查询词典 thermal
- 与 thermal 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
A cryostat used to fabricate cryogenics target by the thermal gradient method is designed. Upper and nether thermal pole are used to make the sample box cooling down.
同时研制和设计了一种热梯度法制备核聚变低温冷冻靶用的带光学窗口的异型低温恒温器。
-
By analysing crystallizability and thermal instability of polyvinylidene chloride in film extrusion, siutable processing additives and modifiers for improving processability, thermal stability and strength of film are introduced, including plasticizers, stabilizer, lubricants and inorganic fillers etc.
通过PVDC树脂的结晶性和对热不稳定性的讨论,介绍了在成膜时提高树脂加工性、稳定性和薄膜强度等的加工助剂和改性剂,包括增塑剂、稳定剂、润滑剂、无机填充剂等。
-
The Eppendorf Thermal Cycler is an Authorized Thermal Cycler and may be used with PCR licenses available from Applied Biosystems.
Eppendorf的热循环仪都具有美国应用生物系统公司颁发的PCR试验专利授权。
-
In addition, the concentration of target DNA fragment in the PCR mix before thermal cycling can be obtained from the time recorded history of the fluorescence intensity by integrating thermal cycler and fluorimeter.
实现此技术的仪器,主要需结合温控机构与萤光检测仪,在温控过程进行 DNA 体外增生,同时监控过程中 DNA 嵌合萤光的多寡,进行 DNA 分析。
-
On the basis of the thermal balance equation,specific inner work equation,cyclic heat absorption equation of a thermal system and the standard coal-consumption calculation formulae of power generation,derived was a general calculation model featuring the influence of lower terminal temperature difference of a heater on the coal consumption of a power plant.
根据热力系统热平衡方程、比内功方程、循环吸热量方程及发电标准煤耗率计算公式,导出了加热器下端差对机组煤耗影响的通用计算模型;并且在考虑到加热器下端差的影响的基础上,改进了以往的建模方法,得到了更为完善的加热器上端差对机组煤耗影响的通用计算模型。
-
The quality of interior environment in nursing home residents will become one of the attention-getting subjects due to the gradual increase of aging populations This paper directs at the research of nursing home's interior environment factors in Tainan We use the standard of international practice to analyze the intrinsical data of environmental monitoring and establish the characteristics which from environmental physical reaction of nursing home The research items are air environments (PM10 CO CO2 formaldehyde TVOC) temperate environments and light environment (illumination average brightness daylight factor) etc There are the inductive conclusions of this research: 1 In basic medicine the clinical diagnosis means the theory and technique about physical examination with patients The definition of clinical diagnosis in architecture should be the diagnosis of building preserve and improve the feasible way to extend building's service life and assure the residents of the healthy quality of interior environment The object of clinical diagnosis in architecture is not only to ensure the use of structure and environment quality but also keep the structure and environment quality in sustainable; therefore creating an efficient system of preserving plan is needed 2 It is an accurate and technical circumstance which about improving remedying and reconstructing the problems of structure space This circumstance includes finding questions ensuring causation ascertaining ultimate strength evaluating environment quality estimating the necessary of restoration and implementing on a suitable way Furthermore when reconstructing and ameliorating the appearance of structure space it should be respected and the memories of it should be preserved 3 In clinical diagnosis of environment quality of space the question of physical environment and the deficiencies of structure must be separated The structure space of construction and the high quality of space should be inspected strictly then observed the crucial reason that can find out any invisible and hidden causes The diagnosis of construction is to observe the reason of destroyed structure The environmental diagnosis of indoor and outdoor is to find out the crucial reason that influences health 4 In order to decrease the iterant problems the construction and environment of space should be diagnosed However the destruction by natural strength and artificial using by human are important causes that can affect the service life of construction Searching the cause of disease just like curing the patient which includes inspection diagnosis cure and prevention We tested the thermal conductivity of siding material in this research and then found out the roof east vertical face and west vertical face have most radiant heat especially the construction of RC The characteristics of opaquely outer casing have relations with the thermal conductivity of wall to wiz the ability of heat insulation Therefore increasing the efficiency of heat insulation and decreasing the endoergic factor of insolation are very important to temperate environments
而随著国内老年人人口逐渐增加,逐渐迈向高龄化之同时,对於高龄者使用空间之室内环境品质相关议题之探讨,亦成为未来我们需加以关注之议题之一。主要为针对台南某安养中心室内环境因子进行检测调查工作,利用现场室内环境测定以取得有效的实测数据;再藉由汇整相关国际评估基准,并进行实测数据比对分析,建立老人安养中心对物理环境反应之特性。并以前期相关研究文献回顾与老人安养中心实测案例现场的实验,来了解不同空间物理环境特性之影响,并将结果回馈实际建筑及室内设计之用。调查工作项目包含:空气环境之PM10、CO、CO2、甲醛、TVOC;温热环境之室内温度、相对湿度、人体PMV、PPD;光环境之照度、均齐度、昼光率等因子调查。本研究结果可归纳以下几点结论: 1 所谓临床诊断医学乃相对於基础医学而言,是指实际与病人接触的医疗及护理行为中牵涉到的理论和技术;而建筑的临床诊断的定义应为建筑本体与室内外诊断、维护及改善所有可行的方式来延长建筑物的寿命,并确保人与室内环境空间品质的健康。建筑临床诊断目的为确保结构体与环境品质能继续使用,而能维持所需要的效能及承受能力。一个有效的维护计画体系是必须建立的 2 在建筑空间之问题改善、治疗与修复执行中,是一个精确与技术性的事项,其中包含找出问题、确定原因、评估结构应力强度、评估环境品质、评估修复与改善必要性、选择及执行一个适当的过程。其改善与修复也必须尊重建筑空间原有色彩与形貌,并保留原有记忆及文化。 3 在临床诊断中空间环境品质中,物理性环境问题与结构构件缺陷必须分别判断,诊断建筑空间之结构与空间舒适品质必须详细观察其症结性问题,才能发现任何隐藏及有潜伏性缺陷的原因。建筑本体诊断是观察出建筑本体之破坏原因,而是内外空间环境诊断目的在於的找出影响健康因素之症结性问题。 4 建筑本体与空间环境之预防评估目的为降低与抑制问题的再发生。然而,自然力的破坏与人为使用因素皆是影响建筑生命期之主要因素,找出病源问题就如同医生对病人的处理,包含了侦查、诊断、治疗以及预防。 5 本研究以外墙材料热传导率测试结果发现,屋面与东西向立面是承受辐射热最多的地方,尤以 RC 的建筑更甚,不透明部分的外壳能特性主要与壁体的热传透率即隔热能力有关,但是承受来自日射的吸热影响,因此增加隔热性能与降低日射吸热因子是对温热环境是非常重要的。
-
Thermal expansion characteristic of semimetallic nylon composite (nylon 1010 packed metal oxide) was analyzed with thermal expansion appearance. The change of composite weight after being heated and decalescence / heat release of composite were analyzed by carrying TG-DSC experiment.
用热膨胀仪分析了半金属尼龙复合材料(金属氧化物填充尼龙1010)的热膨胀特性;通过进行TG-DSC实验,分析了复合材料在受热后其重量的变化以及吸放热情况。
-
The existence of aromatic ring reduces the rates of thermal and thermal-oxidative decomposability during high temperature stage.
芳香环的存在降低了树脂体系高温阶段的热分解和热氧化分解的速率。
-
TG curve of cured PWF were same with that of cured PF during the range of 30 to 291℃.Both were thermal stable and had no weight loss before 200℃and they began to loss weightwith increasing temperature. The temperatures of thermal decomposability of cured PWF andPF were 291℃and 296℃, respectively.
8液化木基树脂和纯酚醛树脂的热重曲线在30~291℃完全相同,两者在200℃以前几乎没有发生失重现象,比较稳定,当温度超过200℃后,两者皆有轻微的失重,液化木基树脂的热降解温度约291℃,纯酚醛树脂的热降解温度约296℃。
-
The polymer which has high thermal stability will become carbon matrix by high temperature carbonization, and the polymer with low thermal stability will decompound and gasify in the process of heat treatment, and the pore structure is l
综述了聚合物共混炭化法制备多孔炭材料的原理、方法、研究现状及最新进展,并指出共混聚合物分相相畴的控制和炭化过程中孔结构的控制是该法所存在的主要问题。
- 推荐网络例句
-
I can not make it blossom and suits me
我不能让树为我开花
-
When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.
当温度高于 80 °C 左右时,滚道或滚动元件褪色是很常见的特征。
-
The lawyer's case blew up because he had no proof.
律师的辩护失败,因为他没有证据。