查询词典 tensile stress

The spectrum peaks nearby 530nm and 480 nm are corresponding with BTSD and BMD respectively. It is found from measurement that the luminescence peak from BMD is bluely shifted. The atoms of BTSD nearby dislocation core are affected by tensile stress along the Burger's vector direction leading to its band gap narrowed. In addition, there is the effect of part quantity of edge dislocation in BMD existed. Part of atoms in BMD are strained by compressive stress leading to its band gap narrowed, in other words, the wavelength from BMD is shorter than that from BTSD.

从测试结果中还发现BMD 的发光位较BTSD有所蓝移，分析认为BTSD位错芯附近原子沿伯格斯矢量方向只受到拉应力，致使禁带宽度变窄，BMD由于除了具有螺型位错的分量外还具有部分刃型位错的分量，而刃型位错中有部分原子受到压应力的作用，导致禁带宽度增宽，从而使得BMD的发光波长比BTSD短

Regarding the thermobaric explosive further tests, the research showed that the compressive stress was 6.699MPa; The tensile stress was 0.716MPa; Heat sensitivity was 288℃(5s); The anti-overload capacity may withstand 1.0×104g launch overloads and smaller than 2×105g the impact deceleration overload; first decomposition temperature was 251.9 ℃, highest exothermic peak temperature was 286.9 ℃; In the compatibility, except the ceresin and Oxidant, the ceresin and the F rubber, the ceresin and Al compatible rank could reach to second level of compatibility, the others could reach to the first level of compatibility.

对此粘结-钝感体系包覆的温压炸药样品进一步测试研究显示：抗压强度为6.699MPa；抗拉强度为0.716 MPa；热感度为288℃（5s爆发点）；抗过载能力为可承受1.0×104g的发射过载和小于2×105g的撞击减速过载；安定性为分解温度251.9℃，最高放热峰温度286.9℃；内相容性为除蜡类钝感剂+氧化剂，蜡类钝感剂+F橡胶，蜡类钝感剂+Al相容性等级为2级相容性较好外，其他组分间相容性均为1级，相容性很好。

The high temperature field did not make tensile stress and shear stress of upslope pavement increase, but it made the flexure of surface rise.

对京珠高速公路某路段车辙病害展开现场调查，调查发现该路段严重的车辙变形，60%来源于中面层，其余。

The pre-tensile stress in wire layer of new type wire wound super high pressure vessel was analyzed,and yielding stress calculation of the wire layer was been formularized.

对新型绕丝式超高压容器的缠绕钢丝层进行了预应力分析，推导出了钢丝层在预紧状态下的屈服压力计算公式，对进一步探讨和研究超高压容器的性能具有一定参考价值。

In the process of leching , porous clad of phaseglass may has tensile stress or compressile stress because of the diffrent glass compose , phase separate condition and cooling rate .

分相玻璃在浸析过程中由于组成，分相制度，冷却速度的不同，而使多孔玻璃受到拉应力或压应力，通过改善浸析条件可制得具有一定强度，没有裂纹的多孔玻璃。

The results showed that when retrogressed by electrical current heating at 200 ℃ the tensile strength in re-aged 7A04 alloy extrusion bar of 60 mm in diameter reached 620-640 MPa and a uniform elongation appeared from central part to surface layer of the sample while the fracture time in test of resistance to stress corrosion under a load stress of 375MPa in 3%NaCl+0.5%H2O2 corrosion solution was greater than 30 d.

结果表明，直径60 mm的7A04铝合金棒材在200℃电流直接加热回归后再时效，从心部到表层的拉伸强度为620-640 MPa，延伸率均匀一致；在3%NaCl+0.5%H2O2水溶液介质中和375 MPa应力下的应力腐蚀断裂时间大于30d，而辐射式加热回归的为575 MPa，延伸率从心部至表层表现极不均匀，应力腐蚀断裂时间只有19 d。

The results showed that when retrogressed by electrical current heating at 200℃the tensile strength in re-aged 7A04 alloy extrusion bar of 60 mm in diameter reached 620- 640 MPa and a uniform elongation appeared from central part to surface layer of the sample while the fracture time in test of resistance to stress corrosion under a load stress of 375MPa in 3%NaCl+0.5%H_2O_2 corrosion sol...

结果表明，直径60 mm的7A04铝合金棒材在200℃电流直接加热回归后再时效，从心部到表层的拉伸强度为620-640 MPa，延伸率均匀一致；在3%NaCl+0.5%H_2O_2水溶液介质中和375 MPa应力下的应力腐蚀断裂时间大于30 d，而辐射式加热回归的为575 MPa，延伸率从心部至表层表现极不均匀，应力腐蚀断裂时间只有19 d。

Pipe heat causes linesr expansion and rurtherresult in tensile stress in the direction of pipe xale to make cracks in direction perpendicular to the axle,in the case ,the stress value is obtained by ormula=E,and if ,it is estimated with 15mm LG PEX-A Pipe as base,the sectional breaking rorce is estimated approx.7.6kg/cm2,being much more little comparing with the concrete bearing force=1,536kg/cm2and its not needed to be anxious to concrete cracking rising.

由于管子的线性热膨而使管子受轴向伸长力，从人在与管轴成直角的方向上产生裂缝，这时的应力接计算，PEX－A按直径15mm标准计算进断面破坏强度约为7.6kg/cm2，比混凝土的支持力1.58kg/cm2小得多，所以不需要考虑管子对混凝土的破坏作用。

The results of simulations performed at nearly zero temperature demonstrate that stress-induced phase transitions from body-centered cubic to face-centered cubic and hexagonal close-packed structures take place during the deformation process of both Fe and Ta, and the maximum fraction of FCC atoms varies linearly with the tensile strength, from which we can conclude that a critical stress exists for the phase transition to take place.

低温模拟结果表明，纳米晶铁和钽在变形过程中都出现了应力诱导的相变，其中FCC结构含量的最大值和抗拉强度成线性关系，并由此可以推出相变发生的临界应力值。

When the top shape of osteotomes was flat,displacement and tensile stress and compressive stress were the minimum.

本实验采用三维有限元法，通过建立上颌骨三维有限元模型，模拟骨挤压器3种顶端形状，对比探讨不同顶端形状时，骨挤压器-骨组织界面的应力和位移情况。1材料与方法1.1上颌骨三维有限元模型的建立参考张彤等建立上颌骨

Summary In copyright infringement cases,if the alleged infringer uses or even plagiarizes the copyrighted works or parts thereof,which causes no substantially adverse effect on the normal exploitation of the work,nor does it inflict any substantial damages to the right owner,the de minis doctrine should be applied to exempt the liabilities of the defendant and seek the balance of interests between the right owner and the general public embodied by the copyright law.

在侵犯著作权案件中，如果被控侵权行为人虽未经著作权人的同意，使用甚至抄袭了受著作权保护的作品或作品的片段，但若情节轻微，未对该作品的正常使用产生任何实质不利的影响，亦未对权利人的权利造成实质性的损害，则应适用&不计琐细原则&，免除行为人的责任，以寻求在权利人利益与著作权法所体现的社会公共利益之间的平衡。

This new product will become our best seller.

这个新产品会成为我们最畅销的产品。