查询词典 thickness

The MCPP isn't contractive, thickness we are controls in the 20-40 Us.

MCPP是不收缩的，厚度我们是控制在20-40U。

Flange height and lip thickness are limited to the drawing ratio of the sheet metal in the convectional hole flanging process. Necking or fracture tends to occur before the required flange height being achieved which is unfavorable for subsequent assembly operations.

般金属板材在进行孔凸缘冲压成形时，凸缘高度和轴壁厚度通常受材料伸长率的限制，往往在未达所需凸缘高度前，板材即发生颈缩或破裂的现象，不利后续组装加工。

The temperature、heat flux and solidified shell thickness were calculated in two different slab. The influence of casting speed to heat transfer was also analysised, and the calculation method of inverse problem model was studied. The convergence behavior of model was discussed under different methods and parameters.

对实际生产中两个不同的铸坯模型的结晶器温度、热流和铸坯凝固状况进行计算，分析了拉坯速度对结晶器传热的影响，并对反问题模型的计算方法进行研究，讨论了不同反算方法及参数下的模型收敛行为。

Simulation results show that the thickness non-uniformity of SiO2 films was less than 8.5% over the convex surface of a dummy dome.

模拟结果显示：头罩外表面制备的SiO2薄膜其厚度不均匀性小于8.5%；雨蚀测试后，蓝宝石验证片的平均透过率损失小于1.0%。

By the cooling curve and the temperature field, it can he known that, the solidification time of ribbon is 1.0×10^(-4)s, the even solidification rate of ribbon with 60 μm thickness is about 10^6K/s, and the temperature of cooling process does not obviously go back by the release of solidification latent heat. The solidification rate of ribbon is at 0.010-0.394 m/s, and it changes from high to low with the prolonged solidification time.

由冷却曲线和温度场曲线类比结果可知，带子的凝固时间为1.0×10^(-4)s；单辊快淬的平均冷却速度在10^6 K/s数量级，且凝固潜热的释放不会明显地引起冷却过程的温度回升；带子的凝固速度在0.010~0.394 m/s范围之内随凝固时间的延长逐渐由大变小。

From TEM bright field image, it can be seen that the surface image of CoPt formed discrete islands, and gradually change to continuous film as the CoPt thickness increase. After annealed at 700℃ for 30 minutes, the single domain state is found by the observation of MFM images at 7.5 nm CoPt. At single domain state, the variation of coercivity with particle size agree with the theory of single domain particles.

由TEM平面明视野影像可以看到，随著CoPt厚度的增加，其表面型态由不连续岛状结构逐渐转变为连续膜，从MFM图可以发现於700℃退火30分钟之CoPt(7.5 nm)为单磁区状态，在此单磁区状态其矫顽磁力随颗粒直径的变化符合单磁区理论。

Basic fertilizer (organic fertilizer 500kg/667m2) add medium-term (organic fertilizer 500kg/667m2) facilitates favor to high-yield with the best conprehensive quality;density（40cm×60cm）with the highest yield; plastic mulching can significantly increase plant height, leaf width, leaf length, mature leaves, basal culm thickness, the first grade cormels weight and the second grade cormels weight; the first grade cormels of red sprout clocasia escalenta weight and yield had the obvious phenomenon of rapid growth in the medium expansion period of clocasia escalenta (July 14); an appropriate increase in plant height and stem yield was conducive to the increase in corn yield, the increase in corn yield favor to the first grade cormel numbers, the first grade cormel yield, the second grade cormel numbers, the second grade cormel yield, and thus obtain a higher yield.

基肥（有机肥500kg/667m2）+中期（有机肥500kg/667m2）有利于获得高产，综合品质最好；密度（40cm×60cm）产量最高；地膜覆盖可明显提高植株高度、叶宽、叶长、成叶数、茎基粗度、子芋和孙芋重量；红芽芋子芋重量和产量在芋膨大中期（7月14日）具有明显的快速增长现象；适当增加株高和茎叶产量有利于母芋产量的增加，母芋产量的增加有利于子芋个数、子芋产量、孙芋个数、孙芋产量的增加，从而获得较高的产量。

Objective To investigate the effect of dilating eyedrop on measurement of thickness of cornea.

目的 探讨复方托吡卡胺滴眼液对测量角膜厚度的影响。

The greater the coefficient is, the greater the correction quantity and the thinner the correctable thickness.

系数越大，订正量越大，但可订正厚度越小。

The attenuation correction coefficient influences correction quantity and correctable thickness.

衰减订正系数影响订正量的大小和可订正厚度。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷