查询词典 tensile stress

The thermal residual stress is a type of short-rang internal stress between matrix and whisker in composite. It was verified that the thermal residual stress could not be released and could not cause the macro-strain, although the diffraction angle of matrix was shifted in composite.

复合材料中热残余应力是基体与晶须之间的短程内应力，试验证实热残余应力虽可引起基体衍射峰位移动，但不会造成复合材料宏观应变而自然释放。

The max stress and the max radial displacement of conveyor is also proportional to the square of rotational speed. With the decrease of the blade thickness, both the stress and axial displacement of conveyor increase rapidly. The stress and radial displacement will increase with the increment of half cone angle and lead.

螺旋输送器的最大应力强度和最大径向位移均与转速近似地成二次方关系；减小叶片壁厚，沉渣对螺旋叶片作用的正压力所引起的叶片的最大轴向位移增长较快；正常工况下，螺旋输送器的最大应力强度和最大径向位移都随着半锥角和导程的增加而增大。

RESULTS:In vertebral pulp extirpation group, the stress was proved to be the highest at superior edge, posterior middle part, lower edge and anterior middle part of small joints under anteflexion, backward extension, compression, lateroflexion and revolving states, moreover, small joint stress in artificial lumbar intervertebral disk was higher than that in normal intervertebral disk, but obviously lower than that in vertebral pulp extirpation group;however, the small joint of the middle part of artificial lumbar intervertebral disk bore the highest stress under revolving states.

结果：髓核摘除组小关节的上边缘部、后中部、下边缘部和前中部在前屈、后伸、压缩、侧屈、旋转状态应力最大，人工腰椎间盘组的小关节的应力比正常椎间盘高，但明显小于髓核摘除组，但正中部在旋转状态下，人工腰椎间盘小关节的中心部位承受的应力最大。

Analyses Ⅲ crack creep fracture under the influence of the initial co_linear array of microcracks antiplane using macrocrack_microcrack inteaction model and the theory of stress intensity factors for creep fracture,and presents the relation between the concrete antiplane Ⅲ crack stress intensity factors for creep fracture and the initial stress intensity factors was obtained.

依据宏观裂纹—微裂纹相互作用模型和蠕变断裂应力强度因子理论，对具有初始等距共线微裂纹列影响的反平面Ⅲ型裂纹体的蠕变断裂问题进行了分析。

Thischaracteristic of Atriplex canescens is consistent with that of many local species. TheLCP of Atriplex canescens in different treatments (light, medium, no and heavy watersoil stress) are 314.8μmolm~(-2)s~(-1)、272.5μmolm~(-2)s~(-1)、176.7μmolm~(-2)s~(-1)、143.1μmolm~(-2)s~(-1), respectively, which indicates that the LCP of Atriplex canescens is reducingwith the escalation of soil water stress. This tendency is favorable for Atriplexcanescens under drought stress to maintain certain photosynthesis even in weaksunlight so as to ensure the survival of itself, and keep balance between maintainingwater content inside and its photosynthesis.

四翅滨藜在不同土壤水分胁迫下的光补偿点：轻度土壤水分胁迫、中度土壤水分胁迫、无土壤水分胁迫和重度土壤水分胁迫下的光补偿点分别为，314.8μmolm~(-2)s~(-1)、272.5μmolm~(-2)s~(-1)、176.7μmolm~(-2)s~(-1)、143.1μmolm~(-2)s~(-1)，说明四翅滨藜的LCP随着土壤水分胁迫的加重而呈现降低的趋势，这种变化有利于处在干旱胁迫中的四翅滨藜在光强较弱的条件下仍然能维持一定的光合作用，以满足植物自身生命活动所需，同时也可以使植物在保持体内水分和进行光合作用之间寻找平衡。

The results show that the critical stress intensity factor under biaxial stress increases with the increasing of biaxial stress ratio.

研究结果表明，裂纹失稳扩展时的应力强度因子值随着双向应力比的升高而升高。

The results show that the critical stress intensity factor under biaxial stress increases with the increase of biaxial stress ratio.

研究结果表明，裂纹失稳扩展时的应力强度因子值随着双向应力比的升高而升高。

Several studies have identified genes that play important roles in stress tolerance and virulence. For example, genes involved in osmotic stress tolerance, acid and alkaline tolerance, oxidative stress tolerance, extreme temperature tolerance, and bile salt tolerance have all been implicated in the virulence of L.

在压力存在的情况下能启动一些基因的表达，以增强细菌对环境的耐受性，这些基因包括与耐受渗透压、酸碱性环境、氧化、极端温度和宿主体内胆碱等环境压力相关的基因。

Using the finite element method to the industry boiler tube plate carries on the qualitative analysis,and obtains the industry boiler commonly used three kind of types tube plates under the similar size specification and the stress condition distortion and the stress distribution,as well as biggest stress value and position.

通过利用有限元方法对工业锅炉管板进行定性的分析，得出工业锅炉常用两种类型的三种管板在同样尺寸规格和受力条件下的变形和应力分布，以及最大应力数值和位置。

The article finally through analyzing of the Zhejiang YiwuBinwang bridge temperature load, obtained the CFST arch bridge temperature stress rules with the temperature load which is including from top to bottom and from margin to core of arch-rib when the temperature value、 steel pipe wall thickness value and marking value of concrete change. The rule is that the axial force、 bending moment, as well as the shearing force elevates along with the change of temperature increases, so the control section stress which is linear relationship is. The article further proved the change of steel pipe wall thickness and marking value of concrete is not remarkable influence on temperature stress and internal force of arch ribs control section.

文章最后通过对浙江义乌宾王大桥温度荷载分析，得出了在由上至下和由周边向核心呈梯度变化的温度荷载作用下钢管混凝土拱桥结构应力随温度值、钢管壁厚值和混凝土标号值变化时的规律，即：轴力、弯矩以及剪力随着温度变化值增大而增大；钢管混凝土拱桥主拱肋的控制截面应力值亦随之增大，基本呈线性关系；并通过计算论证了拱肋各截面应力、内力值同钢管壁厚的变化、核心混凝土标号变化无关。

Vishnu entered a dark fourth dimensional dream that did not support his field or continued life.

毗瑟挐进入了一个第四密度的黑暗梦想，那里并不支持他的能量场或继续生命。

Leaders and decision-making persons use it to collect the data, including the information of unit work, handing in fee, oweing fee, prepaying fee,changing and afterpaying and account transfering of joining-insurance employee, and account paying of all kinds of insurances from hospitalization insurance institutions.The collected data is picked up, organized, switched and showed to user.

该子系统主要面向各级领导、决策分析人员；从各个医疗保险经办机构和定点医疗机构采集数据，包括在各个医疗保险经办机构处理的单位办公信息，单位缴费、欠费、预缴费信息，参保职工变更信息，参保职工增减变动信息，参保职工补缴信息，参保职工帐户划拨信息：包括各定点医疗机构处理的各险种帐户支出信息，各险种的统筹金支付信息等；将采集的数据提取，组织和转换，然后展示给用户。