查询词典 thermal efficiency

Comparing the synchronous rectifier to normal circuit by calculating the efficiency indicates that forestay is much better on efficiency and thermal performance. A simple circuit with good consistency, high efficiency, high reliability and low cost is presented in this paper. The feasibility is proved by emulating with computer.

通过分析已有的集中解决隔离型变换器输出带预偏置电压启动的解决方案，提出了一种全新的一致性好、成本低、效率高、简单和可靠性高的解决隔离变换器输出有预偏置电压的启动问题的电路，通过仿真验证了其可行性。

The project ducts research on new sealing structure of power-type white light emitting diode to achieve low thermal resistance and emitting efficiency over 80lm/W. It can promote phosphor transfer efficiency and improve sealing technique procedure, introduce automatic production and testing equipment,to increase white light LED emitting efficiency and other performance indexes and further large-scale productivity.

本项目专题研制开发功率型白光发光二极管新型封装结构，实现低热阻、发光效率达80lm/W以上的LED光源封装能力，提升自制荧光粉转换效率与制备技术，改进现有封装工艺制程，引进自动化生产及测试设备，提升白光LED发光效率及其其它各项性能指标，形成批量生产能力。

Because nuclear power generation efficiency of thermal heat low, the thermal nuclear power generation thermal pollution than serious.

由於核能发电的热效率较火力发电低，故核能发电的热污染较火力发电严重。

The efficiency of the thermal analysis and thermal design is improved if the variation analysis method is used to the thermal analysis and the thermal design of the satellite.

将参数分析方法应用于卫星的热设计和热分析中，可提高卫星热设计和热分析的效率。

Based on a computing model of floor heating residences, indoor thermal environment and heat distribution under the effect of heat charge/discharge, operation control and solar radiation has been concluded. Concept and formula of equivalent heat supply has been put forward which indicate that actual heat supply will be equal to the sum of design heat supply and equivalent heat supply. Recommend coefficient has been given taken Dalian as an example. Computed according to the new method, design heat supply can be reduced to 37% in cloudy day and 43.3% in sunny day, energy saving effect is very obvious. In Tromb wall solar house, effect of concrete wall on indoor temperature swing and attenuation of temperature wave is very obvious. While the outdoor air-temperature swing exceeds 10℃, indoor air-temperature swing belows 3℃. In the experiment, maximal difference in temperature between inner surface and outer surface of the 300mm wall exceeded 10℃. Heat storage and collector efficiency varies adversely according to solar radiation. Factors such as thickness, material, absorptance of the wall and permeation of the glass cover all have big influence on heat storage and collector efficiency. There exsisted an optimal thickness of the wall, which can make the best of heat storage and collector efficiency. Most of the heat stored in conventional Trombe wall during the daytime has been lost to the outside at night without heat preservation. Heat preservation on the outside surface of the wall has effectively improved heat release performance of the wall at night, heat supply to the room has increased too.

通过建立的地板采暖系统动态热性能分析模型，得出了在蓄放热特性、运行方式和太阳辐射等因素耦合作用下的室内热环境及热量分配比例，提出了等效供热量的概念及计算公式，指出实际所需供热量应等于设计供热量加上等效供热量，并以大连为例，给出了等效供热量的修正系数，以新方法计算，阴天可减少设计供热量37％，晴天最大可以减少设计供热量43.3％，节能效果显著；集热蓄热墙式太阳房中，混凝土蓄热墙的室温均一化效果和对温度波的削减作用非常明显，当室外温度波动最大幅度超过10℃时，室温波幅不超过3℃，实验中300mm厚墙体内外表面温差超过10℃；墙体蓄热效率与集热效率随太阳辐射照度的变化呈相反的变化趋势；墙体厚度、材料、表面吸收率以及盖板透过率等因素对集热和蓄热效率均有较大的影响，存在一个最佳的墙体厚度值，使得墙体集热和蓄热综合性能最优；传统的蓄热墙夜间没有外保温，辐射散热损失很大，研究表明墙体外保温方式明显改善了蓄热墙夜间的散热性能，增加了向室内的供热量。

The microstructure and morphology are examined by SEM, XRD, EPMA, and the electrochemical performance is studied by potentiodynamic polarization and current efficiency. The results show that the alloy elements in the electrode coating prepared by the sol-gel process are well distributed, more sufficient to form solid solution and with higher current efficiency than by the traditional thermal decomposition process. The deactivation effect is due to the forming of unconductive TiO2 for the sol-gel process, but due to the dissolution of active composition for the thermal decomposition process.

SEM、XRD、电子探针、极化曲线、电流效率实验表明，由溶胶-凝胶法制备的氧化物涂层比热分解法制备的氧化物涂层的分散性好、形成固溶体充分、电流效率高；由溶胶-凝胶法制备的氧化物涂层的失效是由于生成不导电的TiO2引起，而由热分解法制备的氧化物涂层的失效是由于活性氧化物涂层的溶解引起。

The radiation by non-thermal plasma can accelerate formaldehyde thansform and make an increase of 29.61% in depurated efficiency. The surface modification makes no obvious difference in depurated efficiency. The chemical modification avails formaldehyde reduction and ACF coated with nano- TiO2 is the best of all that can enhand the depurated efficiency to 94%. The great influence of parameters on depurated efficiency , such as applied voltage and reaction time , shows that an increase in either applied voltage or reaction time enhance formaldehyde conversion.

研究结果表明：低温等离子体辐射能促进甲醛净化，可使其净化效率提高29.61%；表面改性对净化效率没有明显影响；化学改性有利于甲醛净化，其中负载纳米TiO2改性方案最佳，其净化效率高达94%；电源电压和反应时间等参数对净化效率也有较大影响，电压越大，时间越长就越有利于甲醛的去除。

The study of the fluid dynamic characteristics calculation method and its application for gas turbine secondary air network system, which is used for cooling and protecting the high-temperature components of turbine and for sealing and pressurizing chambers, are important to ensure the high thermal efficiency and the operation stability and safety of gas turbine.

研究用于燃气轮机高温部件的冷却与保护、密封以及腔室增压的二次空气系统的流体动力特性计算方法及其应用，对保证燃气轮机发电机组的热经济性与运行的稳定性及安全性具有重要作用。

In addition, you can use a number of combined cycle, such as mercury - a class 2 water steam cycle, steam - gas-fired combined cycle and so on to get closer to Carnot cycle in order to achieve higher thermal efficiency.

此外，还可以采用一些联合循环，如汞—水之类的两汽循环、蒸汽—燃气联合循环等来接近卡诺循环以达到更高的热效率。

The containment of heat and transfer of maximum heat to the T-bar permits a substantial improvement in thermal efficiency and a substantial reduction of power consumption.

热的保持和对T型杆最大的热传导允许热效率的很大改善和大大减小功率消耗。T型杆的加热边缘用容易替换的特氟隆涂覆的加热槽覆盖。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。