查询词典 thickness

Comparison of signal intensity and thickness of cartilaginous regions seen on MR images with architecture and thickness of zones shown in corresponding hi...

将MR所显示的各层微细解剖结构的信号特征、厚度与相应组织学构造和各层的厚度进行相关性比较对照。

By the analysis of stress distortion of circular load symmetry flat plate, starting from the entire deriving course of thickness calculation formula, derives the simple formula of calculating blind flange thickness, which is fit for oral calculation of hydrostatic pressure testing of in-situ equipment and pipeline.

通过对对称载荷圆形平板的应力变形进行分析，从其厚度计算公式的整个推导过程入手，归纳整理出适合于施工现场设备及管道等试压时，所需的盲板厚度的简易计算公式，使其达到现场口算化。

Six parameters were determined,i.e.,cell layers of collenchyma and parenchyma,cell wall thickness of collenchyma,thickness of cortex layer and vascular bundle,and diameter of vessel lumen.

对厚角细胞层数、薄壁细胞层数、厚角细胞壁厚度、皮层厚度、维管束厚度和导管腔大小等6个参数进行了比较分析。

Results Within the first 6h after thermal burn, the volume of corium was increased to (32.75±13.23)% in 27 sites with superficial burns,(76.09±15.88)% in 20 sites with deep dermal burns,and (150.46±24.06)% in 15 sites with full thickness burns .In full thickness burn sites, 13 out of 15 showed no intact of the dermal-fat interfac. Conclusions The corial volume is increased with the increase of burn depth.

结果 烧伤后6h内，27个部位浅Ⅱ度烧伤创面真皮肿胀度为(32.75±13.23)%，20个部位深Ⅱ度烧伤创面真皮肿胀为(76.09±15.88)%，Ⅱ度烧伤创面真皮-皮下界面完整，15个部位Ⅲ度创面真皮肿胀度为(150.46+24.06)%，且部分Ⅲ度创面(13/15)真皮-皮下界面被破坏。

The design in this paper of craftwork glass thickness controller is to implement the smart control of glass thickness.

本文设计的工艺玻璃厚度控制器主要是为了实现玻璃厚度控制的智能化而设计开发的。

Based on Three Gorges Project, the following aspects about the three typical embedding manners are studied:(1) The border condition of cyclic symmetry is applied to the finite element models with contact among cushion layer, penstock and concrete. The effects of elastic modulus, thickness and placement extent of cushion layer on the stress of its around concrete are analyzed. It is suggested that the ratio of thickness to elastic modulus can be used as an important parameter in the design of cushion layer.

因此，本文结合三峡工程建设实践，在收集和总结前人经验的基础上，以大型通用有限元分析软件ANSYS为平台，对不同埋设方式的巨型蜗壳结构进行以下几个方面的研究：(1)引入循环对称边界条件，考虑垫层-钢板-混凝土之间的接触摩擦，建立有限元模型；并对垫层敷设范围、垫层厚度和弹性模量等设计关键参数进行了优化，并把"垫层弹性模量与垫层厚度之比"作为参考指标进行设计。

A fitting curve between the decay time constant and the film thickness of YBCO was obtained, and the film thickness can be obtained from the fitting.

另外还作出了YBCO薄膜的薄膜厚度与衰减时间常量之间的关系曲线，提出了测量YBCO薄膜厚度的一种新方法。

Under determining cushion thickness more than failure face depth, determining cushion thickness less than failure face depth and the space between pile is small etc, the calculation equation of proper determining cushion is got.

从垫层厚度大于破坏面深度、垫层厚度小于破坏面深度和当桩间距较小时等几种情况下，推导出最佳合理垫层计算公式。

The left ventricular internal dimension at end diastole, interventricular septal thickness at end diastole and left ventricular posterior wall thickness at end diastole were measured in the parastemal long axis view by transthoracic two-dimensional echocardiography, and to calculate left ventricular ejection fraction with Teichholtz formula and left ventricular mass with modified Devereux formula, left ventricular mass index=LVM/body surface area. From the apical four chamber and two chamber view, the basical segment and middle segment of interventricular septal, left ventricular lateral wall, anterior wall and inferior wall were obtained by tissue Doppler imaging, Regional left ventricular relaxation asynchrony index was calculated.

应用二维超声心动图在胸骨旁左心室长轴观测量左心室舒张末期内径、室间隔和左心室后壁舒张末期厚度，采用Teichholtz公式计算左心室射血分数，采用Devereux校正公式计算左心室心肌质量，左心室心肌质量指数=左心室心肌质量/体表面积；在心尖四腔心和心尖两腔心切面，应用组织多普勒成像获取室间隔、左心室侧壁、前壁和下壁的基底段和中间段8个心肌节段沿左心室长轴运动的速度频谱，测算左心室局部心肌松弛不同步性指数(regional left ventricular relaxation asynchrony index， AI)；在心尖四腔心切面，应用彩色M型多普勒超声心动图测量左心室舒张早期血流传播速度。

To examine the changes of the comeal thickness ; comeal dioptric power; anterior chamber depth ; lens thickness and axial length before and post-operation lweek,2weeek,lmonth,2months and 3months.

术后1、2、3月对植片植床大小差值与各观察指标进行相关性分析，并建立植片植床差值与角膜屈光力和眼轴长度的回归方程。

Based on the relationship and the phenomenon model, an improved model of MR damper has been presented in this paper.

摘 要：本文在实验数据的基础上建立了磁流变阻尼器输出力与不同常电流控制量的关系，对现有的 p模型进行了改进。

I don't think our founding fathers were very fuckable.

我认为我们的开国元老没什么吸引力