查询词典 thermal equivalent

Test results show that the equivalent strain method exhibits a higher life assessment precision as compared to that by linear damage summation. The critical damage formula for equivalent strain can quite well predict the actual damage incurred and the equivalent strain-life curve with hardness modification fundamentally conforms with the pure fatigue strain-life curve.

试验结果表明，在预测寿命时等效应变法比线性累计损伤法具有更高的精度，等效应变的应力下临界损伤公式能够很好地预测实际损伤，考虑硬度修正的等效应变-寿命曲线和纯疲劳应变-寿命曲线基本一致。

In this thesis, the influence of column force, joint hoop reinforcement, and repeat load on the stress and sheer bearing capability of inclined pressure bar is analyzed utilizing finite element software. In the case study, the column axial force's influence on the inclined pressure bar's equivalent width, stress and sheer bearing capability of RCFEN is obtained by changing the column force when modeling the RCFEN with ANSYS. In the former model, the joint hoop reinforcement influence on the equivalent width inclined pressure bar and the strength of RCFEN is achieved by changing the quantity of joint hoop reinforcement; the inclined pressure bar's equivalent width and the strength variation of RCFEN under cyclic load are gained by applying low frequency cyclic load on the inflection point of column and the middle of beam.

针对上述算例中的框架外节点采用ANSYS进行建模，运用有限元软件分析了柱轴力、节点箍筋、反复荷载对外节点斜压杆承载力、抗剪承载力的影响：改变柱轴力，研究了柱轴力对斜压杆的等效宽度、框架外节点斜压杆承载力、框架外节点斜压杆抗剪承载力的影响；在上述模型中，改变节点箍筋的数量，分析了节点箍筋对斜压杆的等效宽度、框架外节点强度的影响；在上述模型中，在柱反弯点和梁中点均进行低周反复加载，讨论了在反复荷载作用下，框架外节点的斜压杆的等效宽度、框架外节点强度的变化情况。

On the basis of equivalent planar pitch,the tooth profile of the equivalent gear was gotten through simulation when the pitch curve of the gear shaper rolled on the equivalent planar pitch curve.

以平面当量节曲线为基础，通过确定插齿刀的节圆沿平面当量节曲线做纯滚动时插齿刀上各点的运动轨迹，模拟了插齿加工包络出当量齿轮的齿形过程，将非圆锥齿轮的设计转化为平面齿轮的设计，简化了非圆锥齿轮的设计。

The dynamic model and equivalent circuit are researched, A dynamic model and equivalent circuit in d-q frame of dual three-phase synchronous machine are presented for the first time, based on the analyzing of the inductance factor between the windings of synchronous machine under ideal conditions. From them, a dynamic model and equivalent circuit that has general significance is educed.

基于理想同步电动机模型，以相绕组为研究对象，对双电枢绕组同步电动机的动态数学模型进行了研究，首次推导出双电枢绕组同步电动机在d-q坐标系的动态数学模型，绘出了d-q坐标系等效电路。

Also, the performance of four techniques, using different approximation to estimate the equivalent peak value of shear stress and strain were investigated for the purpose to determine the equivalent shear modulus, damping, excess pore water pressure and residual strain induced by seismic loading, in which the equivalent peak value was computed in terms of its standard deviation and the corresponding peak factor.

利用上述动力有限元程序分别对水平地基进行了总应力、不排水有效应力和排水有效应力随机动力响应分析，并通过4种不同的方法来计算地基的等效剪切模量、阻尼比、振动孔压和残余剪应力。

The equivalent stress nephograms, the variation rule of pipe displacement and stress on the bellow pipe under expansion were obtained. It was found that the stress and strain of the pipe were symmetrically distributed over the geometric shape of the pipe,the equivalent stresses and equivalent strains at different points of the pipe varied with the curvature radius.

模拟了井眼中波纹管的膨胀变形，得到了波纹管施工加压膨胀和井壁接触过程中的等效应力分布云图、波纹管的位移、应力变化规律，以及波纹管膨胀后和井壁的接触状况。

There are few equivalent circuit modeling methods for UWB antennas. This thesis compares the characteristic of some existing modeling methods and presents a general and precise modeling method for UWB antennas. Firstly, establish the narrowband model of the antenna, and compute the difference between input admittances of the antenna and its narrowband model. Secondly, implement rational approximation of the difference to build the macromodel, and convert it into SPICE equivalent circuits. Lastly, combine the narrowband model and the macromodel to form the ultimate equivalent circuit model of the antenna.

本论文针对目前UWB天线等效电路建模方法比较少的现状，结合现有的天线建模方法的一些特点，研究了一种系统通用、模型精度高的新建模方法：首先建立超宽带天线的窄带模型，计算天线及其窄带模型导纳的差值；接着对差值进行有理多项式拟合，得到相应的宏模型，并转化为SPICE等效电路；最后合并窄带模型与宏模型电路，得到天线等效电路模型。

Both the mathematical mode of noise equivalent temperature difference and the noise equivalent eradiation difference are established for micro thermal imaging systems.

研究了显微热成像系统的噪声等效温差和噪声等效辐射率差模型，分析了显微热成像与望远模式热成像的差异。

Micro thermal imaging ; noise equivalent temperature difference ; mathematical model ; noise equivalent eradiation difference

显微热成像；噪声等效温差；数学模型；噪声等效辐射率差

Based on a computing model of floor heating residences, indoor thermal environment and heat distribution under the effect of heat charge/discharge, operation control and solar radiation has been concluded. Concept and formula of equivalent heat supply has been put forward which indicate that actual heat supply will be equal to the sum of design heat supply and equivalent heat supply. Recommend coefficient has been given taken Dalian as an example. Computed according to the new method, design heat supply can be reduced to 37% in cloudy day and 43.3% in sunny day, energy saving effect is very obvious. In Tromb wall solar house, effect of concrete wall on indoor temperature swing and attenuation of temperature wave is very obvious. While the outdoor air-temperature swing exceeds 10℃, indoor air-temperature swing belows 3℃. In the experiment, maximal difference in temperature between inner surface and outer surface of the 300mm wall exceeded 10℃. Heat storage and collector efficiency varies adversely according to solar radiation. Factors such as thickness, material, absorptance of the wall and permeation of the glass cover all have big influence on heat storage and collector efficiency. There exsisted an optimal thickness of the wall, which can make the best of heat storage and collector efficiency. Most of the heat stored in conventional Trombe wall during the daytime has been lost to the outside at night without heat preservation. Heat preservation on the outside surface of the wall has effectively improved heat release performance of the wall at night, heat supply to the room has increased too.

通过建立的地板采暖系统动态热性能分析模型，得出了在蓄放热特性、运行方式和太阳辐射等因素耦合作用下的室内热环境及热量分配比例，提出了等效供热量的概念及计算公式，指出实际所需供热量应等于设计供热量加上等效供热量，并以大连为例，给出了等效供热量的修正系数，以新方法计算，阴天可减少设计供热量37％，晴天最大可以减少设计供热量43.3％，节能效果显著；集热蓄热墙式太阳房中，混凝土蓄热墙的室温均一化效果和对温度波的削减作用非常明显，当室外温度波动最大幅度超过10℃时，室温波幅不超过3℃，实验中300mm厚墙体内外表面温差超过10℃；墙体蓄热效率与集热效率随太阳辐射照度的变化呈相反的变化趋势；墙体厚度、材料、表面吸收率以及盖板透过率等因素对集热和蓄热效率均有较大的影响，存在一个最佳的墙体厚度值，使得墙体集热和蓄热综合性能最优；传统的蓄热墙夜间没有外保温，辐射散热损失很大，研究表明墙体外保温方式明显改善了蓄热墙夜间的散热性能，增加了向室内的供热量。

Vishnu entered a dark fourth dimensional dream that did not support his field or continued life.

毗瑟挐进入了一个第四密度的黑暗梦想，那里并不支持他的能量场或继续生命。

Leaders and decision-making persons use it to collect the data, including the information of unit work, handing in fee, oweing fee, prepaying fee,changing and afterpaying and account transfering of joining-insurance employee, and account paying of all kinds of insurances from hospitalization insurance institutions.The collected data is picked up, organized, switched and showed to user.

该子系统主要面向各级领导、决策分析人员；从各个医疗保险经办机构和定点医疗机构采集数据，包括在各个医疗保险经办机构处理的单位办公信息，单位缴费、欠费、预缴费信息，参保职工变更信息，参保职工增减变动信息，参保职工补缴信息，参保职工帐户划拨信息：包括各定点医疗机构处理的各险种帐户支出信息，各险种的统筹金支付信息等；将采集的数据提取，组织和转换，然后展示给用户。