查询词典 thickness

Coating thickness of the coating determined using point-3:00 measured the thickness of the coating thickness gauge general, the living

涂装漆膜厚度的测定，用触点式漆膜测厚仪一般测定3点厚度，取其平均值。

The results show that the chip thickness compression ratio decreases with the increase of undeformed chip thickness, and particularly, the chip thickness compression ratio is less than 1 under most experimental conditions.

第五，研究了KK合金在切削过程中的摩擦行为及其机理，发现切削时前刀面上的摩擦主要是在紧密型接触的条件下进行的。

In order to determine the optimum thickness of antifreezing layer of highway tunnel in cold region,the thickness was computed by separately using equivalent thickness conversion method ,weather analytic method and finite element simulation method.

为确定寒冷地区隧道防冻隔温层的最佳设防厚度，利用等效厚度换算法、气象解析法和有限元模拟计算法，分别对其设防厚度进行计算。

It is found that the bearing capacity of large diameter belled pile will increase with the increment of thickness of supporting course, bearing capacity and proportion of bottom-resistance are affected more notably by supporting course thickness when the supporting course thickness is small.

可以发现，大直径扩底桩承载力随持力层厚度的增加而增大，且在持力层厚度较小时持力层厚度的变化对承载力及桩端阻力所占比例影响显著。

RESULTS: Twelve days after mandibular vertical functional positioning the condylar height increased. Nine days after mandibular vertical functional positioning the thickness of prechondroblast layer and chondroblast layer increased significantly compared with control groups. However the thickness of hypertrophic layer decreased significantly after 6 days' mandibular repositioning. No change was found in the thickness of mesenchymal layer during the experimental period.

结果：下颌垂直向功能性移位后12d，髁突高度较对照组显著增加，前斜面更倾斜；髁突后上区前成软骨细胞及成软骨细胞层厚度在实验第3~6天无明显差异，第9天开始出现显著变化，实验组较对照组显著增厚，这种变化持续到实验第12天；肥大软骨细胞层厚度在实验第3、9、12天，实验组与对照组无显著差异，在实验第6天较对照组显著减少，间充质细胞层变化不大。

AFM images revealed that as the sputtering time was prolonged, the film thickness increased, the film became compacter, and the specific area of the film also increased, thus, the release rate of silver ions increased, which led to improved antibacterial properties. EDX test results indicated that increase in film thickness led to increase in silver weight percentage per unit surface, causing improved antibacterial properties. Moreover, when the film thickness was 1 nm, the inhibition percentage of Staphylococcus aureus and Escherichia coli were 100%.

结果表明：随着薄膜厚度的增大，样品抗菌性能提高；溅射时间延长，薄膜厚度增大，膜层的致密性改善，单位面积上的银含量增加，膜层表面积增大，银离子释放几率增大，是提高抗菌性能的主要原因；当纳米结构银薄膜厚度为1 nm时，对大肠杆菌和金黄色葡萄球菌的抑菌率均达到100%。

Results Central foveal thickness and foveal thickness (mean thickness in the central 1000-μm diameter area) were 153±18 and 188±17μm, respectively.

结果 正常人黄斑中心小凹的视网膜最薄，平均厚度为(53±18)μm，直径1mm中心环视网膜下均厚度为(188±17)μm。

Currently, in the oil-field exploitation, existing the phenomenon of garbling the lack thickness of stratum with vertical fault-throw in well logging identification of strata while meeting fault in drilling well. In most case, consider the lack thickness of stratum which contrast the imperfection geologic strata thickness to the well and the well as the fault-throw. The method which using very popular in oil-field exist shortages, it very much easily lead people into the areas of misplay. especially when the seismic person and geology confirm the fault-throw, It often appear inconsistent instance.

目前，在油田开发中钻井钻遇断层时，地质人员时常存在将测井分层与相邻井对比时缺失地层厚度与铅直地层断距混淆的现象，很多情况下把井与井对比缺失地层厚度等同于断层断距等，这些现今在油田非常流行的用法存在一些不足之处，容易把人们引入一些认识上的误区，特别是在地震与地质人员进行断层断距的确定时，经常出现矛盾的情况。

The specimen was preliminary coated with carbon of 10-20 nm in thickness, then sputtered with gold of various thickness according to its shape and surface texture: a gold film of 60-80 nm in thickness for bell-jar or tower-type radiolarites, 80-140 nm for globiferous radiolarites with spines and 140-200 nm for globiferous radiolarites.

在放射虫化石表面先蒸镀一层10-20 nm厚的碳膜，然后根据放射虫化石的形态和表面结构的不同，溅射厚度不同的金膜；钟罩形、塔形放射虫化石的金膜厚度在60-80 nm，带刺的球形放射虫化石的金膜厚度在80-140 nm，球形放射虫化石的金膜厚度在140-200 nm。

As for the printing and embossing roll roll retrohepatic, practical experience, in order to achieve such a request, that is, the gap = plates total thickness + corrugated board thickness — corrugrted thickness of error amount (usually 0.5mm)— roller and plates error amount (usually 0.1mm).

至于印版辊与不抬印辊间隙的把持，根据践诺教训，给到达这样的请求，即：间隙=印版总薄度+瓦楞纸板薄度—瓦楞纸板薄度的误不不差度(凡是为0.5mm)—辊与版材的误不不差度(凡是为0.1mm)。

Based on the relationship and the phenomenon model, an improved model of MR damper has been presented in this paper.

摘 要：本文在实验数据的基础上建立了磁流变阻尼器输出力与不同常电流控制量的关系，对现有的 p模型进行了改进。

I don't think our founding fathers were very fuckable.

我认为我们的开国元老没什么吸引力