查询词典 thermal conductivity
- 与 thermal conductivity 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
The material of the invention has lower heat conductivity and higher coefficient of thermal expansion compared to the traditional zirconium oxide which is solidified by 7-8% yttrium oxide.
与目前普遍使用的7~8%氧化钇稳定的氧化锆相比,该材料具有低的热导率和高的热膨胀系数。
-
Because of the adulteration of rare earth ion and the lamellar structure of the calcium and titanium mine, the material has lower heat conductivity and higher coefficient of thermal expansion compared to the zirconium oxide which is stabilized by 7-8% yttrium oxide.
由于稀土离子的掺杂及其自身的层状钙钛矿结构,该材料与目前普遍使用的7~8%氧化钇稳定的氧化锆相比具有更低的热导率和更高的热膨胀系数。
-
The coordination process and structure between amidoxime modified polyacrylonitrile fiber and FeCl3 in aqueous solution were studied by using X-ray photoelectron spectroscopy, Fourier transforminfrared spectrometer, dynamic thermal mechanical analyzer, and electrical conductivity method, respectively.
在室温条件下应用偕胺肟改性聚丙烯腈纤维与FeCl3反应制备了聚丙烯腈纤维铁配合物,并分别使用X射线光电子能谱、傅立叶红外光谱、动态热机械分析和电导法对Fe-AO-PAN进行了表征以确定其组成结构。
-
Result of thermogravity analysis showed that the thermal stability of polyvinylamine chloride lowers with increasing in amination degree. Moreover, properties of dilute aqueous solutions of three types of poly chloride with different amination degree were compared by use of viscosimetric, conductometric, and potentiometric measurements. Results showed that both the electrostatic interaction of neighboring groups on the chain and the reduced viscosity of poly chloride are increased with increasing the degree of amination of poly . The equivalent conductivity is decreased with the increasing the concentration of poly chloride and increased with the increasing the amination degree of poly .
研究了聚乙烯胺盐酸盐的热稳定性和水溶液性质,发现:随着胺化度的提高,聚乙烯胺盐酸盐的对热稳定性逐步降低;聚乙烯胺盐酸盐是一种典型的聚电解质,其水溶液的pH值随平均分子量的变化并不明显,而随着聚乙烯胺胺化度的升高,pH值降低;随着聚乙烯胺盐酸盐的平均聚合度由82.3增加到201.8,它的m值(用于表征聚电解质侧链基团之间相互作用大小的常数)从5.13升高到5.58,而当聚乙烯胺盐酸盐的平均聚合度增加到311.4时,它的m值反而降低到了5.48;随着胺化度由55.65%升高到82.36%,m值由3.65提高到5.50;随着聚乙烯胺盐酸盐的平均聚合度的提高,聚乙烯胺盐酸盐的平均解离常数由7.48降低到7.26,同时随着胺化度的提高,聚乙烯胺盐酸盐的平均解离常数也由8.33降低到7.37;随着聚乙烯胺盐酸盐浓度的提高,溶液的摩尔电导率逐步降低,随着聚乙烯胺胺化度和聚合度的提高,溶液的摩尔电导率有所升高;在pH值为4左右时,聚乙烯胺盐酸盐的比浓粘度分别达到极值,而与聚合度的大小关系不大;聚乙烯胺盐酸盐的特性粘数明显高于其原料聚丙烯酰胺的特性粘数,分子量对特性粘数的影响十分明显,胺化度对特性粘数的影响并不显著。
-
Under the instruction of above-mentioned theoretical results, in the thesis chapter 10, the strongly electron-withdrawing anion, C_5O_5~(2-)[dianion of croconic acid (4,5-dihydroxycyclopent-4- ene-1,2,3-trione)], was chosen as the chelator to coordinate with boron to form lithium salt, which will yield high ionic conductivity solutions, and exhibit wide electrochemical stability windows and high thermal stability. As described in the chapter, two new lithium salts containing C_5O_5~(2-), lithium bisborate and its novel derivative, lithium borate for Li-ion battery electrolytes were synthesized.
在上述理论结果的指导下,论文第十章选择了克酮酸二价阴离子——具有很强的酸性、较好的芳香性、较大的电荷分散性、形成的配合阴离子具有较显著的共轭性——作为配体与B配位,合成了二种新的锂盐,通过实验测定了它们的结构和在有机溶剂中的溶解性。
-
The electrical conductivity and thermal expansion of La2Mo2O9 under low oxygen partial pressure were studied with the help of thermoelectric power and dilatometric measurements, respectively.
通过热电势和热膨胀测量,分别研究了La2Mo2O9在低氧分压条件下的电学性质和热膨胀行为。
-
Firstly, polyacrylamide with 26 million molecular weight was compounded in lab through establishing optimum compounding initiator proportionality of 1:1. 3 and mass concentration of 170 mgL^(-1), temperature of 10 ℃, acrylamide mass percentage of 25%, electrical conductivity of 3.6 μSm^(-1) and pH value of 6.57. The salt-resistance, thermal endurance and shear-resistance of polyacrylamide could be enhanced b introducing sulfonic acid group or styrene sulfonate group or drawing the two groups above at the same time. Secondly, chelator HEDP, bactericide isoquinoline ketone and oxygen scavenger thiourea were optimized to improve the compatibility of polyacrylamide and formation water.
在由室内试验确定了复合引发剂最佳比值1:1.3和质量浓度170 mgL^(-1)、合成最佳温度10℃、丙烯酰胺单体质量分数25%、电导率3.6μSm^(-1)和pH值6.57后,合成出相对分子质量高于2.6×10^7的聚丙烯酰胺,同时通过丙烯酰胺单体复配引入磺酸基团、苯乙烯磺酸基团或同时引入此两种基团,提高了聚合物的抗盐、抗温、抗剪切性能;后针对聚丙烯酰胺与地层水配伍性差的问题,优选出HEDP螯合剂、异噻唑烷酮杀菌剂和除氧剂硫脲,对聚合物稳定效果明显。
-
CNTs were first pre-treated using acid solution (HNO3) to obtain CNTs functionalized with carboxylic groups. Subsequently, the stearyl alcohol was grafted onto CNT with the assistance of dehydrating agent, N,N'-dicyclohexyl-carbodiimide. Excellent dispersion in organic solvents such as acetone, THF, and chloroform was found for the modified CNTs (CNT-C18). In addition, the PBS/CNTs nanocomposites were then prepared through simple melt-blending. Mechanical properties, thermal behavior, conductivity of resultant polymer/CNT composites were investigated. The results show that excellent dispersion of nanotubes in the PBS matrices was achieved.
为了增加多壁奈米碳管在复合材料中的分散性,将碳管表面进行化学修饰,首先将多壁奈米碳管浸入HNO3溶液中,进行酸化,使碳管表面带有羧酸的官能基,然后再加入十八烷醇,在温和的条件下,藉由N,N'-二环己基碳二亚胺(N,N'-dicyclohexyl- carbodiimide,DCC)脱水剂脱水,使碳管和十八烷醇之间产生酯基的化学键结,改质后的碳管可以分散在acetone、THF、chloroform…等有机溶剂中,结果显示成功的利用DCC脱水剂完成碳管的改质。
-
The dissertation designs a new type treble hole concrete block. Through adding the block holes number, its thermal resistance increases, but the coefficient of heat conductivity depresses.
本文研究设计了新的三排孔砌块块型,增加砌块的孔洞数,使之热阻增加,导热系数降低,并对其进行了试验研究。
-
The crystal structure,high temperature conductivity and thermal expansion curve of these samples were characteristiced and a selected sample was tested in the single cell.
对其进行晶体结构表征,高温电导率和热膨胀曲线测试,并选取其中性能较好的样品进行了单电池实验。
- 推荐网络例句
-
The concept of equivalent rotationally rigidity is offered and the formula of rotationally rigidity is obtained.
主要做了如下几个方面的工作:对伸臂位于顶部的单层框架—筒体模型进行分析,提出了等效转动约束的概念和转动约束刚度的表达式。
-
Male cats normally do not need aftercare with the exception of the night after the anesthetic.
男猫通常不需要善后除了晚上的麻醉。
-
Its advantage is that it can be used in smaller units.
其优点在于可以在较小的单位中应用。