查询词典 thickness

During CT scan,patients were in supine position, and the teeth in the middle of the contactposition on the jaw; and maintain a static head and body during the scanningprocess, did not swallow; measurement parameters including: soft palatelength, maximum thickness of the soft palate, pharynx lateral spacing, uvula length and base width of the free edge ofsoft palate to the throat wall spacing, velopharyngeal cross-sectional area,angina cross-sectional area,thickness of retropharyngeal wall.

随机对10例患者进行系统的腭咽CT测量，测量时间为术前、术后3个月、术后6个月；测量方法为：患者在清醒状态下进行平静呼吸时的上气道CT扫描，范围自听眶线至声门。利用CT工作站进行三维重建和测量。CT扫描时患者取仰卧位，牙齿处于正中颌的接触位上。

The mechanism of cohesion in the generation of ice rubble and ice ridging, the main factors arc demonstrated and analyzed elementarily. Considering three sea ice ridging process. the cohesion is set up as a function of initial ice thickness, total ice thickness, temperature and salinity, respectively. The theoretic expressions of sea ice cohesion were determined and to be introduced into the Mohr-Coulomb yield criterion.

考虑三种不同情况下的海冰堆积过程，将粘结力分别设为初始冰厚、当前堆积冰厚和海冰温盐的函数，分别建立了海冰粘结力的理论表达式，并将其应用到Mohr-Coulomb屈服准则中，建立了考虑粘结力影响的粘弹-塑性海冰动力学本构模型。

Infiltrates the level thickness to increase along with the temperature ascension, the time with infiltrates the level thickness the relations to throw satisfiedly.

渗层厚度随着温度的升高而增加，时间与渗层厚度的关系满足抛

Infiltrates the level thickness to increase along with the Temperature Test Instruments ascension, the time with infiltrates the level thickness the relations to throw satisfiedly.

渗层厚度随着温度的升高而增加，时间与渗层厚度的关系满足抛

A cortical pattern-matching method used 72 sulcal landmarks traced on each brain as anchors to align cortical thickness maps across subjects, construct group average maps, and identify areas with changed cortical thickness.

一种皮质层模式匹配得方法，使用了70sulcal标记物在每个大脑进行跟踪，锚着在不同受试者的系列皮质层增厚图谱上，创建组平均图谱，鉴别出皮质层厚度发生改变的区域。

Based on a computing model of floor heating residences, indoor thermal environment and heat distribution under the effect of heat charge/discharge, operation control and solar radiation has been concluded. Concept and formula of equivalent heat supply has been put forward which indicate that actual heat supply will be equal to the sum of design heat supply and equivalent heat supply. Recommend coefficient has been given taken Dalian as an example. Computed according to the new method, design heat supply can be reduced to 37% in cloudy day and 43.3% in sunny day, energy saving effect is very obvious. In Tromb wall solar house, effect of concrete wall on indoor temperature swing and attenuation of temperature wave is very obvious. While the outdoor air-temperature swing exceeds 10℃, indoor air-temperature swing belows 3℃. In the experiment, maximal difference in temperature between inner surface and outer surface of the 300mm wall exceeded 10℃. Heat storage and collector efficiency varies adversely according to solar radiation. Factors such as thickness, material, absorptance of the wall and permeation of the glass cover all have big influence on heat storage and collector efficiency. There exsisted an optimal thickness of the wall, which can make the best of heat storage and collector efficiency. Most of the heat stored in conventional Trombe wall during the daytime has been lost to the outside at night without heat preservation. Heat preservation on the outside surface of the wall has effectively improved heat release performance of the wall at night, heat supply to the room has increased too.

通过建立的地板采暖系统动态热性能分析模型，得出了在蓄放热特性、运行方式和太阳辐射等因素耦合作用下的室内热环境及热量分配比例，提出了等效供热量的概念及计算公式，指出实际所需供热量应等于设计供热量加上等效供热量，并以大连为例，给出了等效供热量的修正系数，以新方法计算，阴天可减少设计供热量37％，晴天最大可以减少设计供热量43.3％，节能效果显著；集热蓄热墙式太阳房中，混凝土蓄热墙的室温均一化效果和对温度波的削减作用非常明显，当室外温度波动最大幅度超过10℃时，室温波幅不超过3℃，实验中300mm厚墙体内外表面温差超过10℃；墙体蓄热效率与集热效率随太阳辐射照度的变化呈相反的变化趋势；墙体厚度、材料、表面吸收率以及盖板透过率等因素对集热和蓄热效率均有较大的影响，存在一个最佳的墙体厚度值，使得墙体集热和蓄热综合性能最优；传统的蓄热墙夜间没有外保温，辐射散热损失很大，研究表明墙体外保温方式明显改善了蓄热墙夜间的散热性能，增加了向室内的供热量。

Methods Fifty healthy SD rats were fed for twentytwo months in order to build the model of aging rats, the histology of femoral bone, tibial bone and lumbal vertebra was used to observe, then we evaluated the indexes which reflect the degeneration of intervertebral disc including the quantity of collagen type Ⅱ,Ⅹ of intervertebral disc by the immunohistochemistry methods, the relative area of vascular bud, the thickness of calcified layer and uncalcified layer on cartilage endplate and the indexes which reflect the osteoporosis including the thickness ratio of cortical bone, the relative area of bone trabecula, the bone density, the max stress and straining of bone.

50只健康纯种SD大鼠，喂养22个月，建立老龄大鼠模型，进行股骨、胫骨、腰椎等组织学观察，并评价椎间盘退变的相关指标(椎间盘软骨Ⅱ型和Ⅹ型胶原表达、软骨终板血管芽相对面积、软骨终板钙化层/非钙化层厚度)与骨质疏松的相关指标(骨皮质厚度指数、骨小梁相对面积、骨密度、骨最大应力和应变)的相关性。

The factors of temperature and humidity influenced on film thickness and order of layer were studied, in which pulling speed and pulling times were also included. It showed that the thickness of single dip-coating film reached 0.23 μm ~ 0.625 μm, and the degree of order of surface layer were still holding much higher.b Adopting calcined or uncalcined mesoporous silica membrane as matrix, nano zirconia particles were assembled through ion exchange method and ion-template exchange method.

结果表明，单次提拉膜膜厚0.23μm～0.625μm、8次提拉后表层膜仍有一定的有序性； b以自制的介孔氧化硅煅烧/未煅烧厚膜样为基体，采用离子交换法/离子模板交换法组装锆氧纳米粒子，选用DSC-TG、FT-IR、Uv-vis、SAXRD等对不同组装方法、锆源浓度、pH值等组装条件下ZrO_2/介孔氧化硅厚膜组装效果进行评价。

Because of having surplus weld reinforcement height and irregular seam form as well as the influences of polyethylene raw materials and coating process, the quality problems of ununiformity in thickness of 3PE coating and coating thickness reduction on helical seam occur.

由于螺旋埋弧焊管存在焊缝余高超高和焊缝形貌不规整等现象，加之聚乙烯原材料及涂敷工艺等因素的影响，会使三层PE防腐涂层出现涂层厚度不均、焊缝处涂层减薄等质量问题。

About feeding thick material flush ioint machine,Usee five connecting rods to be possible to adjust about thickness the compound feeding,to swollens the wseam material and dives moves the natural big especially thick material and the thin material,Can enable the lower level in the tailoring process the feeding quantity to achieve consistently;Uses turns on lathe the shuttle greatly,The raduction trades the agent number of times,Most major characteristic thickness dual purpose,Enhances the working efficiency,Uses the completely automatic lubricating arrangement,Enhances the machine service life.

0388系列上下送厚料平缝机使用五连杆可调整厚薄上下复合送料，对膨体类缝料和潜移性较大特厚料和溥料，在缝纫过程中能使上下层的送料量达到一致；采用大旋梭，减少换底线次数，最大特点针线张力小；缝纫厚度能力增大，缝纫薄料性能优良。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。