查询词典 tension

Based on structural characteristics, tension schemes were compared optimally to select radial steel pull rod tension method at last during the construction of prestressed cables.

结合工程结构特点，对张拉方案进行优化比选，最终确定选择径向钢拉杆张拉法进行预应力拉索施工。

But both of them are 380 lines per inch, the diameter of 34 Micron screen lines of tension than 31 Micron diameter wire-mesh line fuelled tension?

但是同样是380线/英寸，直径为34微米的丝网线所能撑持的不不弛力是否比直径为31微米的丝网线所撑持的不不弛力不小呢？

This thesis has studied Levy system Cable dome's tension and simulated 24 tension schemes by using finite element analysis software.

本文所完成的Levy体系索穹顶结构的结构选型，节点设计，张拉方案研究是对现有索穹顶结构理论研究的有益补充，并为索穹顶结构在我国的工程应用提供参考。

On the basis of thermoviscoplastic theory, the dynamic recrystallization model of tension was constructed. This model was introduced into the finite element analysis of tension of AZ31 magnesium alloy sheet by changing temperature.

摘 要：基于热粘塑性本构理论，构建拉伸动态再结晶理论模型，并将该模型引入AZ31镁合金薄板变温拉伸的数值仿真。

The structure internal forces were analyzed under different kinds of tension using a finite element computation model for the whole bridge with Midas software,and rational tension values and subsequence are finally calculated.

结合系杆拱桥的设计方案，对吊杆张拉力的控制进行分析计算，并利用Midas程序建立全桥的有限元分析模型，分析比较几种张拉情况下的结构内力变化情况，最终得出比较合理的张拉力取值及顺序，分析结果可为同类桥梁的设计与施工提供一定的参考。

The stress distribution on the cross section of geotextile with a circle or an ellipse or a square hole under uniaxial tension or double-axial tension was calculated with boundary element method program. The results show that the stress concentration appear at the range from the hole side to about 3 times of the hole diameter, and the degree of stress concentration near the hole is related to the shape of the hole, the size of the hole, the position of the hole and the dimension of the specimen.

用边界元法程序分别对开有圆孔或椭圆孔或方孔的土工织物试样在单向与双向拉伸时孔截面上的应力分布情况进行了计算与分析，结果表明：土工织物孔截面上的应力集中出现在距孔边3倍左右的孔径尺寸范围内；孔边附近应力集中的程度与孔的形状、大小、位置及试样的尺寸有关。

Taking Rong hu bridge project as the background, the paper Studies on the optimization of dead load cable tension, construct system of controlling, effect of non-linear factor, limit bearing capacity of structure and spatial stress of concrete-filled steel tubular tower and the combination of girder, which are based on the hybrid cable-stayed bridge.Asking for the maximal deformation of tower and girder to be minimized and cable permissible stress as constraint conditions, the paper tries to solve the ideal dead load cable tension by combining finite element calculation and optimize analysis.

本文以蓉湖大桥工程为背景，就混合梁斜拉桥的成桥恒载索力优化、施工监控体系、过程非线性因素影响、结构极限承载力、索塔和主梁结合部的空间应力分析等问题开展研究：关于索力的优化，是以斜拉桥索塔和梁的最大变位最小为目标，以拉索容许应力为约束条件，采用有限元计算与优化分析相结合的方法来确定斜拉桥的成桥合理恒载索力。

It is a very small number when you join, you can significantly reduce the surface tension of the solution or the interfacial tension of two, and can improve the solution by dissolving, emulsifying, dispersing, wetting, foaming and washing effect material.

它在加入量很少时，就能显著降低溶液的表面张力或二相间界面的张力，并能改进溶液的增溶、乳化、分散、润湿、发泡和洗涤等作用的物质。

The size of material roll direct impact on the film the tension and the tension and the momentum of large volume of material for the formation of inertia.

料卷的直径巨细间接感化薄膜的不压力，这个不压力与不小料卷的动量变成的惯性有关。

Through the tension sensor to receive signals transmitted by the internal smart PID output signal after processing, regulation of the implementing agencies to control the tension right size roll diameter changes.

通过接收张力传感器传送的信号，经内部智能PID运算处理后输出信号，调节执行机构，以控制张力大小适卷径的变化。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。