查询词典 tensile

The main mechanical properties in warp and weft direction of the hollow integrated core sandwich composites are obtained by edgewise tensile, edgewise compression, flatwise tensile, flatwise compression, double lap shear, and four point bending experiments. Some properties are compared with the honeycomb sandwich composites.

对整体中空夹层复合材料经、纬向的侧拉、侧压、平拉、平压、双层剪切和4点弯曲等性能进行了实验研究，获得了该种材料的主要力学性能参数，并与类似的蜂窝夹层材料部分力学性能进行了对比。

The main mechanical properties in warp and weft direction of the hollow integrated core sandwich composites are obtained by edgewise tensile,edgewise compression,flatwise tensile,flatwise compression,double lap shear,and four point bending experiments.

对整体中空夹层复合材料经、纬向的侧拉、侧压、平拉、平压、双层剪切和4点弯曲等性能进行了实验研究，获得了该种材料的主要力学性能参数，并与类似的蜂窝夹层材料部分力学性能进行了对比。

The synthesized PCU was then characterized by infrared spectroscopy, differential scanning calorimetry, thermogravimetric analysis, small-angle X-ray scattering, and tensile strength measurement. The IR showed that the polymer synthesized by the above two methods both have the polycarbonate-urethane structure and the tensile measurement showed good mechanical performance of the polymer. The DSC and TGA data showed that there is an obvious soft-hard glass transition area, which indicated the existence of the micro-phase separation structure. The extent of the phase separation was affected by the ratio of starting materials, the molecular weight of PCD, and the polymerization method. The decomposition upon heating was observed in two steps. SAXS result showed that the radius (r_2), the distance between domains (d_2), and gyral radius (R_2) of hard segment micro-domain were fairly affected by the starting materials ratio and soft segment content.

IR结果表明两种方法合成的聚合产物均具有聚碳酸酯聚氨酯的结构；拉伸实验表明聚合产物具有良好的力学性能；DSC、TG结果表明，聚合物呈现出较为明显的软硬段玻璃化转变区，表明存在微相分离的结构，相分离的程度受原料配比、软段分子量、聚合方法的影响，其热分解分为明显的两个阶段； SAXS结果表明，聚合物原料配比、软段含量的变化对硬段微区回旋半径R_2，微区间距d_2，微区半径r_2影响不大其值分别为9.5(A|°、29、7.4，但对软段的微区半径及间距影响较大，随着软段含量的增大，软段微区的半径r1和间距d1都增大。

Totally 60 semi-circular bending specimens cored from superpave gyratory compactor with three groups of notch depths are tested at the temperature of-10 and 20℃ The experimental results reveal good repeatability in EAM characterization. The tensile strength ratio of SCB to the indirect tensile test is at a range of 1.4 to 1.7, and the ultimate strength of EAM is exponentially dependent on the notch depths. At the test temperatures, the critical J-integral value of EAM is much higher than that of hot mix asphalt with thermoplastic asphalt binder. The response mode of EAM changes from ductile mode to brittle mode and the fracture energy increases 30% when temperature decreases from 20 to-10℃, while its critical J-integral value decreases only 15%.

结果表明，环氧沥青混合料的半圆弯曲试验结果复现性好；由非切口试件的半圆弯曲试验与标准间接拉伸试验所测得的环氧沥青混合料的抗拉强度，其比值在1.4~1.7之间，且SCB抗拉强度与切缝深度指数相关；在20℃与－10℃试验条件下，环氧沥青混合料具有比热塑性HMA高得多的临界J-积只分值；当温度由20℃降至－10℃时，环氧沥青混合料的响应模式由延性变为脆性，断裂能增加30%，而临界J-积分值下降15%。

In this paper, the 3-D finite element relocating mesh method is used to calculate the temperature field and the thermal creep stress field of spillway dam and mid level outlet dam in certain roller compacted concrete gravity dam, sensitivity analysis have been down with different parameters, such as placing temperature, the location of cooling pipe, cooling temperature, time for water supply, ascended-layer of concrete, intermissive time and different placing time, and the commendatory construction scheme have been put forward in such analysis; according by the test result on the two scheme of concrete aggregate combination (basalt as coarse aggregate and limestone as fine aggregate, basalt as coarse aggregate and basalt as fine aggregate), simulation analysis on temperature field and thermal creep stress field of the commendatory construction scheme have been down, and analysis have also been down on temperature field and thermal stress field of the two different aggregate combination, the result indicates that the spillway dam and mid level outlet dam which adopted these two aggregate combination can both satisfy the require of design crack resistance in concrete, furthermore limestone as fine is better than basalt as fine aggregate; the effect of summer water storage and winter water storage on the temperature field and thermal stress field have been analyzed, comparing with winter water storage, in summer water storage scheme the maximum tensile stress at abnormal concrete in upstream fill is decreased by 0.1～0.3MPa and there are no evidence change of the maximum tensile stress at other parts, which indicate that summer water storage is avail for the crack resistance of upstream fill; according to the simulation calculating result and comparing temperature simulation calculating results and temperature controlling measures of some similarity projects both completed and construction, synthesis appraise have been carried to the design temperature controlling measures of dam, and the temperature controlling measures of this project have been brought forward, all these have great reference value on the design of temperature controlling measures and the optimization of the construction scheme.

本文采用三维有限元浮动网格法仿真计算程序，对某碾压混凝土重力坝的溢流坝段和中孔坝段分别进行了三维有限元温度场和温度徐变应力仿真计算分析，对浇筑温度、冷却水管的布置方式、冷却水温、通水时间、浇筑升程和间歇时间、不同开始浇筑日期等参数进行了敏感性分析，在此基础上提出了推荐的施工方案；根据两种骨料方案(玄武岩粗骨料+灰岩细骨料方案；玄武岩粗骨料+玄武岩细骨料方案)的混凝土性能试验研究成果，对推荐的施工方案进行了温度场和温度徐变应力仿真计算，并对比分析了两种不同骨料情况下的温度场和温度应力，结果表明溢流坝段及中孔坝段采用上述两种骨料均能满足混凝土的抗裂设计要求，且灰岩细骨料优于玄武岩细骨料；计算分析了夏季蓄水和冬季蓄水对坝体温度场和温度应力的影响，夏季蓄水方案与冬季蓄水方案相比，坝体上游变态混凝土区域最大拉应力小0.1～0.3MPa，其他部位最大拉应力无明显变化，夏季蓄水对坝体上游面混凝土的抗裂有利；根据仿真计算成果并通过比较国内一些已建和在建的类似工程的温度仿真计算成果及采取的温控措施，对大坝的设计温控措施进行了综合评价，并提出了该工程的温控措施，对温控设计和优化施工方案具有重要参考价值。

The microstructures and tensile properties of artificial aging and natural aging a new aluminum matrix sliding bearing alloy TZS88 were investigated by SEM,metallograph analysis,hardness and tensile tests.

通过金相显微镜、扫描电镜观察、硬度和拉伸试验研究了自然时效和人工时效状态下新型铝基合金TZS88的组织与性能。

I produced tensile properties tensile¤strong, transparent flat, rolling and firm, self-adhesive, and is assembled goods, transporting, loading and unloading mechanization ideal packaging supplies, packaging, convenient, fast, high-performance anti-puncture tear low cost, play a cargo dust, moisture, mothproof, the role of anti-collapse and packaging.

我公司生产的拉伸缠绕膜拉伸性能强，透明平整，收卷结实，自粘性强，是货物集装、储运、机械化装卸的理想包装用品，包装方便、快捷、抗穿刺撕裂性能高、成本低，起到货物的防尘、防潮、防蛀、防倒塌及包装作用。

Weibull distribution function is used to characterize phenomenologically the debonded probability of the interface, which is decided by the tensile stress of the particle. A partially debonded isotropic spherical elastic particle is replaced by an equivalent, perfectly bonded spherical particle, which possesses yet unknown transversely isotropic elastic moduli. The fictitious particles can be determined in such a way that their tensile and shear stresses will only vanish in the debonded direction.

认为颗粒增强金属基复合材料的界面脱黏受控于颗粒所受的拉应力，引入Weibull分布函数描述颗粒脱黏概率，且受单向拉伸载荷作用时，仅在沿受力方向的上下两侧发生部分界面脱黏，从而将部分脱黏的各向同性颗粒由一完好的横观各向同性颗粒来等效，建立了部分脱黏模型。

To guarantee high quality,BRIGHTWAY has brought in a large batch of the latest advanced equipment from around the world such as omnipotent material tester,M/I index tester,heat deflection temperature tester,RoHS test equipment,aging property tester etc.All of the production processes are under strict control and supervision ofour experienced enginners. Density,flow index,hardness,tensile-strength,tensile stetch, bending strength, flexural modulus,impact strenght, mould shrinkage factor, heat deflection temperature, fibre glass contents, water absorption, combustibility will be tested strictly by the professional engineers.

为了确保产品的高品质，百莱威引进了大量国际新一代的先进设备，如万能材料试验机、M/I指数测定仪、热变形温度测定仪、RoHs检测设备、耐老化试验设备等等，并且所有的生产过程都受到了严格的质量控制，由经验丰富的专业工程师进行了密度、流动指数、硬度、拉伸强度、伸长率、弯曲强度、冲击强度、模收缩率、热变形温度、玻纤含量、吸水率、燃烧性能等十多项苛刻的评审和检测。

The tensile property was improved and then stable with the increasing content of coupling agent, however, the crupture ratio up and then down. And the tensile strength increase stey by step and electric insulation property is up and then descended with the addition of radiation agents.

结果表明，随着阻燃剂含量的增加和粒径超细化，其阻燃性能不断得到提高；而随着偶联剂含量的增加，其拉伸强度逐渐增大到一定程度后趋向稳定，断裂伸长率则先增大后下降；随着辐照剂量的增大，拉伸强度逐渐增大，电气绝缘性能先上升后下降。

They weren't aggressive, but I yelled and threw a rock in their direction to get them off the trail and away from me, just in case.

他们没有侵略性，但我大喊，并在他们的方向扔石头让他们过的线索，远离我，以防万一。

In slot 2 in your bag put wrapping paper, quantity does not matter in this case.

在你的书包里槽2把包装纸、数量无关紧要。