英语人>网络例句>thermal charge 相关的网络例句
thermal charge相关的网络例句

查询词典 thermal charge

与 thermal charge 相关的网络例句 [注:此内容来源于网络,仅供参考]

Macro is /cast cold blood /cast envenom (or eviscerate your choice I made both tho)/use ur rocket glove item /use Global Thermal Sapper Charge.

6:00 我用了血之饥渴并且使用了"疯狂的"宏,可以瞬间对任何穿PVP装备的人造成1万2左右的伤害。

Further analysis showed that lightning was closely related to graupel and ice in middle atmosphere (3.2~7km) and upper atmosphere. This result is consistent to the charge mechanism of lightning. Meanwhile, this study went through the sensitivity of WISCDYMM settings on thermal bubble condition of triggering cloud growth.

探讨闪电数量与水象粒子质量百分比的关系,可发现高层大气(7.2 ~ 11公里)相关性较佳,若分析这些参数的时间序列特徵,可发现中层大气(3.2 ~ 7公里)与高层大气高度中,软雹与冰晶分别与闪电发生有明显的相关性存在,符合云中粒子带电之理论。

The thermal emittance was measured with solenoid scan method under the condition of very low charge for which the space charge induced emittance growth is negligible.

针对低发射度的测量问题,我们在清华大学光阴极微波电子枪实验平台上开展了一系列先进束流测量方法研究。

The characteristics of charge storage in APCVD Si 3N 4/thermal\|grown SiO 2 double layers electret films, charged by coroma were investigated by measurements of isothermal surface potential decay and thermally stimulated discharge.

利用等温表面电位衰减及热刺激放电(thermallystimulateddischarge ,TSD)方法探讨了恒栅压电晕充电经常压化学气相沉积的Si基Si3N4 和热生长SiO2 双层薄膜驻极体电荷的存储特性。

Therefore, how to improve cellular PP films\' thermal stability of piezoelectricity and charge storage becomes one of the focuses in the field of the functional dielectric materials.

因此,如何改善这种功能膜的储电及压电热稳定性是近年来倍受关注的课题。

It is found that, the quantum fluctuations of charge number and phase-difference in free thermal state are related to not only the parameters of the circuit, but also the temperature, and the average energy stored in the capacitance and inductance is equal to each other.

结果表明,体系中电荷数及相位差在自由热态下的量子涨落不仅和电路中器件的参数有关,而且还和温度有关,且储存于电感中的平均能量和电容中的平均能量分别相等。

Increased siege damage caused by Saronite Bombs and the Global Thermal Sapper Charge.

提高了萨隆邪铁炸弹和通用热力工程炸药造成的攻城伤害。

Through designing of composition and structure of the bioactive graded coating,innerstress and its distribution in the coating were analyzed and calculated, the resultsshowed that when composition distribution coefficient n was 1.5, a reasonable stressdistribution could be got, that was at the beginning of deposition the suspension containingrichly BG granules was used so that a rich BG granules layer, a good transitional layerbetween BG layer at the bottom and the coating could be obtained at the titanium alloy side,the bottom of the coating; the stress value near the interface and surface and its character,pressure stress or tensile stress, were decided by the character of its composition itself.Changing composition distribution coefficient n could only change the variation tendency ofstress in the coating, but did not change the stress distribution rule in the coating. Thethinner the coating is, the sharper stress variation in the coating is, which does not mean thatthicker coating is better because the thicker the coating is, the little the permitteddeformation of coating is, so the coating thickness should be thinner, for example, about50μm for bending applications, but for applications only bearing pure shear stress, such asroot of tooth implant, the coating can be thicker little, for instance, about 80~100μm. The study on electrification characteristic and electrophoresis deposition of HAand BG granules in aqueous and non-aqueous solution system found that EPD almost didn'toccur in aqueous solution system. However, because HA granules take position charges inabsolute alcohol, a homogeneous EPD be carried out on the cathode titanium alloy slice, but taking negative charge in absolute alcohol the BG granules not be deposited on the cathode. A guided HA crystallizing, 100~300nm, on surface of the BG granules be realized by metathetical reaction, which cover BG granules with HA microcrystals and make the covered BG granules taking position charges in absolute alcohol, sequentially realize the EPCD of the BG and HA granules on the cathode, so it is feasible to make a titanium alloy/BG/HA bioactive graded coating by making use of EPCD technology. The corrosion experiment of rich boron bioglass coating and plasma spray coating showed that split phase, rich boron and rich silicon phase, occurred during its preparation. In basic medium the corrosion behavior of 〓 BG coating showed uniformity corrosion, the corrosion mostly occurred at rich boron phase area, therefore batch formula design of BGshould avoid the occurring of split phase. The corrosion appearance of plasma spray coatingappeared a non-uniform corrosion, mostly occurred at the edge of the laminated HA moltendrops, and emerged an accelerated corrosion tendency, which will easyly lead to corrosioncrackles extending to the interface and the happening of osmotic interfacial corrosion, thatmay be one of the major reasons leading to the coating cracking-off in the later period. Thetesting results of thermal expansion coefficient of 〓 and 〓BG showed the thermalexpansion coefficient of 〓 BG matched with that of titanium alloy better, and 〓 BG couldsinter with titanium alloy into densification enamel layer at low temperature (720℃).

将Ti6Al4V合金在1000℃下进行真空热处理会降低其力学性能,且合金内的V元素会向表面富集,因此,钛合金真空热处理和表面涂层的烧结温度不能过高,即应低于其相转变点;通过对生物活性梯度涂层的组成和结构的设计,分析和计算了梯度涂层内的应力大小和分布,结果表明:对于本研究,当成分分布系数n=1.5时,可以获得较合理的涂层力学性能,即在沉积开始时,采用富含BG颗粒的悬浮液,以便在钛合金侧获得同底层BG有良好过渡的富BG涂层;梯度涂层界面和表面的应力大小、性质由材料组成本身的性质决定,改变成分分布系数,只能改变涂层内应力变化的趋势;涂层的厚薄不影响涂层内的应力分布规律,但涂层越薄,涂层内的应力变化越快,但这并不意味着涂层越厚越好,因为涂层越厚,涂层允许的变形越小,对于应用于弯曲受力部位的涂层而言,涂层应薄一点为好(50μm);而对于仅纯受剪切应力的部位,如牙根种植体,涂层可适当加厚(80~100μm);通过对HA和BG颗粒在水溶液体系和非水溶液体系中的带电特性和电泳沉积的研究发现,它们在水溶液体系中很难发生电沉积;在无水乙醇溶液中,HA颗粒带正电,可在阴极钛合金片上发生均匀的电泳沉积,而BG颗粒则带负电荷;利用复分解反应法,可以制得100~300nm的HA,通过诱导HA在BG颗粒表面结晶,可对BG颗粒进行表面包覆,获得了被HA包覆的BG颗粒,改变了BG颗粒表面的带电特性,使BG和HA颗粒在无水乙醇中均带上正电荷,从而实现了HA和BG颗粒在阴极上的共沉积。

In this paper, 4-4-(trifluoromethoxy benzoyl cyclohexyl-3, 5-diaminobenzoate with a large branch chain, pyromellitic dianhydride and 4-(4-aminobenzyl) benzenamine were used to synthesize polyimides. The effect of monomer charge order on pretilt angle was investigated for the first time when PIs were used as LC alignment layer, and the effect of diamine mole ratio on pretilt angle was studied. The thermal stability of the pretilt angle was discussed.

文章用均苯四酸二酐、4,4'-二胺基二苯甲烷和具有较大支链的4-(4-苯甲酰基)环己基-3,5-二胺基苯甲酸酯等单体制备聚酰亚胺,首次研究了单体加料顺序对液晶预倾角的影响,同时也研究了二胺配比对液晶预倾角的影响问题,并探讨了预倾角的热稳定性等问题。

Based on a computing model of floor heating residences, indoor thermal environment and heat distribution under the effect of heat charge/discharge, operation control and solar radiation has been concluded. Concept and formula of equivalent heat supply has been put forward which indicate that actual heat supply will be equal to the sum of design heat supply and equivalent heat supply. Recommend coefficient has been given taken Dalian as an example. Computed according to the new method, design heat supply can be reduced to 37% in cloudy day and 43.3% in sunny day, energy saving effect is very obvious. In Tromb wall solar house, effect of concrete wall on indoor temperature swing and attenuation of temperature wave is very obvious. While the outdoor air-temperature swing exceeds 10℃, indoor air-temperature swing belows 3℃. In the experiment, maximal difference in temperature between inner surface and outer surface of the 300mm wall exceeded 10℃. Heat storage and collector efficiency varies adversely according to solar radiation. Factors such as thickness, material, absorptance of the wall and permeation of the glass cover all have big influence on heat storage and collector efficiency. There exsisted an optimal thickness of the wall, which can make the best of heat storage and collector efficiency. Most of the heat stored in conventional Trombe wall during the daytime has been lost to the outside at night without heat preservation. Heat preservation on the outside surface of the wall has effectively improved heat release performance of the wall at night, heat supply to the room has increased too.

通过建立的地板采暖系统动态热性能分析模型,得出了在蓄放热特性、运行方式和太阳辐射等因素耦合作用下的室内热环境及热量分配比例,提出了等效供热量的概念及计算公式,指出实际所需供热量应等于设计供热量加上等效供热量,并以大连为例,给出了等效供热量的修正系数,以新方法计算,阴天可减少设计供热量37%,晴天最大可以减少设计供热量43.3%,节能效果显著;集热蓄热墙式太阳房中,混凝土蓄热墙的室温均一化效果和对温度波的削减作用非常明显,当室外温度波动最大幅度超过10℃时,室温波幅不超过3℃,实验中300mm厚墙体内外表面温差超过10℃;墙体蓄热效率与集热效率随太阳辐射照度的变化呈相反的变化趋势;墙体厚度、材料、表面吸收率以及盖板透过率等因素对集热和蓄热效率均有较大的影响,存在一个最佳的墙体厚度值,使得墙体集热和蓄热综合性能最优;传统的蓄热墙夜间没有外保温,辐射散热损失很大,研究表明墙体外保温方式明显改善了蓄热墙夜间的散热性能,增加了向室内的供热量。

第1/2页 1 2 > 尾页
推荐网络例句

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发,分析对称连杆曲线上鲍尔点的产生条件,提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品,年生产总值3000万美元,产品价廉物美、选料上乘、质量保证,深受国内外客户的青睐

The eˉtiology of hemospermia is complicate,but almost of hemospermia are benign.

血精的原因很,以良性病变为主。