查询词典 tensile

According to time-temperature characteristic of hot stamping, tensile experiments were carried out for hot stamping steel USIBOR1500 at the temperature 600℃~800℃ and strain rate 0.01/s~0.5/s on the test machine Gleeble3800 and corresponding stress-strain curves were obtained.

根据热冲压工艺的时间－温度特征，采用Gleeble3800热模拟系统，在温度600℃~900℃、应变速率0.01/s~0.5/s下，对热冲压钢板USIBOR1500进行热拉伸实验，获得了相应的应力－应变曲线。

The influences of deformation rate on the mechanical properties of 304 austenitic stainless steel were studied by tensile test at room temperature.

采用室温拉伸实验研究了不同变形速度对304奥氏体不锈钢力学性能的影响规律。

Taking 2A11 Al-alloy for example,a simple tensile test to bar stock with MTS 810 material test system was done.

1引言在弹塑性力学的发展中，材料简单拉伸试验是建立材料本构关系和测定材料常数的主要宏观方法之一[1，2]。

Taking 2A11 Al-alloy for example, a simple tensile test to bar stock with MTS 810 material test system was done.

以2A11铝合金材料为例，采用美国MTS公司生产的MTS 810 Material Test system对棒材试样作简单拉伸试验。

Stage 3: When the load was increased beyond P1 (greater than 6000 lb, 26.7KN), tensile stresses in concrete at the tension zone increased until they were greater than the modulus of rupture fc, and cracks developed.

阶段3：当装载在P1 (大于6000磅之外被增加了， 26.7KN)，张应力在混凝土在紧张区域增加了，直到他们大于破裂fc的模数，并且被开发的镇压。

This paper describs the requirements of testing members to be nominal, the precedure of exerting load upon the tension rod, specific cautions and the effect upon the construction, for the application of the shear type constant force tester to measure initial tensile force of the rod in the wharf construction for the Port of Tangshan .

阐述在唐山港码头施工中应用剪式恒力仪测定拉杆初拉力时对标定试件材料的要求、拉杆施力的过程和须注意的具体问题以及施工效果。

In each construction stage, it is need to determine the tensile force of cables and the camber to ensure the cable tension and the line are reasonable when completed the bridge.

在每一个施工阶段，需要确定当前拉索的张拉力和预拱度，以确保竣工时索力和线形都达到合理成桥状态。

When a small amount of poly was added, the surface resistivity of PVC materials was not sensitive to atmospheric humidity and was further reduced, and the tensile strength and break elongation of PVC, however, were improved.

在上述抗静电PVC材料中添加一定量的聚氧化乙烯，可以降低抗静电材料对环境湿度的依赖性，并提高PVC材料的力学性能和抗静电性能。

Results were obtained only for a surface layer on the tensile side of the plate.

只能在板的受拉侧的表面层得到结果。

V type composite insulator string, which has advantages of light weight, easy cleaning, high tensile strength and stable post buckling, is a key component of compact line.

V型合成绝缘子串是紧凑型线路的重要组成部分，具有重量轻、易清洗、抗拉强度高的优点以及稳定的后屈曲抗压能力。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。