查询词典 thin layer

RESULTS: Result of hematoxylin-eosin stain confirmed that the cell layer by manual microdissection was ciliated cells and basal cell layer, which were thin without submucous layer.

结果：苏木精-伊红染色见手工显微分离的组织层为纤毛细胞和基底细胞层，较薄，不含有黏膜下层。

The differentiation states of costae indicates the ways they absorb and transport water, and their ability adapting to the dry conditions, which was elucidated by the following examples: Brachythecium plumosum, because of its thin cell-walls in the costae and the absence of hydrome, assistant and steroid cells, can absorb water and nutrition under shady and moist conditions; Plagiomnium rostratum, though often grows in shady and wet condition, has hydrome and steroid cells, a feature similar to those of xeric mosses, which endows it to grow in the conditions with periodical drought stress during its life cycle; Hygrohypnum luridum is characterized by its slender leaves with only one layer of cells, the thin cell-walls, the absence of filaments on the leaf surface, and the fewer layer cells in the costae, the absence of hydrome and steroid cells. These features make it adaptable to aquatic environments. For Pogonatum inflexum and Atrichum undulatum, their ventral surfaces covered with lamella, while for Racomitrium japonicum, Thuidium cymbifolium, Macromitrium ferriei, Diphyscium fulvifolium, Barbula unguiculata and Ceratodon purpureus, their leaves are strongly mammillose or papillos. Such appendiculate structures made them adaptable to thy conditions.

例如，荫湿生环境下的羽枝青藓Brachythecium plumosum，其中肋细胞胞壁较薄，无导水主细胞和副细胞的分化，也没有厚壁细胞分化，能够在阴湿环境下吸收水分和养分；钝叶匍灯藓Plagiomnium rostratum具有与旱生藓类植物相似的中肋结构，叶片较厚，中肋具导水主细胞，中肋背面具厚壁细胞，这些特点使该种藓类植物能够分布于间隙性干旱胁迫的环境中；水灰藓Hygrohypnum luridum叶片纤细柔弱，仅1层细胞，细胞胞壁薄，叶表无附属结构，中肋细胞层数少，无导水主细胞分化，也没有厚壁细胞，这些特点使得水灰藓'能够生长在水生环境中；东亚小金发藓Pogonatum inflerum和波叶仙鹤藓Atrichum undulatum的叶腹面覆盖着栉片，东亚砂藓Racomitrium japonicum、大羽藓Thuidium cymbifolium、福氏蓑藓Macromitrium ferriei、东亚短颈藓Diphyscium fuhifolium、扭口藓Barbula unguiculata和角齿藓Ceratodon purpureus的叶片表面有乳头状突起或疣状物，这些附属结构使它们能够适应于旱生的环境中。

According to the simulated results, it was found that the incident light was not fully absorbed in the solar cell due to a thinner base layer. The un-absorbed incident light could be further reflected by a AuGe/Au mirror layer and absorbed again by the base layer. Thus the disadvantage of the GaAs thin-film cell with a thinner base layer could be solved by the additional reflection from the AuGe/Au mirror with a high reflectivity within 800~1000 nm wavelength. Moreover, the external quantum efficiency in the long wavelength region and short current density were also increased.

从模拟结果中得知，薄膜型结构之太阳电池可以经由AuGe/Au之金属反射层，再次将未被基极层完全吸收之入射光反射回太阳电池，使得薄膜型结构在长波段的外部量子效率获得提升，这结果显示薄膜型结构太阳电池可利用AuGe/Au之金属反射层在长波段的高反射率，改善使用较薄基极层时，无法将入射光完全吸收的缺点。

Considering the shortcoming of thick epitaxial layer technology , author proposed a thin epitaxial layer ldmos used n - burry layer .

针对目前厚外延工艺的缺点，提出的薄外延ldmos 采用n 埋层，通过优化n 埋层长度、注入剂量可提高器件耐压。

In addition, a printing plate edge marked slopes or plate is too thin, or short-run printing of excessive wear lighter, so that the short-run suites and whitespace differences of high and low is too low and too soft pads, resulting in suites blank areaand, electro-chemical layer of aluminum foil, etc, should be made at the edge version slope near 90-degree right-angle (such as seihan with carving techniques that help you make little gradient edge version), according to the characteristics of the short-run suites, with thickness larger plate seihan, and a blank site, using a corrosion deeper stereoplasm lining for short-run; in addition, you should choose thin aluminized layer of anodized, adjust the appropriate business card printing and membership card making and adjusted pressure volume drum uponsize pressuer letoff drum.

此外，印版边沿存在明显的斜坡度或版材太薄，或印版过量烫印磨损变浅，使烫印版面与空白的高低差异太小，衬垫材料过软，造成版面空白部位与电化铝箔层接触等，应将版边沿坡度制成近90 度的直角(如采用雕刻工艺进行制版，可使版边沿几乎没有坡度)，根据烫印版面的特点，采用厚度大一些的版材制版，并将空白部位腐蚀深一点，采用硬质包衬进行烫印；此外，应选择镀铝层较薄的电化铝，调整合适的制卡和会员卡制作压力，并适当调整压卷滚筒压力和收卷滚筒拉力。

Glazing is business card printing and membership card making products surface with on a layer of clear coatings, after leveling, dry, calendering, Business card printing and membership card making products surface layer of thin, transparent layer of intermediatein.

上光是在制卡和会员卡制作品表面涂上一层无色透明的涂料，经流平、干燥、压光后，在制卡和会员卡制作品表面形成一层薄且均匀的透明光亮层。

One side of a thin elastic base cloth is attached with a layer of machine woven cloth, and the other side of the base cloth is compounded with a PU layer via wet processing of synthesized leather, then the base cloth is dried and molded, and the machine woven cloth is peeled during a coiling process; wherein, the base cloth and the machine woven cloth are fuzzed in a single surface, the fuzzed surface of the machine woven cloth is attached to the non-fuzzed surface of the base cloth by low concentration hydrophilic adhesive, and the PU layer is compounded to the fuzzed surface of the base cloth.

一种薄型、弹性PU合成革的制作方法，先在薄型、弹性基布的一面贴合一层机织布，再在基布的另一面用合成革湿法工艺复合PU层，干燥定型，然后在收卷过程中剥去机织布，其中基布单面起毛，机织布也为单面起毛，机织布的起毛面用低浓度的水性粘结剂贴合在基布的不起毛面上，PU层复合在基布的起毛面上。

The reservoir rock types in the region of interest are grain limestone, algal limestone, cryptite, siltstone, muddy limestone and mudstone. The thesis identified as a result of changes in the deposition causing the heterogeneity in plane, and then the geological oil reserves have been calculated in accordance with the areal heterogeneity.3、Based on the data of core analysis, bore logging, array induction imaging log and FMI, porosity and permeability model were built using regression analysis. Through testing 45 rock samples, a, b, m, n value were obtained and used to calculate single-layer oil saturation value using the Archie formula. According to the theory of laterolog and inductolog, resistivity ratio and cross plot were used to identification effective thickness. Effective thickness was identified delicately in 103 wells. Based on the over work, active porosity and oil saturation was calculated accurately.4、According to observation of 100 pieces of the thin slices, cast thin slices and 383m core in three wells, the chief diagenesis in this area were compaction, cementation, denudation and cataclasis. Cementation and denudation were universally influenced active porosity this area. The intergranular pores, residual pores and secondary pores were formed in thin carbonated reservoir of lacustrine facies.5、The influence of reservoir heterogeneity to reservoir calculation was analyzed systematically using actual data. And the conclusions were as follows:①The principal reason leading to oil distribution unequal is interior structural feature of reservoir in structural hydrocarbon reservoir.

确定了由于沉积微相的变化而导致的平面非均质性，进而在平面上按照平面非均质单元计算了石油地质储量。3、利用岩心分析、常规测井曲线与阵列感应、成像测井资料相结合，分岩性利用回归分析方法建立了储层孔隙度、渗透率模型；通过对45块岩样进行岩电试验，获取了a、b、m、n值，利用阿尔奇公式计算了各单层含油饱和度值；根据侧向电阻率和感应电阻率串并联特性，利用电阻率比值法与常规交会图法相结合重建了有效厚度图版，对全区103口井目的层段进行了有效厚度精细划分，通过以上工作，准确求取了储量计算单元内有效厚度参数、有效孔隙度参数以及含油饱和度参数。4、通过对研究区3口井383m岩心观察，100余块薄片、铸体薄片镜下鉴定得出：油泉子油田上、下油砂山组储层主要成岩作用是压实作用、胶结作用、溶蚀作用和破裂作用，其中溶蚀作用、胶结作用最普遍，这两种作用对有效孔隙度影响最大，以上成岩作用形成了原生粒间孔、粒间残余孔和次生孔隙(如粒间溶孔、粒内溶孔、铸模孔、晶间孔等)为主的薄层湖相碳酸盐岩储层。5、利用实际资料，系统分析了油藏非均质对储量计算的影响，认为：①对于构造油气藏而言，油气藏构造及断裂特征是造成油气分布不均的首要原因，储集条件相同的条件下，构造高部位有利于储存油气，油气在垂向的重力分异体现了油气藏内部构造的不均一特征。

The thin film transistor may include: a gate insulting layer; a gate electrode formed on the gate insulating layer; a channel layer formed on the gate insulating layer; and source and drain electrodes that contact the channel layer.

具体而言，薄膜晶体管可以包括：栅绝缘层；形成在栅绝缘层上的栅电极；形成在栅绝缘层上的沟道层；以及接触沟道层的源和漏电极。

The structure of the thin film capacitor 1 of this invention is: form sequentially at least the bottom electrode layer 102, the high dielectrics constant oxide film 103 and the upper electrode layer 105 on the semiconductor substrate 101; said upper electrode layer 105 which is a film layer 104 formed by the electrical conductive material which is processable by reactive ion etching, or a multilayered film composed of two kinds of film layers 107 and 108, which are each formed of a conductive material which is processable by at least two kinds of reactive ion etching.

要约 薄膜电容器1是至少在半导体基片101上按顺序形成下部电极层102、高介电常数氧化物膜层103、上部电极层105而构成的薄膜电容器，该上部电极层105由一种仅由可用反应性离子刻蚀加工的导电性材料形成的膜层104，或至少两种由可用反应性离子刻蚀加工的导电性材料分别形成层状的多层膜层107和108构成；经历350℃的热试验之后，对该薄膜电容器1施加OV到2V的驱动电压的薄膜电容器漏电电流密度为1×10 －8 A/cm 2 以下。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。