the sewing line parallel to the folding line.

把两个相邻的织物，每5厘米× 4厘米，并排于试样测10厘米× 4厘米，在未来，无论是缝纫大约四个方面的标本与白棉缝纫线，或褶皱在一半标本到五五厘米× 4厘米大小等，以奠定相邻织物内，并缝合大约在其中心附近。该标本与白棉缝纫线，使缝纫机线平行的折线。

Take sample, with10cm length, weighing about 1/2 of two adjacent fabrics , fold to half the adjacent fabric, measuring 10 cm × 4 cm, at the centr of its shorter side, insert the flattened sample thread between the folded cloth so as to make the direction of the sample parallel to the longer side of the cloth ,and sew roughly three sides except the folded line with white cotton sewing thread

取样本， 10cm长，重约1 / 2的两个相邻的布料，折叠到一半相邻织物，测量10厘米× 4厘米，其较短的一边，加上平地样本线程之间折叠布等，以使该方向的样品平行于长边的布，缝大约三面除了折叠线与白棉缝纫线

Put two adjacent fabrics(single-fibre cloth), each measuring 5 cm ×4 cm , side by side on a specimen measuring 10 cm × 4 cm, next, either sew roughly four sides of the specimen with white cotton sewing thread, or fold in half the specimen into 5 cm ×4 cm size so as to lay the adjacent fabric inside, and sew roughly at its near centr of the specimen with white cotton sewing thread to make the sewing line parallel to the folding line.

把两个各自5厘米× 4厘米毗连的织布，并排放置成10厘米× 4厘米的试样，然后用白棉缝纫线粗略地在试样四周进行缝制，或把试样对折成5厘米× 4厘米大小以确保毗连的织物放在里面，然后用白棉缝纫线以平行于对折线的方向在试样近中心处进行粗略缝制。

Pressed nut and the joint between the screw thread connection with the transition to improve the impact resistance of the thread, the function of vibration.

压紧螺母与接头体之间的螺纹用过渡螺纹连接，提高螺纹连接的抗冲击、震动的功能。

The study on drilling collar screw-stick,analysis of drilling collar screw thread and test of material and thread parameter have been done.

对钻铤粘螺纹事故进行了调查研究，并进行了宏观形貌和材质分析；对新钻铤材质和螺纹参数进行了检验，并采用不同旋螺纹扭矩对新钻铤试样进行了上卸螺纹试验。

As wire or thread may be used for the stitching, thus saddle stitch may be saddle-wre stitch or saddle-thread stitch.

因为可以用线或铁丝的关系，所以有骑马线订或骑马铁丝订的方式。

As wire or thread may be used for the stitch ing, thus saddle stitch may be saddle-wre stitch or saddle-thread stitch .

因为可以用线或铁丝的关系，所以有骑马线订或骑马铁丝订的方式。

2 The provisions of valve flap stent thrust nut in space; 4.3 will bring more than ejector stem components, and into the valve flap bracket, now can adjust screw ring on the injector; adjustment ring discharge pipe may be twisted too high in case of this case, when the valve assembly after the valve flap in contact with its seat before the valve flap seat will have an additional load on the adjustment ring edge, in order to avoid this from happening, should enable the adjustment ring hole just below the injector thread, through which holes should not be able to see thread.

4.2 规定阀瓣支架与止推螺母中的间隙； 4.3 将喷射器提起超过阀杆组件，并放到阀瓣支架上，现在可以把调节环拧在喷射器上；调节环可能在排放管上拧得太高，如遇此情况，当阀门组装后，在阀瓣与其座相接触前，阀瓣座将加载荷于调节环的边上，为了避免此情况的发生，应使调节环上的孔正好低于喷射器的螺纹，通过这些孔应不能看到螺纹。

If there is only one thread running before main starts and after main ends, then both allocators are completely thread-safe.

如果在 main 开始前和 main 结束后，只有一个线程在运行，则两个分配器都是线程安全的。

New type rotary thread take-up ensures uniform thread tensions under low-tension settings.

本机采用新型旋转挑线杆，即使是在极地的张力下也能得到高品质且稳定的线迹。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐