查询词典 tensile

The test data of mechanical properties showed that the tensile strength and the elongation at break of PUE reached the maximum value as 46MPa and 732% respectively when THEIC mass fraction up to 10%.

力学性能测试结果表明：当赛克质量分数为10%时，PUE的拉伸强度和拉断伸长率达到了最高值，分别为46MPa和732%。

The results showed that the m-PUE had better heat-resistant properties, lower glass transition temperature, higher thermal decomposition temperature and better damping property. The internal friction peak was changed from 10 ℃ to -10 ℃, while the tan δ was changed from 0.28 to 0.46. The hardness, tensile strength and tear strength of m-PUE decreased with the increase of the THEIC content. However, the swelling ratio of PUE was increased meaning a deteriorated solvent resistance property.

结果表明，引入IS环后，PUE的耐热性能有提高；IS改性的PUE的内耗峰比未改性的窄，峰位由10℃移到-10℃，且内耗峰值增大（tanδ由0.28增大到0.46），玻璃化温度降低，而阻尼性能得到提高；引入IS环的PUE的硬度和其它力学性能比未改性的PUE有所降低；随着固化剂中THEIC用量的增加，PUE的溶胀率增大，即IS改性PUE的耐溶剂性变差。

And undertook stampings, tensile mold, and product processing business.

并承接冲压件，拉伸模具、及产品加工业务。

In fact, we had obtained polythiophene films with high quality in BF3 ethyl ether, a kind of solvated Lewis acid. The electric conductivity of the polythiophene film is a bout 100 Scm-1. and the tensile strength is as high as 140 MPa, which is forty percent higher than that of aluminum.

事实上，我们已经从一种Lewis酸催化下的低电位聚合体系—噻吩/三氟化硼乙醚溶液中得到了高质量的聚噻吩薄膜，在降低了的聚合电位下得到的聚合物具有优异的力学及电学性能：拉伸强度达140MPa(比金属铝高40%)，电导率则可达100Scm-1。

In fact, we had obtained polythiophene films with high quality in BF〓-ethyl ether, a kind of solvated Lewis acid. The electric conductivity of the polythiophene film is about 100Scm〓, and the tensile strength is as high as 140Mpa, which is forty percent higher than that of aluminum.

事实上，我们已经从一种Lewis酸催化下的低电位聚合体系-噻吩/三氟化硼乙醚溶液中得到了高质量的聚噻吩薄膜，在降低了的聚合电位下得到的聚合物具有优异的力学及电学性能：拉伸强度达140MPa（比金属铝高40％），电导率则可达100Scm〓。

The weight loss,tensile strength and wettability of treated silica glass fibers were compared and the way of washing the silica glass fibers with 30% sulphuric acid was chosen.Al2O3 coating silica glass fibers was prepared by solgel technology.

首先采用三种处理方法除去石英纤维表面的有机层，比较了处理前后石英纤维的失重、拉伸强度和浸润性变化，最终优选出30%硫酸洗涤的方法对石英纤维表面进行处理。

Cement. Has 10 times the tensile strength of silicones.

，其接口的拉力比硅酮制品强九倍。

The result showed that after the treatment of the high-shear fiber kneader, the content of shives of the pulp will decrease 87％or more, the tensile index of the pulp sheets increases 22.6％, the tear index increases 28.8％, and the burst index increases 39.1％.

实验结果表明：纸浆中的纤维束去除率可达87％以上；纸浆纤维形态发生了变化，纤维的柔软度有所提高；纸浆的游离度略有下降，但对纸浆滤水性能影响甚微。

Experimental results showed that the CPF improved the retention of precipitated calcium carbonate filler significantly. With 0.9% CPF (based on oven-dry pulp), the retention of PCC increased from 57.53% to 72.21%. The physical properties of paper were also slightly improved. The tensile strength and burst strength of the paper with CPF were higher than those with CPAM.

结果表明，用作麦草浆湿部添加剂的制得的阳离子纸浆纤维能显著提高沉淀碳酸钙填料的留着率，添加0.9%的CPF即可使PCC的留着率从57.53%提高到72.21%，同时能够对纸张的物理性能有所改善，添加CPF的麦草浆成纸的抗张强度和耐破强度要明显高于添加CPAM的，而不低于添加未改性加拿大漂白针叶木浆纤维的。

Seeling, etc. explored at a two-way hollow mold hearth pore distribution, and Chen and Zhou indicate stress state on cavitation phenomena can be used bi-directional tensile test.

泽林等探讨了在双向炉缸模具中空孔分布，而陈和周表明应力状态对空穴现象的影响可利用双向拉伸实验。

Plunder melds and run with this jewel!

掠夺melds和运行与此宝石！

My dream is to be a crazy growing tree and extend at the edge between the city and the forest.

此刻，也许正是在通往天国的路上，我体验着这白色的晕旋。