查询词典 tensile

8Co alloy have been studied by means of optical and transmission electron microscopy, X-ray diffraction, dilatometry, tensile tests and Vickers hardness measurements. The inherent factors responsible for the low shape memory effect of polycrystalline Fe-Mn-Si alloys have been revealed.

本文通过金相、透射电镜及X-射线衍射分析以及热膨胀、拉伸和硬度试验等手段研究了Fe-25.6Mn-5.1Si-4.1Ni-1.8Co合金中应力诱发γ→ε马氏体相变和形状记忆效应，揭示了引起多晶Fe-Mn-Si系记忆合金形状记忆效应低的内在因素。

Percussvie is the dominant factor in percussive dilling and the process is similarto the impact test process.the process is retaled to rock compressive and tensile stength.

Percussvie是在有敲击特征dilling的统治因素，并且过程是冲击试验process.the过程retaled晃动压缩和拉伸stength的similarto。

Disclosed are certain moisture curable prepolymers formed by the reaction of diphenylmethane diisocyanate with conventional polyether polyols to produce sealants and coatings exhibiting excellent combinations of physical properties; most notably high tensile strength, high tear resistance, and high elongation.

公开了通过二苯基甲烷二异氰酸酯与习用的聚醚多元醇反应形成的某种湿固化的预聚物，以生产显示杰出综合物理性质(最显著的高拉伸强度、高抗撕裂强度和高伸长度)的密封胶和涂料。

Proper pre-deformation will make T1 phase distribute more dispersively and homegeneously, greatly improving the tensile properties of the alloy.

过大的预变形量使T1相变得粗大且分布不均匀，合金强度降低。

Proper pre-deformation will make T1 phase distribute more dispersively and homegeneously,greatly improving the tensile properties of the alloy.

通过显微组织观察和室温拉伸实验，研究了固溶热处理制度和时效前预变形对Al-Cu-Li-Sc-Zr合金拉伸力学性能和显微组织的影响。

In the absence of additional cross-linker, increasing molding temperature from 25 to 125℃significantly enhances crosslinking density of the three-dimensional proteinnetwork through disulphide bonding, leading to increase of tensile strength, Young\'smodulus and relaxation time.

未添加任何交联剂时，仅将模压温度从25℃升高到125℃，可提高蛋白质网络的二硫键交联密度，导致拉伸强度和杨氏模量增高、松弛时间延长。

Ankle Foot Orthosis is usually applied for stroke patients to prevent foot drop during swing phase, and provides some range of ankle dorsiflexion after mid stance phase on walking. These conditions cause cyclic tensile and compression force on the AFO, and result in breaking or tearing of AFO after several weeks or months usage. Therefore, it is important for therapists to know what geometric modification of AFO can prolong its usage. The purpose of this study was to develop a motion simulator for observing the effect of simulated heel strike impact and foot dorsiflexion on the AFO. The geometry of motion simulator was designed similar to human leg.

足踝副木经常被使用在中风患者下肢以避免走摆荡期发生垂足现象，同时，副木於站期中期后也能提供些许的踝关节背曲角，此一况导致副木遭受循环的张与挤压，常於星期或个月的使用后，导致副木疲断或撕，因此，让治师解副木的几何外型改设计能延长使用时间是很重要的，也因此，本研究目的为设计一评估副木疲破坏的运动模拟器，用以观察副木遭受模拟的脚跟著地冲击与足踝跖曲与背曲弯折对副木的效应。

Drawbench plastic production process, because of plastic material contained in the composition of drawing complex, such as PP + renewable PP; PP + inorganic filler; renewable PP + renewable PE and so on; these materials more or less entrainment of water and impurities will directly affect the silk-smooth surface film formation and the tensile toughness of noodle degrees, resulting in mechanical properties of products and sensory quality by a greater impact, broken wires, the membrane surface uneven, dull and so on.

塑料拉丝制品生产过程中，由于塑料拉丝材料所含的成份复杂，如PP＋再生PP；PP＋无机填料；再生PP＋再生PE等等；这些材料多多少少夹带水份和杂质，将直接影响丝面的光滑平整及膜面的韧性拉伸度，从而导致产品的机械性能和感观质量受到较大影响，断丝、膜面凸凹不平、无光泽等现象。

Like sample of jute fiber reinforced composite, the tensile strength, flexural strength, module and temperature resistance of ramie fiber reinforced polypropylene are improved but its toughness and ductibility decrease.

与黄麻纤维类似，芒麻纤维的加入使聚丙烯的强度、模量和热变形温度提高，但使其韧性和延性降低。

The thickness of the new PS version as 0.3mm, after the PS version of thickness and in some cases not of 0,15 mm, the tensile strength of nature would be no new PS Edition, and the ductibility but newer PS Edition.

陈PS版的厚度为0.3mm，电解后PS版的厚度有时还不到0.15mm，其抗不推不弱度板滞不离操纵陈PS版不弱，而延展性却较陈PS版不弱。

You can do some assertiveness training.

你可以进行一些自信训练。

We were well on the path to making a rear-wheel-drive global platform," says Mays."

我们正致力于建立一个后轮驱动的平台，"Mays这样说道。"