查询词典 thermal stability

The results showed that new type structure of organic phase containing inorganic phase between polyimide and titania particle by bond conjunct was formed.The discomposing temperature was decreased with the increasing of TiO2 contents,and the thermal stability was better than polyimide materials under the temperature of 450℃.The pore size increased with the increasing of TiO2 contents,and pore size distribution tended to disperse.The permeability of N2,H2 and CO2 across the membrane were controlled by Knudsen diffusion,and the memebrane exhibited outstanding hydrophilicity since their permeation coefficients of H2O／N,are higher than the Knudsen diffusion values.

结果表明，杂化膜材料形成了有机相包裹无机相的交联结构；聚酰亚胺与二氧化钛粒子形成了新型键联结构；其热分解温度随二氧化钛含量的增加而降低，在 450℃以下热稳定性优于聚酰亚胺膜材料；平均孔径随二氧化钛含量增大而增大，孔径分布趋于弥散；N2、H2和CO2在膜内渗透由Knudsen扩散控制，H2ON2分离因子均大于Knudsen扩散值，表现出良好的亲水性。

The experimental results show that it could reduce viscosity and shearing force of mud.When the addition of viscosity reducer is 0.5%,the thinning rate at high temperature will be up to 91.4% for fresh water clay mud.And it has very good salt tolerance and calcium tolerance.It has good viscosity reduction and disgregation in saturated saltwater mud and calcareous mud.Its thermal stability is also good.

研究结果表明：研制的钻井液降黏剂可以显著降低泥浆的黏度和切力，加入0.5%降黏剂的淡水基浆，高温降黏率可以达到91.4%；具有较好的抗盐、抗钙性能，在饱和盐水泥浆和含钙泥浆中也具有很好的降黏作用和分散作用；具有较好的热稳定性。

A series of poly/PET-copolyester polymer blends and fibers from these blends are preparated . The polymer blends are : PET/CDP(CDP: cation dye dyeable polyester or high pressure type cation dye dyeable polyester); PET/ECDP(easy cation dye dyeable polyester or normal pressure type cation dye dyeable polyester); PET/ECDP/polyethyleneglycoland PET/CGP. The transition temperature, crystalline structure, rheological behavior and thermal stability were studied .

本文制备了聚对苯二甲酸乙二醇酯／高压型阳离子染料可染聚酯；PET／常压型阳离子染料易染聚酯；PET／ECDP／聚乙二醇和PET／CGP一系列PET／PET-共聚酯共混物及纤维，对其转变温度、结晶性能、流变性能及热稳定性进行了研究。

It is demonstrated that TAP7 is a good hole transport material and blue electroluminescent material with high thermal stability.

结果表明TAP7是一种具有高热稳定性的空穴传输及蓝光发光材料。

Because of the high diffusivity and solubility of oxygen in Ti〓Al, once the oxidation layer loss its protection, oxygen can easily enter into the alloy and thus considerable oxygen contaminated region is formed, which would embrittle Ti〓Al alloys and seriously decrease their thermal stability and high temperature properties.

氧在Ti〓Al基合金中具有较高的固溶度，当表层氧化膜缺乏保护性时，氧得以在合金基体表面部分形成厚度可观的氧污染层，使本身塑性就较差的Ti〓Al基合金脆化，从而严重影响Ti〓Al基合金的热稳定性和高温力学性能。

Two reasons can be explained the improvements of catalytic activities after the addition of Ce. One is the increase of the thermal stability of Ni-B and Ni-P nanoamorphous alloys, which retards the nanocrystalline Ni to aggregate during the exothermal reaction of benzene hydrogenation. The other is to make their grain sizes smaller, thus it increases the number of activity center in unit mass.

说明加入Ce提高催化活性的主要作用有两方面，一是提高Ni-B和Ni-P纳米非晶态合金的热稳定性，抑制催化苯加氢反应时大量放热促使纳米晶Ni的聚集长大；二是使生成的Ni-B和Ni-P纳米非晶态合金颗粒更为细小，从而增加单位质量样品的活性中心数量。

Compared with homo-polymimdes and copolymimdes,PAIs can evidently improve mechanical properties while maintaining excellent solubility,high Tg and thermal stability of fluorenyl cardo polyimides.

与均聚PI，共聚PI相比，PAI在维持芴基Cardo型PI优异的溶解性，高的玻璃化转变温度及热稳定性的同时，明显改善(来源：A60d626BC论文网www.abclunwen.com)力学性能。

The catalytic performance of all the amorphous alloy catalysts mentioned above was measured during liquid phase hydrogenation of furfural to furfuryl alcohol, together with the kinetic studies. The relationship between the catalyst performance and the structure of catalyst, surface electronic state of the amorphous alloy has been systematically studied based on a series of characterization of catalysts . Meanwhile, the promoting effects of the support on the thermal stability and catalytic activity of the amorphous alloy catalysts have been discussed.

本文采用一系列的表征方法(XRD、XPS、TEM、BET、氢吸附、TPD等)进一步研究非晶态合金催化剂的表面结构、表面电子态和催化性能之间的关系，探索电子效应和几何效应对催化剂活性中心结构的影响，探索非晶态合金的晶化失活和载体对非晶态结构的稳定化作用，以及修饰剂对催化性能的改善作用等。

Nanosized CPF(Conjugated Polymer of Furfuryl alcohol)/ZnO composite catalyst was prepared through in-situ polymerization and heat conversion. The thermal stability, morphologies, size, structure and optical absorption properties of the CPF/ZnO material were characterized by TG-DTA, TEM, XRD, XPS, IR and UV-Vis techniques.

通过原位聚合-热转化两步法，利用ZnO纳米微粒和糠醇制备出了具有大共轭结构的高分子和ZnO的纳米复合催化材料；用TG-DTA、TEM、XRD、XPS、IR和UV-Vis等技术对其热稳定性、形貌、尺寸、结构及吸光特性等进行了表征，以亚甲基蓝溶液的催化降解研究了该材料在自然光条件下的催化性能。

The light and thermal stability of methyl orange anion-pillared hydrotalcite was enhanced to a considerable extent, comparing with that of methyl orange.

该超分子结构材料不仅保持了甲基橙本身的颜色，而且与甲基橙相比，其耐光性和耐热性均有大幅度的提高。

And discuss some key point of integrated management system design, include hazard identification and risk assessment and risk control in the occupational health and safety management, the measure of satisfaction target of customer, the flawlessness of law system, the integration of the integrated management system and enterprise standardization system, unify lead institution and work orgnization, integreted internal audit and integrated management review.

同时，论述了一体化管理体系构建中的几个主要问题，包括职业健康安全管理中的危险源辨识、风险评价和风险控制、顾客满意度的科学监测、法律、法规体系的完善、一体化管理体系与企业标准化体系的有机结合、统一的领导机构和工作机构、一体化的内部审核和管理评审。

Deepwater Taranaki is investigated for its petroleum potential, using all available seismic data tied to shallow-water wells.

运用与浅水井相关的现有全部震波探测数据考察了深海区塔拉纳基盆地的油藏前景。