查询词典 thermal

Advantages include thermal stability, non-wetting and elimination of inclusions from shot.· Roll Caster Tips- Ceramic tips offer improved thermal stability, non-wetting, and contain no shot.· Block Caster Tip- Ceramic tips offer improved thermal stability, increased hot strength and do not outgas.· Belt Caster Tips- Ceramic tips offer improved thermal stability, increased hot strength, non-wetting, and do not outgas.

优势包括热稳定性，非焊接和除去钢丸中的杂物·滚动铸造机刀片——陶瓷刀片提供热稳定性，非焊接，不包括钢丸·块铸造机刀片——陶瓷刀片提供热稳定性，增加热强度，不泄露气体·带式铸造机刀片——陶瓷刀片提供热稳定性，增加热强度，非焊接和不泄露气体。

Two kinds of thermal residual stresses exist in metal matrix composites. One of them is temperature gradient induced thermal stresses caused by temperature gradient in MMC. The other can develop upon cooling from the processing temperature to room temperature due to the coefficient of thermal expasion mismatch between the fiber and matrix and is called CTE mismatch induced thermal stresses.

金属基复合材料有两种形式的热应力，一种是在MMC中由于温度梯度引起的热应力，即温度梯度诱导的热应力；另一种是在冷却过程中由于基体金属和纤维的热膨胀系数不匹配引起的热应力，即热膨胀系数不匹配诱导的热应力。

And the thermal drift curves were measured in different ranges of grid voltages in order to work out compensatory temperature-voltage curves which eliminated the thermal drift. The means of the using of thermal resister network for circuit's thermal compensation was adopted, which was based on compensatory temperature-voltage curves.

按照试验结果作出了在以上四个栅极电压范围内的温度漂移曲线，并在温度漂移曲线的基础上作出了理想的消除了漂移的温度-电压曲线。

Secondly, ANSYS is used to compute the thermal filed of air-core reactor. A coupled magnetic-circuit-thermal finite element model is proposed for thermal analysis. Finally, the distribution of the thermal field and the maximal temperature are given.

对干式空心电抗器的温度场进行了有限元分析，建立磁场-电路-温度场的耦合计算模型，得到空心电抗器的稳态温度场分布以及最高温度值。

This paper investigated the stress response while the reactor endures thermal shock, and bring out the basic thermal-elastic mechanics equations and their solutions. It also discussed the thermal stress changes with time, study on the relationship between stress and radium. It provides theoretical references for reducing reactors'damage from thermal shock.

论文研究了反应器承受热冲击作用的应力响应，给出了热弹性力学基本方程及方程解，探讨了热应力随时间的变化及当量应力与半径的关系，从而为研究反应器减小热冲击损伤提供了理论参考。

A method using a tiny thermistor as heat transfer model was developed to measure thermophysical properties (thermal conductivity and thermal diffusivity) of three standand samples(ethanol, ethylene alcohol, solution of calcium chloride). Results showed that there was no significant difference between measurement and recommendation; results of thermal conductivity from thermistor method and heat probe method for carrot and potato samples showed no significant difference; results of thermal diffusivity between thermistor method and calculation for carrot and potato samples showed no significant difference.

在分析微珠状热敏电阻传热模型的基础上，在室温对标准样品（乙二醇、乙醇、氯化钙的水溶液）的热物性进行测定，结果显示，导热系数及热扩散系数的测量值与推荐值之间无显著性差异（p＞0.05）；热敏电阻法与热探针法对比测定胡萝卜及马铃薯两种农产品的导热系数，结果显示两种方法之间无显著性差异（p＞0.05）；热敏电阻法与常规计算对比测定胡萝卜及马铃薯两种农产品的热扩散系数，结果显示两种方法之间无显著性差异（p＞0.05）。

In this paper, a thermal simulation model of a LED driver was established. The thermal field and thermal stress analysis of the driver was done by using the software EFD Pro 8.2, and the temperature rise from various parts and the temperature field distribution of the PCB were obtained. By analyzing the reasons leading to overheating and unideal heat distribution, corresponding thermal simulation using an improved model was carried out. Finally, the comparison and analysis of experimental measurement results and simulation results were given.

本文基于计算流体力学中的有限体积法，建立了该变换器的热仿真模型，利用EFD Pro 8.2软件，对驱动电源内部进行了热场及热应力分析，得到了各部分的温升情况和整个电源温度场的分布情况，分析导致PCB局部过热的原因，然后针对热仿真得出的不理想的热分布情况提出了改进的方法，进行了模型改进，对PCB板上的各部分进行合理的重新布局，并再次进行了热仿真，最终得到了较为理想的结果，最后给出了实验测量结果与仿真结果的对比及分析。

The efficiency of the thermal analysis and thermal design is improved if the variation analysis method is used to the thermal analysis and the thermal design of the satellite.

将参数分析方法应用于卫星的热设计和热分析中，可提高卫星热设计和热分析的效率。

In Chapter Four, the surface fracture was studied for a functionally graded plate with a semi-elliptical surface crack under state thermal loading, and studied the influence of crack sizes, aspect ratios and material property on the stress intensity factors along a crack-front under two types thermal loading: calefactive state thermal loading and descent state thermal loading.

第四章研究了含有半椭圆表面裂纹的功能梯度材料板条在稳态温度热载荷作用下的裂纹问题分析，着重考虑了升温载荷及降温载荷作用下应力强度因子在裂纹前沿的分布及材料梯度及裂纹与板的几何尺寸对应力强度因子的影响。

These indexes describe the fabric's thermal properties during the heated process. The heat insulation ratio preferably manifests fabric's insulation property; the difference of calefactive ratio describes dynamic conditions average calefactive case; effective thermal conductivity and compound thermal resistance are mainly considering the wholly testing characteristics and describing the compound thermal property; the response time expresses the time of step response during dynamic testing process. 3. Dynamic heat transmitting properties of fabrics and warmth retention testing methods have been developed; many different textile materials are used for actual test, and the data are analyzed, illustrated, and compared.

这些指标从不同的侧面描述了试验过程中织物试样的传热隔热性能，其中隔热率是从整体上来考虑的指标，它较好的描述了试样的隔热保温性能；升温速率差考虑的是动态变化过程中平均升温变化情况，它的大小表现了织物热性能的差异；名义导热系数和复合热阻是从试验装置的特点出发整体来考虑的热传递指标，描述了铜板、试样、铜板三者复合时的传热性能与隔热性能；而温度动态响应时间表示动态热传递过程中趋于稳态所经历的时间。

I didn't watch TV last night, because it .

昨晚我没有看电视，因为电视机坏了。

Since this year, in a lot of villages of Beijing, TV of elevator liquid crystal was removed.

今年以来，在北京的很多小区里，电梯液晶电视被撤了下来。