查询词典 tensile

The tensile tests designed by orthogonal test used to test low carbon billet,hot roll armor plate and cold-roll armor plate at room temperature to investigate the influence of tensile rate on mechanical properties have been discussed in this paper.

采用正交试验方法设计拉伸试验方案，对低碳钢坯、低碳热轧及冷轧钢板进行了金属常温拉伸试验，考察试验速率对力学性能的影响。

In order to deeply analyze the distribution of maximum tensile strain during asphalt surface for Semi-rigid base asphalt pavement and compound base asphalt pavement , two types of typical structure were chosen, taking the Shell designing software BISAR 3.0 as calculation tool, considering two kinds interface contact condition of complete continuousness and not incomplete continuousness, then a comprehensive analysis was made on the maximum tensile strain of every structure on the basis different interface contact condition.

摘 要：为深入分析半刚性基层沥青路面和复合式基层沥青路面面层内的最大拉应变的规律，选取两类沥青路面的典型结构，采用壳牌设计软件 BISAR 3.0为计算工具，考虑层间完全连续状态以及不完全连续两种状态，对各结构在不同的层间结合条件下沥青层最大拉应变进行了比较和分析。

With the method of Stress Function,this paper analyzes the distribution of stresses of biaxial tensile and builds the finite element model of biaxial tensile test of cruciform specimens with slots on arms.

用应力函数法分析了双向拉伸的应力分布，建立了臂上开缝十字形试件双向拉伸试验的有限元模型，使用大型通用有限元软件ANSYS8.0对十字形双向拉伸试验进行模拟及分析，并对其结构尺寸进行优化设计。

The tensile and the compressional deformation recovery ratios of high-density polyethylene-natural rubber blending material, the effects of temperature on its tensile deformation recovery ratio and its mechanical properties are studied, and the mechanism of its shape memory is also discussed.

研究了高密度聚乙烯/天然橡胶材料的拉伸与压缩形变回复率、温度对拉伸形变回复率的影响、力学性能，探讨了形状记忆的原理。

Most walls are not normally subject to direct tensile stress and the designer and detailer to avoid such stressing but external walls at the top of a high-rise structure are liable to flexural tensile action due to lateral wind forces.

大多数的墙壁不通常服从的指示张应力和设计者而且细说避免如此的强调，但是由于侧面的风军队，外部的墙壁对弯曲的可拉长的行动在有多层结构的顶端是有义务的。

Crack growth direction of V-notch column sample under tensile-pressural loading was found by means of simulating the crack growth path side by side analyzing the distribution of Von Minses equivalent stress of the V-notch sample, the result shows crack growth direction of the sample under tensile-pressural loading is diametral direction of circle where the V-notch lies.

通过边分析试样的Von Minses等效应力分布，边模拟裂纹扩展方向的方法对拉压载荷下V型切口试样的裂纹扩展方向进行了模拟，结果显示V型切口试样在拉压状态下的裂纹扩展方向为棒料V型切口处圆周的直径方向。

The in-plane equivalent elastic modulus and tensile strength of stitched composite laminates are studied, and its found that the in-plane equivalent elastic modulus decreases with the increase of stitch density, stitch thread diameter, maximal misalignment angle and the distortion width, and the range is about 5%. The tensile strength of stitched composite laminate increases with the increase of stitch step and decreases with the stitch space.

研究结果表明：随着缝纫密度、缝纫线直径、最大纤维偏转角和缝纫变形区宽度的增加，缝纫复合材料层合板面内等效模量逐渐降低，最大降幅一般在5%左右；缝纫复合材料层合板的拉伸强度随缝纫针距的增加而增大，随缝纫行距的增加而降低，因此缝纫密度对拉伸强度的影响程度要看具体的缝纫针距和行距。

Focusing on the doubtable results and abnormal stress-strain curves in the tensile test of high grade line pipe body,the effect on test results of sample preparation process was analyzed,and it is considered that strain aging was the main reason caused pipe body tensile test result abnormal.

针对高钢级输送管管体拉伸性能试验中发现的异常值和异常曲线，分析了试样制备过程对试验结果的影响，认为应变时效是造成管体拉伸试验结果异常的主要原因。

A tensile facture fractal model of grain filled polymer composites on the base of the fractal theory was established,and an equitation of the tensile fracture fractal dimension was proposed.

梁基照，吴成宝，颗粒填充高分子复合材料拉伸断口的分形模型基于分形理论构建了颗粒填充高分子复合材料拉伸断口的分形模型，进而提出了分形维数计算公式。

It was estimated pulp properties with Runkel ratio more than 1 would be harder in tension for fiber and less oriented fiber to make paper into fluffiness (Casey,1980), with flexibility coefficient less than 0.5, the paper had medium tensile strength, burst strength and folding endurance, with slenderness ratio no less than 75 that be the paper of medium tearing strength but suitable beating with per cent of wall fraction less than 40 per cent would be good paper (Rydholm, 1967) while fibers completely oriented to get higher tensile and burst strength.

牙髓腔的财产据估计超过1比率将难以在紧张、纤维少使纸纤维成蓬松型、弹性系数低于0.5，该报中等抗拉强度、爆裂强度和耐折、与细比不少于75文件中被撕裂，但适当强度击打元墙上分数占不到40%将好的文件(rydholm， 1967)而获得较高的完全纤维拉伸强度和爆裂。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。